AIMTEC AM2LW-4805D-NZ

Click on Series name for product info on aimtec.com Series AM2LW-NZ 1.5 Watt | DC-DC Converter FEATURES: • SMD package • Operating temperature: -40°C to +85°C • Ultra Wide (4:1) input range • Regulated single/dual output • 1500VDC isolation • MTBF>1,000,000 hours • Continuous short circuit • RoHS compliant protection Models: Single output Output Voltage Output Current Isolation Efficiency Model Input Voltage(V) (V) max(mA) (VDC) (%) AM2LW-2403S-NZ 9-36 3.3 455 1500 72 AM2LW-2405S-NZ 9-36 5 300 1500 76 AM2LW-2409S-NZ 9-36 9 167 1500 78 AM2LW-2412S-NZ 9-36 12 125 1500 79 AM2LW-2415S-NZ 9-36 15 100 1500 80 AM2LW-4805S-NZ 18-72 5 300 1500 76 Models: Dual output Input Voltage Output Voltage Output Current Isolation Efficiency Model max (mA) (V) (V) (VDC) (%) AM2LW-2405D-NZ 9-36 ±5 ±150 1500 74 AM2LW-2412D-NZ 9-36 ±12 ±63 1500 77 AM2LW-2415D-NZ 9-36 ±15 ±50 1500 75 NOTE 1: Add suffix “TR” to a part number when ordering in tape and reel package NOTE 2: Unless otherwise specified, all specifications in this datasheet are measured at an ambient temperature of 25°C, humidity<75%, nominal input voltage and at rated output load. Input Specifications Parameters Nominal Typical Maximum Units 24 9-36 Voltage range VDC 48 18-72 24 40 Absolute Maximum Rating VDC 48 80 Peak Input Voltage time 100 ms Isolation Specifications Parameters Conditions Typical Rated Units Tested I/O voltage 60 sec 1500 VDC Resistance At 500 Vdc 1000 MOhm Capacitance Input to Output 1000 pF Output Specifications Parameters Conditions Typical Maximum Units Voltage accuracy ±5 % Short Circuit protection Continuous Short circuit restart Auto-Recovery Line voltage regulation From Low in to High In ±0.75 % Load voltage regulation (Single) From 10% to 100% load ±1.5 % From 10% to 100% load Load voltage regulation (Dual) ±5 % Unbalanced load o Temperature coefficient ±0.03 %/ C Ripple & Noise 20MHz Bandwidth 100 mV p-p Minimum Load Current* 10 % of Max * Operation under 10% load will not damage the converter; however, not all specifications will be met. www.aimtec.com Tel: +1 514 620 2722 Toll free: + 1 888 9 AIMTEC (924 6832) F 051e R8.G 1 of 3 North America only Series AM2LW-NZ 1.5 Watt | DC-DC Converter General Specifications Parameters Conditions Typical Maximum Units Switching frequency 100% load 550 KHz o Operating temperature -40 to +85 C o Storage temperature -55 to +125 C o Maximum case temperature 100 C o Derating Above 71º 2.9 %/ C Cooling Free Air Convection Humidity 95 % RH Case material Plastic (UL94-V0) Weight 5.2 g Dimensions (L x W x H) 0.94 x 0.54 x 0.32 inches 23.86 x 13.70 x 8.00mm MTBF >1,000,000 hours(MIL-HDBK -217F, Ground Benign, t=+25ºC) o Maximum Soldering Temperature 1.5mm from case for 10 seconds 300 C . Pin Out Specifications Pin Single Dual 1 - Vin - Vin 7 NC NC 8 NC Common 9 +Vout +Vout 10 - Vout -Vout 16 + Vin + Vin NC – not connected Dimensions Front View Side View 23.86 15.00 (0.94) (0.59) A A 7.50 8.20 0.50 (0.30) (0.32) (0.02) 0.50 (0.02) 5.00º angle 13.10 (0.52) 1.36 17.50 (0.05) MAX Top View (0.69) 23.86 (0.94) 0.80 (0.03) Footprint 1.02 0.50 (0.04) (0.02) 16 10 9 13.70 18.50 (0.54) (0.73) 1 8 7 0.20 (0.08) 15.24 3.04 15.24 2.54 2.54 (0.60) (0.12) (0.60) (0.10) (0.10) www.aimtec.com Tel: +1 514 620 2722 Toll free: + 1 888 9 AIMTEC (924 6832) F 051e R8.G 2 of 3 North America only Series AM2LW-NZ 1.5 Watt | DC-DC Converter Recommended Filter Circuit Single Output Dual Output +Vout + Vin +Vout + Vin Cout + Cin + + Cout Cin + Common DC DC DC DC + Cout - Vout -Vout - Vin - Vin All the AM2LW-Z Series have been tested with the above recommended test circuit. This series should be tested under load. If it is necessary to further decrease the input/output ripple, the value of the filter capacitor can be increased; a capacitor with a low ESR should be used. Excessive filter capacitance can cause start up problems with the converter. In general, the recommended capacitance values are: Cin: 10μF~47μF Cout: 10μF/100mA Refer to table below for maximum capacitor values: External Capacitor Value Single Output Dual Output Cout (uF) Cout (uF) Vout (VDC) Vout (VDC) 5 1000 ±5 ±680 12 470 ±12 ±330 15 330 ±15 ±220 Derating Free Air Convection º 71 C 100 80 Safe Operating Area 60 40 20 0 85 - 20 100 - 40 0 20 40 60 80 Ambient Temperature º C NOTE: 1. Datasheets are updated as needed and as such, specifications are subject to change without notice. Once printed or downloaded, datasheets are no longer controlled by Aimtec; refer to www.aimtec.com for the most current product specifications. 2. Product labels shown, including safety agency certifications on labels, may vary based on the date manufactured. 3.Mechanical drawings and specifications are for reference only. 4.All specifications are measured at an ambient temperature of 25°C, humidity<75%, nominal input voltage and at rated output load unless otherwise specified. 5.Aimtec may not have conducted destructive testing or chemical analysis on all internal components and chemicals at the time of publishing this document. CAS numbers and other limited information are considered proprietary and may not be available for release. 6. This product is not designed for use in critical life support systems, equipment used in hazardous environments, nuclear control systems or other such applications which necessitate specific safety and regulatory standards other the ones listed in this datasheet. 7. Warranty is in accordance with Aimtec’s standard Terms of Sale available at www.aimtec.com. www.aimtec.com Tel: +1 514 620 2722 Toll free: + 1 888 9 AIMTEC (924 6832) F 051e R8.G 3 of 3 North America only Output Power (%)