Click on Series name for product info on aimtec.com Series AMEPR5-AZ up to 1A | AC-DC / DC-DC LED driver FEATURES:  AC-DC or DC-DC Constant current LED Driver  SCP, Over Voltage Protection  Input range 90-264VAC/47-440Hz  Waterproof Case rated IP67  Operating temperature 0 to 80°C  No load consumption <0.3W  High Efficiency up to 79%  5 Years Limited Warranty Models Single output Max Efficiency Output Output Output (%) Input Voltage Input Voltage Model Voltage Current Power (VAC/Hz) (VDC) Range (V) (A) 115 230 ① VAC VAC (W) AMEPR5-1630AZ 4.8 8-16 0.3 90-264/47-440 130-370 79 75 AMEPR5-1435AZ 4.9 6-14 0.35 90-264/47-440 130-370 77 74 AMEPR5-1236AZ 4.32 5-12 0.36 90-264/47-440 130-370 77 74 AMEPR5-0670AZ 4.2 2-6 0.7 90-264/47-440 130-370 76 73 AMEPR5-05100AZ 5 3-5 1 90-264/47-440 130-370 74 72 ① Exceeding the maximum output power will permanently damage the converter NOTE: Aimtec limited warranty of 5 years is valid based on product operation at datasheet specifications at ambient temperature of 25°C, humidity<75%, nominal input voltage (115/230VAC) and at rated output load unless otherwise specified. See http://www.aimtec.com/terms- sale AMEPR5-AZ’s AC/DC LED drivers have electrical safeguards designed within to protect it from conventional electrical abnormalities with the levels listed in the safety table. Applications for use within rural agricultural, heavy industrial, and other areas or regions which are prone to ‘dirty’ electrical conditions which would subject any of the above models to excessive voltages surges or spikes, may damage or cause early life failure of product. In this case consideration should be made by the end user to ensure that adequate line or mains surge suppression is installed in front of Aimtec device to ensure the longevity of the products. Failure to identify excessive line surges violations prior to installation may damage sensitive equipment permanently. Input Specifications Parameters Conditions Typical Maximum Units 115VAC 15 Inrush current <2ms A 230VAC 30 115VAC 0.2 Leakage current mA 230VAC 0.25 115VAC 0.09 AC current A 230VAC 0.06 115VAC 0.1 No load consumption W 230VAC 0.2 External fuse 250V/0.5A Start up time 140 ms Output Specifications Parameters Conditions Typical Maximum Units Current accuracy ±10 % Line regulation LL-HL ±5 % Load regulation 0-100% load ±10 % 6/12/14/16V models 100 ② Ripple & Noise mV p-p 5V model 150 Hold-up time 2 ms Minimum Load Voltage See the models table ② Ripple and Noise are measured at 20MHz bandwidth by using a 0.1μF (M/C) or (C/C) and 220µF (E/C) parallel capacitor. www.aimtec.com Tel: +1 514 620 2722 Toll free: + 1 888 9 AIMTEC (924 6832) F 052.1e R3.L 1 of 3 North America only Series AMEPR5-AZ up to 1A | AC-DC / DC-DC LED driver Isolation Specifications Parameters Conditions Typical Maximum Units Tested I/O voltage 3sec 3000 VAC Isolation Resistance >1000 MΩ General Specifications Parameters Conditions Typical Maximum Units Switching frequency 65 KHz Over Load protection �103 % Over voltage protection ≥103 % Short circuit protection Auto recovery o Operating temperature With derating over 50°C 0 to +80 C o Maximum case temperature 100 C o Storage temperature -40 to +95 C o Temperature coefficient ±0.02 % / C Cooling Free air convection Humidity 95 % RH Case material Plastic Potting Epoxy (IP67 rated) Wires UL1015 22AWG * 10CM Weight 25 g Dimensions (L X Diameter) 29 x 26.5 mm (1.14x1.04 inch) MTBF >400,000 hrs (MIL-HDBK-217F at +25°C) Environment Approval Test Parameters Conditions Wave form Half sine wave Acceleration amplitude 5gn Shock Bump duration 30ms Converter operation Before and after test, body mounted (on chassis) Number of bumps 18 (3 in each direction for every axis) Test mode Sweep sine, 10-100Hz, speed 0.05Hz/s Displacement 1 mm Vibration Acceleration 3g, 3 loops 30min one cycle, 3h total, every axis tested Converter operation Before and after test, body mounted (on chassis) Safety Specifications Parameters Agency approvals cULus, CE, FCC EN61347-1, EN61347-2-13, IEC62384, UL8750, UL60950-1, EN55015, EN55024, FCC part 15 Subpart B, Class B, ANSI C63.4 :2003 Harmonic Current Emissions IEC/EN 61000-3-2, (EN60555-2) Voltage fluctuations and flicker IEC/EN 61000-3-3, (EN60555-3) Electrostatic Discharge Immunity IEC 61000-4-2 Level 3 Standards RF, Electromagnetic Field Immunity IEC 61000-4-3 Level 2 Electrical Fast Transient/Burst Immunity IEC 61000-4-4 Level 2 Surge Immunity IEC 61000-4-5 Level 1 RF, Conducted Disturbance Immunity IEC 61000-4-6 Level 2 Power frequency Magnetic Field Immunity IEC 61000-4-8 Level 2 Voltage dips, Short Interruptions Immunity IEC 61000-4-11 www.aimtec.com Tel: +1 514 620 2722 Toll free: + 1 888 9 AIMTEC (924 6832) F 052.1e R3.L 2 of 3 North America only Series AMEPR5-AZ up to 1A | AC-DC / DC-DC LED driver Dimensions Temperature Graph Free Air Convection º C 50 100 80 60 Safe Operating Area 40 20 0 -20 020 40 60 80 100 Ambient Temperature º C NOTE: 1. Datasheets are updated as needed and as such, specifications are subject to change without notice. Once printed or downloaded, datasheets are no longer controlled by Aimtec; refer to www.aimtec.com for the most current product specifications. 2. Product labels shown, including safety agency certifications on labels, may vary based on the date manufactured. 3. Mechanical drawings and specifications are for reference only. 4. All specifications are measured at an ambient temperature of 25°C, humidity<75%, nominal input voltage and at rated output load unless otherwise specified.5..Aimtec may not have conducted destructive testing or chemical analysis on all internal components and chemicals at the time of publishing this document. CAS numbers and other limited information are considered proprietary and may not be available for release. 5. This product is not designed for use in critical life support systems, equipment used in hazardous environments, nuclear control systems or other such applications which necessitate specific safety and regulatory standards other the ones listed in this datasheet. www.aimtec.com Tel: +1 514 620 2722 Toll free: + 1 888 9 AIMTEC (924 6832) F 052.1e R3.L 3 of 3 North America only Output Power %