ARTESYN SIL15E-05W3V3-VJ

process yellow 116 1375 1797 375 3405 313 2985 240 Embedded Power for Business-Critical Continuity 242 2607 Rev.12.11.08_97 SIL15E Series 1 of 5 652 SIL15E Series 3.0 Vin to 5.5 Vin Single Output Total Power: 54.5W Input Voltage: 5.5VDC # of Outputs: Single Electrical Specifications Special Features Output • 15 A current rating • Input voltage range: Voltage adjustability: ± 10.0% Fixed output version 3.0 Vdc to 5.5 Vdc 0.8-3.63 Vdc Wide trim version • Output voltage range: Setpoint accuracy ± 0.4% 0.8 Vdc to 3.63 Vdc • Ultra high efficiency: 95% @ Line regulation: ± 0.2% 5 Vin and 3.3 Vout Load regulation: ± 1.0% • Extremely low internal power Minimum load: 0 A dissipation • Minimal thermal design Overshoot/undershoot: None concerns Ripple and noise: 60 mV pk-pk • Designed in reliability: 25 mV rms max. (0-20 MHz BW) MTBF of >7 million hours per Temperature coefficient: ± 0.01%/ °C Telcordia SR-332 • Ideal solution where board Transient response: 60 mV max. deviation space is at a premium or tighter 50 µs recovery to within ± 1.0% card pitch is required Short circuit protection: Continuous • Industry standard footprint and Thermal protection: Automatic recovery pin out • Available RoHS compliant Input • 2 year warranty Input voltage range: 3.0-5.5 Vdc Input current: 70 mA typ. No load Input current (max): 11.8 A max. @ lo max. and Vout = 3.63 V Input current ripple: 110 mA rms Safety Remote ON/OFF: (See Note 2) • UL/cUL : CAN/CSA 22.2 Start-up time: 20 ms No. E174104 • UL 60950 File No. E174104 • TÜV Product Service (EN60950) Certificate No. B 03 10 38572 • CB report and certificate to DE3-51686M1 process yellow 116 1375 1797 375 3405 313 2985 240 242 Embedded Power for Business-Critical Continuity 2607 Rev.12.11.08_97 SIL15E Series 2 of 5 652 Specifications All specifications are typical at nominal input, full load at 25 °C unless otherwise stated. EMC Characteristics Electrostatic discharge: EN61000-4-2, IEC801-2 Conducted immunity: EN61000-4-6 Radiated immunity: EN61000-4-3 General Specifications Efficiency: See table Insultation voltage: Non-isolated Switching frequency: Fixed 300 kHz typ. Approvals and standards: EN60950 (see note 13) UL/cUL60950 Material flammability: UL94V-0 Dimensions: (LxWxH) 50.8 x 7.8 x 12.7mm 2.0 x 0.31 x 0.5 inches Pin length: 0.135 ± 0.02 in (3.43 ± 0.5 mm) Weight: 5 g (0.18 oz) MTBF (see note 9): Telecordia SR-332 7,042,000 hours MIL-HDBK-217F 680,000 hours Environmental Specifications Thermal performance: Operating ambient -40° C to +100 °C (See Note 3) Non-operating -40 °C to +1255 °C process yellow 116 1375 1797 375 3405 313 2985 240 242 Embedded Power for Business-Critical Continuity 2607 Rev.12.11.08_97 SIL15E Series 3 of 5 652 Ordering Information (2, 5, 6, 7) Output Power Input Output Output Currents Efficiency Regulation Model Numbers (Max.) Voltage Voltage (Typ.) Min Max Line Load 29.7 W 3.0 - 5.5 Vdc 1.8 V 0 A 15 A 89% ±0.2% ±1.0% SIL15E-05S1V8-VJ (EOL) 41.2 W 3.0 - 5.5 Vdc 2.5 V 0 A 15 A 92% ±0.2% ±1.0% SIL15E-05S2V5-VJ (EOL) 54.5 W 4.5 - 5.5 Vdc 3.3 V 0 A 15 A 94% ±0.2% ±1.0% SIL15E-05S3V3-VJ (EOL) (4) 54.5 W 3.0 - 5.5 Vdc 0.8 - 3.63 Vdc 0 A 15 A 94% ±0.2% ±1.0% SIL15E-05W3V3-VJ Part Number System with Options SIL15E-05S3V3-VJ (6) Product Family Packaging Options SIL = Single In Line J = Pb-free (RoHS 6/6 compliant) Rated Output Current Mounting Option 15 = 15 Amps V = Vertical (5) H = Horizontal Performance Output Voltage E = Enhanced Performace 2.5 V, 3.3 V etc Type of Output S = Single W = Wide Input Voltage 05 = 3.0 Vdc to 5.5 Vdc Output Voltage Adjustment Output Voltage Adjustment of the SIL10-05Wxxx of the SIL15E-05W3V3 Series Series The ultra-wide output voltage trim range offers major advantages to users who select the SIL15E-05W3V3. It is no longer necessary to purchase a variety of modules in order to cover different output voltages. The output voltage can be trimmed in a range of 0.8 Vdc to 3.63 Vdc. When the SIL15E-05W3V3 converter leaves the factory the output has been adjusted to the default voltage of 3.3 V. • When Vin ≥ 4.5 V, then Vout can be adjusted from 0.8 Vdc to 3.63 Vdc • When Vin < 4.5 V, then Vout can be adjusted from 0.8 Vdc to 2.75 Vdc Notes 1 When Vin ≥ 4.5 V, then Vout can be adjusted from 0.8 Vdc to 3.63 Vdc. When Vin < 4.5 V, then Vout can be adjusted from 0.8 Vdc to 2.75 Vdc. 2 The SIL15E 5 V features a ‘Negative Logic’ Remote ON/OFF operation. If not using the Remote ON/OFF pin, leave the pin open (the converter will be on). The Remote ON/OFF pin is referenced to ground. The following conditions apply for the SIL15E: Configuration Converter Operation Remote pin open circuit Unit is ON Remote pin pulled low Unit is ON Remote pin pulled high [Von/off >1.2 V] Unit is OFF A ‘Positive Logic’ Remote ON/OFF version is also possible with this converter. To order please place the suffix ‘R’ towards the end of the model number, e.g. SIL15E-05W3V3-VRJ. 3 Full derating curves available in both the Longform Datasheet and Application Note 134. 4 When the unit is trimmed down to 0.8 V, the efficiency is 82%. 5 For horizontal mounting option please consult factory for details. 6 TSE RoHS 5/6 (non Pb-free) compliant versions may be available on special request, please contact your local sales representative for details. 7 NOTICE: Some models do not support all options. Please contact your local Emerson Network Power representative or use the on-line model number search tool at http://www.powerconversion.com to find a suitable alternative. process yellow 116 1375 1797 375 3405 313 2985 240 Embedded Power for Business-Critical Continuity 242 2607 Rev.12.11.08_97 SIL15E Series 4 of 5 652 Americas 5810 Van Allen Way Carlsbad, CA 92008 USA Telephone: +1 760 930 4600 SIDE VIEW FRONT VIEW Facsimile: +1 760 930 0698 0.307 0.008 2.000 0.020 (50.80 0.50) (7.80 0.20) Europe (UK) 0.500 (12.70) Waterfront Business Park PCB Merry Hill, Dudley West Midlands, DY5 1LX United Kingdom Telephone: +44 (0) 1384 842 211 0.135 (3.43) Facsimile: +44 (0) 1384 843 355 0.635 (16.13) Asia (HK) 1 15 2 3 4 2 3 56 0.025 0.001 14/F, Lu Plaza J2 (0.64 0.02) 2 Wing Yip Street 0.168 (4.26) J1 Kwun Tong, Kowloon 0.100 (2.54) Hong Kong Telephone: +852 2176 3333 0.050 (1.27) 1.900 (48.26) Facsimile: +852 2176 3888 For global contact, visit: Dimensions in Inches (mm) Tolerances (unless otherwise specified) www.powerconversion.com 2 Place 0.15 3 Place 0.006 techsupport.embeddedpower @emerson.com While every precaution has been taken to ensure accuracy and completeness in this literature, Emerson Pin Connections Network Power assumes no responsibility, and disclaims all liability for damages resulting from use of this J1 information or for any errors or omissions. Pin 1 + Vout Pin 2 + Vout Emerson Network Power. The global leader in enabling Pin 3 Remote Sense (+) business-critical continuity. Pin 4 + Vout AC Power Pin 5 Ground Connectivity J2 DC Power Pin 1 Ground Embedded Computing Pin 2 + Vin Embedded Power Pin 3 + Vin Monitoring Pin 4 No Pin Outside Plant Pin 5 Trim Power Switching & Controls Pin 6 Remote ON/OFF Precision Cooling Racks & Integrated Cabinets Services Surge Protection EmersonNetworkPower.com Emerson Network Power and the Emerson Network Power logo are trademarks and service marks of Emerson Electric Co. ©2008 Emerson Electric Co.