Panel Mount DataSheet 3RHP Series DC Control • 100K-cycle UL508 Endurance Rating for Enhanced Reliability • 40 and 50A output • Voltage ratings to 240 VAC • Lifetime 2 million operations at full load • LED input status indicator • Wire, lug or quick connect termination • Industry Standard DP contactor mounting PRODUCT SELECTION (by control voltage and output rating) Control Voltage 40A 120 VAC 50A 120 VAC 40A 240 VAC 50A 240 VAC 3RHP2440D5 4.5-5.5 VDC 3RHP1240D5 3RHP1250D5 3RHP2450D5 10-15 VDC 3RHP1240D12 3RHP2440D12 3RHP2450D12 3RHP1250D12 22-27 VDC 3RHP1240D24 3RHP1250D24 3RHP2440D24 3RHP2450D24 OUTPUT SPECIFICATIONS (voltage) Description 120 VAC 240 VAC 100-120 Operating Voltage (47-63Hz) [Vrms] 208-240 Maximum Off-State Leakage Current per channel 0.05 mA @ 120 VAC 0.06 mA @ 240 VAC OUTPUT SPECIFICATIONS (current) Description 40 A 50 A Maximum Load Current per phase @ 40°C [Arms] (1) 50A Resistive 40A Resistive Power terminals 1/4" Quick Connect and 10x32 binder 1/4" Quick Connect and box lugs head screws Wire Size 8-14 AWG 6-14 AWG INPUT SPECIFICATIONS Description SUFIX D5 SUFIX D24 SUFIX D12 Coil Voltage 4.5-5.5 VDC 10-15 VDC 22-27 VDC Max. Reverse Voltage -5.5 VDC -15.5 VDC -27.5 VDC Input Current 12mA @ 5 VDC 12mA @ 12 VDC 12mA @ 24 VDC Min. Turn-On Voltage 4.5 VDC 9.5 VDC 9.5 VDC Min. Turn-Off Voltage 1 VDC 2 VDC 2 VDC GENERAL SPECIFICATIONS Description Parameters Dielectric Strength, Input to Output 4000 Vrms Dielectric Strength, Input/Output to ground 2500 Vrms Contacts (2) Three Normally Open Ambient Operating Temperature Range (3) -20 to 65 °C Ambient Storage Temperature Range -40 to 100 °C Max. Turn-On Time 50/60 Hz 20 ms / 16.6 ms Max. Turn-On Time 50/60 Hz 40 ms / 32 ms Maximum Number of Operations 30 per Minute >2 Million Lifetime Number of Operations @ Rated Current (4) Weight (typical) 1.19 lbs (540 g) Screw Torque (input/Output) 40A 4.4-5 in lb (0.5-0.6 Nm) / 15-18 in lb (1.7-2.1 Nm) 4.4-5 in lb (0.5-0.6 Nm) / 20-25 in lb (2.2-2.9 Nm) Screw Torque (input/Output) 50A Do not forget to visit us at: www.crydom.com Copyright © 2017 Crydom Inc. Specifications subject to change without notice. Obsolete Panel Mount DataSheet GENERAL NOTES (1) See Derating curves for additional operating conditions. (2) The RHP includes a Solid State Relay, therefore electrical isolation is not provided. (3) The RHP includes over temperature protection for the solid state relay (4) 40°C ambient temperature, 30 operations/min, maximum voltage control. MECHANICAL SPECIFICATIONS Tolerances: ±0.02 in / 0.5 mm All dimensions are in: inches [millimeters] AC Line/Load Terminals #10-32 screw or .25in x .032in Dual Fast-On (Box lugs available on 50 Amps version only) Input/Control Terminals #8-32 screw or .25in x .032in Fast-On MECHANICAL SPECIFICATIONS 3RHPXX50XX 3RHPXX40XX 55 45 50 40 45 Power lead size Power lead size 35 40 AWG # 6 AWG # 6 AWG # 8 AWG # 8 35 30 Safe Operating Area 30 Safe Operating Area 25 25 20 20 25 35 45 55 65 75 25 35 45 55 65 75 Ambient Temperature (ºC) Ambient Temperature (ºC) Do not forget to visit us at: www.crydom.com Copyright © 2017 Crydom Inc. Specifications subject to change without notice. Obsolete Load Current (Amps) Load Current (Amps) Panel Mount DataSheet TYPICAL ELECTRICAL CONNECTIONS AGENCY APPROVALS AGENCY APPROVALS UL/cUL UL5 E08, 116950 EN60950-1-2006 Rev. 073011 Do not forget to visit us at: www.crydom.com Copyright © 2017 Crydom Inc. Specifications subject to change without notice. Obsolete Panel Mount DataSheet ACCESSORIES Do not forget to visit us at: www.crydom.com Copyright © 2017 Crydom Inc. Specifications subject to change without notice. Obsolete Panel Mount DataSheet DANGER / PELIGRO / DANGER /GEFAHR / PERICOLO / 危险 HAZARD OF RIESGO DE RISQUE DE GEFAHR EINES RISCHIO DI 存在电击、 ELECTRIC DESCARGA DESCHARGE ELEKTRISCHE SCOSSA 爆炸或电弧 SHOCK, ELECTRICA O ELECTRIQUE N SCHLAGES ELETTRICA O 闪烁危险 EXPLOSION, EXPLOSION. OU EXPLOSION ODER EINER DELL’ESPLOSIONE. OR ARC FLASH. EXPLOSION. • 在操作此设 • Desconectar • Eteindre • Spenga tutta • Disconnect all • Stellen Sie todos los toutes les l'alimentazione 备之前请先 power before jeglichen suministros de sources che fornisce 关闭电源。 installing or Strom ab, der d'énergie de questa energia a este working with dieses Gerät cet appareil apparecchiatura equipo antes 若不遵守这些说明， this equipment. versorgt, bevor avant de de trabajar prima di lavorare Sie an dem 可能会导致严重的 travailler con este equipo. a questa • Verify all Gerät Arbeiten 人身伤害甚至死亡。 dessus de cet apparecchiatura connections • Verificar todas durchführen appareil and replace all las conexiones • Verificare tutti • Vor dem covers before y colocar todas • Vérifier tous i collegamenti Drehen auf turning on las tapas antes connections, et e sostituire Energie alle power. de energizer remettre tous tutte le coperture Anschlüsse el equipo. couverts en prima überprüfen Failure to follow dell’accensione olace avant de und alle these El mettre sous Abdeckungen instructions will L'omissione di incumplimiento ersetzen. result in death De non-suivi de queste istruzioni de estas or serious injury. ces instructions Unterlassung provocherà la instrucciones provoquera la dieser morte o puede provocar mort ou des Anweisungen lesioni serie la muerte o lésions sérieuses können zum lesiones serias. sérieuses. Tode oder zu schweren Verletzungen führen. WARNING / AVERTISSEMENT / WARNUNG /ADVERTENCIA / AVVERTENZA / 警告 RISQUE DE DOMMAGE MATERIEL ET DE GEFAHR VON MATERIALSCHÄDEN UND RISK OF MATERIAL DAMAGE AND HOT SURCHAUFFE DU BOITIER GEHÄUSEERHITZUNG ENCLOSURE • Les panneaux latéraux du produit peuvent être • Die Seitenwände können heiß sein. Lassen Sie • The product's side panels may be hot, allow chauds. Laisser le produit refroidir avant de le das Produkt abkühlen, bevor Sie es berühren. the product to cool before touching. toucher. • Beachten Sie die Montageanweisungen, • Follow proper mounting instructions including • Respecter les consignes de montage, et • Führen Sie keine Flüssigkeiten oder torque values. notamment les couples de serrage. Fremdkörper in das Produkt ein. • Do not allow liquids or foreign objects to enter • Ne pas laisser pénétrer de liquide ni de corps this product. étrangers à l'intérieur du produit. Le non-respect de cette directive peut entraîner, Die Nichtbeachtung dieser Anweisung kann Failure to follow these instructions can result in des lésions corporelles graves ou des Körperverletzung oder Materialschäden serious injury, or equipment damage. dommages matériels. zur Folge haben. RIESGO DE DAÑOS MATERIALES Y DE 材料损坏和高温外壳的危险性 RISCHIO DI DANNI MATERIALI E D'INVOLUCRO SOBRECALENTAMIENTO DE LA UNIDAD CALDO • 产品的一侧面板可能很热，在其冷却前请 • Los paneles laterales del producto pueden • I pannelli laterali dell'apparecchio possono 不要触碰。 estar calientes. Esperar que el producto se scottare; lasciar quindi raffreddare il prodotto • 遵照正确的安装说明，包括扭矩值。 enfríe antes de tocarlo. prima di toccarlo. • 请勿让液体及其他异物进入本产品。 • Respetar las instrucciones de montaje, y en • Seguire le istruzioni di montaggio corrette. particular los pares de apretado. • Non far entrare liquidi o oggetti estranei in questo • No dejar que penetren líquidos o cuerpos apparecchio. extraños en el producto. La mancata osservanza di questa precauzione può 如不能正确执行这些操作说明， Si no se respetan estas precauciones pueden causare gravi rischi per l'incolumità personale o 极有可能造成严重人体伤害或者设备的损坏。 producirse graves lesiones, daños materiales. danni alle apparecchiature. Do not forget to visit us at: www.crydom.com Copyright © 2017 Crydom Inc. Specifications subject to change without notice. Obsolete Panel Mount DataSheet ANNEX - ENVIROMENTAL INFORMATION The environmental information disclosed in this annex including the EIP Pollution logo are in compliance with People’s Republic of China Electronic Industry Standard SJ/T11364 – 2006, Marking for Control of Pollution Caused by Electronic Information Products. Part Toxic or hazardous Substance and Elements Name Lead Mercury Cadmium Hexavalent Polybrominated Polybrominated Chromium biphenyls diphenyl ethers (Pb) (Hg) (Cd) (Cr (VI)) (PBB) (PBDE) Semiconductor die Solder 附件 - 环保信息 此附件所标示的包括电子信息产品污染图标的环保信息符合中华人民共和国电子行业标准 SJ/T11364 - 2006, 电子信息产品污染控制标识要求。 部件 有毒有害物质或元素 名称 铅 汞 镉 六价铬 多溴联苯 多溴二苯醚 (Pb) (Hg) (Cd) (Cr (VI)) (PBB) (PBDE) 半导体芯片 焊接点 50 Do not forget to visit us at: www.crydom.com Copyright © 2017 Crydom Inc. Specifications subject to change without notice. Obsolete