SUBMINIATURE SOLID STATE LAMP AM27SYC03 SUPER BRIGHT YELLOW Features Description
SUBMINIATURE PACKAGE. The Super Bright Yellow device is made with DH InGaAlP
GULL WING. (on GaAs substrate) light emitting diode chip.
LONG LIFE - SOLID STATE RELIABILITY.
LOW PACKAGE PROFILE.
PACKAGE :1000PCS / REEL.
RoHS COMPLIANT. Package Dimensions Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is ±0.25(0.01") unless otherwise noted. 3. Lead spacing is measured where the leads emerge from the package. 4. Specifications are subject to change without notice. SPEC NO: DSAD1302 REV NO: V.3 DATE: APR/07/2005 PAGE: 1 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN:H.Q.YUAN ERP:1202000407 Selection Guide Iv (mcd) V i e w i n g @ 20mA Angle Part No. Dice Lens Type Min. Typ. 2 θ θ θ θ 1/2 AM27SYC03 SUPER BRIGHT YELLOW (InGaAlP) WATER CLEAR 110 700 20° Note: 1. θ1/2 is the angle from optical centerline where the luminous intensity is 1/2 the optical centerline value. Electrical / Optical Characteristics at TA=25°C Symbol Parameter Device Typ. Max. Units Test Conditions λpeak Peak Wavelength Super Bright Yellow 590 nm IF=20mA λD Dominant Wavelength Super Bright Yellow 588 nm IF=20mA Δλ1/2 Spectral Line Half-width Super Bright Yellow 28 nm IF=20mA C Capacitance Super Bright Yellow 25 pF VF=0V;f=1MHz VF Forward Voltage Super Bright Yellow 2.0 2.5 V IF=20mA IR Reverse Current Super Bright Yellow 10 uA VR = 5V Absolute Maximum Ratings at TA=25°C Parameter Super Bright Yellow Units Power dissipation 125 mW DC Forward Current 30 mA Peak Forward Current [1] 150 mA Reverse Voltage 5 V Operating/Storage Temperature -40°C To +85°C Note: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. SPEC NO: DSAD1302 REV NO: V.3 DATE: APR/07/2005 PAGE: 2 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN:H.Q.YUAN ERP:1202000407 Super Bright Yellow AM27SYC03 SPEC NO: DSAD1302 REV NO: V.3 DATE: APR/07/2005 PAGE: 3 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN:H.Q.YUAN ERP:1202000407 AM27SYC03 Recommended Soldering Pattern (Units : mm) Tape Specifications (Units : mm) Remarks: If special sorting is required (e.g. binning based on forward voltage, luminous intensity, or wavelength), the typical accuracy of the sorting process is as follows: 1. Wavelength: +/-1nm 2. Luminous Intensity: +/-15% 3. Forward Voltage: +/-0.1V Note: Accuracy may depend on the sorting parameters. SPEC NO: DSAD1302 REV NO: V.3 DATE: APR/07/2005 PAGE: 4 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN:H.Q.YUAN ERP:1202000407