KINGBRIGHT WP117GYWT

2mm x 5mm BI-COLOR RECTANGULAR LED LAMP Part Number: WP117GYWT Green Yellow Features Descriptions z Uniform light output. z The Green source color devices are made with Gallium z Suitable for level indicator. Phosphide Green Light Emitting Diode. z Low power consumption. z The Yellow source color devices are made with Gallium z Long life - solid state reliability. Arsenide Phosphide on Gallium Phosphide Yellow Light z RoHS compliant. Emitting Diode. Package Dimensions Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is ±0.25(0.01") unless otherwise noted. 3. Lead spacing is measured where the lead emerge from the package. 4. The specifications, characteristics and technical data described in the datasheet are subject to change without prior notice. SPEC NO: DSAF2685 REV NO: V.5B DATE: JAN/21/2015 PAGE: 1 OF 7 APPROVED: WYNEC CHECKED: Allen Liu DRAWN: L.Q.Xie ERP: 1101000881 Selection Guide Iv (mcd) [2] Viewing @ 20mA Angle [1] Part No. Dice Lens Type Min. Typ. 2θ1/2 Green (GaP) 2 6 WP117GYWT White Diffused 110° Yellow (GaAsP/GaP) 2 4 Notes: 1. θ1/2 is the angle from optical centerline where the luminous intensity is 1/2 of the optical peak value. 2. Luminous intensity/ luminous Flux: +/-15%. 3. Luminous intensity value is traceable to the CIE127-2007 compliant national standards. Electrical / Optical Characteristics at TA=25°C Symbol Parameter Device Typ. Max. Units Test Conditions Green 565 λpeak Peak Wavelength nm IF=20mA Yellow 590 Green 568 λD [1] Dominant Wavelength nm IF=20mA Yellow 588 Green 30 Δλ1/2 Spectral Line Half-width nm IF=20mA Yellow 35 Green 15 C Capacitance pF VF=0V;f=1MHz Yellow 20 Green 2.2 2.5 VF [2] Forward Voltage F=20mA V I Yellow 2.1 2.5 Notes: 1.Wavelength: +/-1nm. 2.Forward Voltage: +/-0.1V. 3.Wavelength value is traceable to the CIE127-2007 compliant national standards. 4.Excess driving current and/or operating temperature higher than recommended conditions may result in severe light degradation or premature failure. Absolute Maximum Ratings at TA=25°C Parameter Green Yellow Units Power dissipation 62.5 75 mW DC Forward Current 25 30 mA Peak Forward Current [1] 140 140 mA Operating / Storage Temperature -40°C To +85°C Lead Solder Temperature [2] 260°C For 3 Seconds Lead Solder Temperature [3] 260°C For 5 Seconds Notes: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. 2. 2mm below package base. 3. 5mm below package base. SPEC NO: DSAF2685 REV NO: V.5B DATE: JAN/21/2015 PAGE: 2 OF 7 APPROVED: WYNEC CHECKED: Allen Liu DRAWN: L.Q.Xie ERP: 1101000881 WP117GYWT Green SPEC NO: DSAF2685 REV NO: V.5B DATE: JAN/21/2015 PAGE: 3 OF 7 APPROVED: WYNEC CHECKED: Allen Liu DRAWN: L.Q.Xie ERP: 1101000881 Yellow SPEC NO: DSAF2685 REV NO: V.5B DATE: JAN/21/2015 PAGE: 4 OF 7 APPROVED: WYNEC CHECKED: Allen Liu DRAWN: L.Q.Xie ERP: 1101000881 PACKING & LABEL SPECIFICATIONS WP117GYWT Terms and conditions for the usage of this document 1. The information included in this document reflects representative usage scenarios and is intended for technical reference only. 2. The part number, type, and specifications mentioned in this document are subject to future change and improvement without notice. Before production usage customer should refer to the latest datasheet for the updated specifications. 3. When using the products referenced in this document, please make sure the product is being operated within the environmental and electrical limits specified in the datasheet. If customer usage exceeds the specified limits, Kingbright will not be responsible for any subsequent issues. 4. The information in this document applies to typical usage in consumer electronics applications. If customer's application has special reliability requirements or have life-threatening liabilities, such as automotive or medical usage, please consult with Kingbright representative for further assistance. 5. The contents and information of this document may not be reproduced or re-transmitted without permission by Kingbright. 6. All design applications should refer to Kingbright application notes available at http://www.KingbrightUSA.com/ApplicationNotes SPEC NO: DSAF2685 REV NO: V.5B DATE: JAN/21/2015 PAGE: 5 OF 7 APPROVED: WYNEC CHECKED: Allen Liu DRAWN: L.Q.Xie ERP: 1101000881 SPEC NO: DSAF2685 REV NO: V.5B DATE: JAN/21/2015 PAGE: 6 OF 7 APPROVED: WYNEC CHECKED: Allen Liu DRAWN: L.Q.Xie ERP: 1101000881 SPEC NO: DSAF2685 REV NO: V.5B DATE: JAN/21/2015 PAGE: 7 OF 7 APPROVED: WYNEC CHECKED: Allen Liu DRAWN: L.Q.Xie ERP: 1101000881