MEAN WELL SCP-1K2-24

900~1200W Parallel (N+1) With PFC Function SCP-1K2 s e ri e s Features : AC input 180~260VAC only PF> 0.98@ 230VAC Protections: Short circuit / Overload / Over voltage / Over temperature Built in remote sense function Built-in remote ON-OFF control Built-in power good signal output Built-in parallel operation function(N+1) Can adjust from 20~100% output voltage by external control 1-5V Forced air cooling by built-in DC fan 3 years warranty SPECIFICATION ORDER NO. SCP-1K2-05 SCP-1K2-09 SCP-1K2-12 SCP-1K2-15 SCP-1K2-18 SCP-1K2-24 SCP-1K2-36 SCP-1K2-48 SCP-1K2-60 SAFETY MODEL NO. 1K2S-P005 1K2S-P009 1K2S-P012 1K2S-P015 1K2S-P018 1K2S-P024 1K2S-P036 1K2S-P048 1K2S-P060 DC VOLTAGE 5V 9V 12V 15V 18V 24V 36V 48V 60V RATED CURRENT 200A 133A 100A 80A 66.6A 50A 33.3A 24A 20A CURRENT RANGE 0 ~ 200A 0 ~ 133A 0 ~ 100A 0 ~ 80A 0 ~ 66.6A 0 ~ 50A 0 ~ 33.3A 0 ~ 24A 0 ~ 20A RATED POWER 1000W 1197W 1200W 1200W 1198W 1200W 1198W 1152W 1200W OUTPUT RIPPLE & NOISE (max.) Note.2 100mVp-p 100mVp-p 120mVp-p 150mVp-p 180mVp-p 240mVp-p 360mVp-p 480mVp-p 500mVp-p VOLTAGE ADJ. RANGE 3.0% Typical adjustment by potentiometer 20%~100% adjustment by 1~5VDC external control VOLTAGE TOLERANCE Note.3 2.0% 1.5% 1.0% 1.0% 1.0% 1.0% 1.0% 1.0% 1.0% LINE REGULATION 0.5% 0.5% 0.5% 0.5% 0.5% 0.5% 0.5% 0.5% 0.5% LOAD REGULATION 1.5% 1.0% 0.5% 0.5% 0.5% 0.5% 0.5% 0.5% 0.5% SETUP, RISE, HOLD UP TIME 500ms, 200ms, 16ms at full load VOLTAGE RANGE 180 ~ 260VAC 260 ~ 370VDC see the derating curve FREQUENCY RANGE 47 ~ 63Hz POWER FACTOR >0.98 / 230VAC INPUT EFFICIENCY (Typ.) 80% 82% 84% 85% 86% 89% 89% 90% 90% AC CURRENT 10A / 230VAC INRUSH CURRENT (max.) 60A / 230VAC LEAKAGE CURRENT (max.) 3.5mA / 240VAC 105 ~ 140% rated output power OVERLOAD Note. 4 Protection type : Current limiting, delay shut down o/p voltage, re-power on to recover 110 ~ 135% Follow to output set up point PROTECTION OVER VOLTAGE Protection type : Shut down o/p voltage, re-power on to recover >100 / measure by heat sink, near transformer OVER TEMPERATURE Protection type : Shut down o/p voltage, recovers automatically after temperature goes down -20 ~ +65 (Refer to output load derating curve) WORKING TEMP. 20 ~ 90% RH non-condensing WORKING HUMIDITY STORAGE TEMP., HUMIDITY -20 ~ +85 , 10 ~ 95% RH ENVIRONMENT TEMP. COEFFICIENT 0.04% / (0 ~ 50 ) VIBRATION 10 ~ 200Hz, 2G 10min./1cycle, 60min. each along X, Y, Z axes UL60950, TUV EN60950-1 approved SAFETY STANDARDS WITHSTAND VOLTAGE I/P-O/P:3KVAC I/P-FG:1.5KVAC O/P-FG:0.5KVAC SAFETY & ISOLATION RESISTANCE I/P-O/P, I/P-FG, OP/FG:100M Ohms / 500VDC / 25 / 70% RH EMC EMI CONDUCTION & RADIATION Compliance to EN55022 (CISPR22) class A (Note. 5) HARMONIC CURRENT Compliance to EN61000-3-2,3 EMS IMMUNITY Compliance to EN61000-4-2,3,4,5,6,8,11, light industry level, criteria A POWER GOOD SIGNAL Open collector of NPN transistor SPECIAL FUNCTION DC Voltage Adj., remote sensing, remote control, parallel operation(refer to control terminal instruction manual) COOLING By fan, >20% load or >50 fan on OTHERS MTBF 37.4K hrs min. MIL-HDBK-217F(25 ) DIMENSION 290*120*132mm (L*W*H) PACKING 5kg; 4pcs /21kg /CARTON 1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25 of ambient temperature. NOTE 2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor. 3. Tolerance : includes set up tolerance, line regulation and load regulation. 4. Current limiting 3 times(1.5s,3.0s,5.0s)Then intelligent auto recovery before shut down 5. The power supply is considered a component which will be installed into a final equipment. The final equipment must be re-confirmed that it still meets EMC directives. File Name: SCP-1K2-SPEC 2008-05-06 900~1200W Parallel (N+1) With PFC Function SCP-1K2 s e ri e s Mechanical Specification Unit:mm 290 200 120 200 1 2 3 1 2 3 4 5 6 7 8 TB1 #6-32-4 Vadj AC INPUT M3(NUT) 3H-4 LED POS+ NEG- LED 30 26.5 251 Air flow M3(NUT) 3H-4 direction Terminal Pin No. Assignment Control terminal Pin No. Assignment (TB1) : Dinkle 51HDBC-O8P or equivalent Pin No. Assignment Pin No. Assignment Pin No. Assignment Mating With 1 AC/L 1 VS+ 5 PG 2 AC/N 2 VS- 6 PAR Dinkle 51SDB-O8P 3 FG VCI GND or equivalent 3 7 VCO INH 4 8 Derating Curve Ta=25 1800 100 1600 80 1400 1200 60 1100 1000 40 800 20 600 -20 -10 10 20 30 40 50 60 70 90 110 130 150160 180 200 220 240 260 AMBIENT TEMPERATURE ( ) INPUT VOLTAGE (VAC) 60Hz File Name: SCP-1K2-SPEC 2008-05-06 132.5 LOAD (%) OUTPUT POWER (W) 103 89 900~1200W Parallel (N+1) With PFC Function SCP-1K2 series Control terminal instruction manual LOAD LOAD LOAD LOAD VS+ VS+ VS+ VS+ VS- VS- VS- VS- VCI VCI VCI VCI VCO VCO VCO VCO H:ON PG PG PG PG ON/OFF SWITCH PAR PAR PAR PAR L:OFF GND GND GND GND INH INH INH INH USING INTERNAL VOLTAGE CONTROL ON/OFF CONTROL BY SWITCH ON/OFF CONTROL BY TRANSISTOR REMOTE SENSING Vout O.V.P. 120% (Typ.) GOOD : LED OFF FAIL 120 :LED ON 100 LOAD LOAD 80 Non-Linear VS+ VS+ 60 VS- VS- VCI VCI VCO VCO 40 DC 1-5V PG PG PAR PAR GND GND 20 INH INH 40V / 0.5A MAX. V 123456 POWER GOOD SIGNAL OUTPUT VOLTAGE ADJUST WITH DC 1-5V EXTERNAL VOLTAGE (DC) LOAD LOAD VS+ VS+ VS+ VS+ VS+ VS+ VS- VS- VS- VS- VS- VS- VCI VCI VCI VCI VCI VCI VCO VCO VCO VCO VCO VCO PG PG PG PG PG PG PAR PAR PAR PAR PAR PAR GND GND GND GND GND GND INH INH INH INH INH INH PARALLEL OPERATION WITHOUT REMOTE SENSING PARALLEL OPERATION WITH REMOTE SENSING File Name: SCP-1K2-SPEC 2008-05-06 OUTPUT VOLTAGE (%)