WWW.PHIHONG.COM 80W Constant Current LED Driver PDA080 Series for Outdoor Lighting Features  High Efficiency  IP67 - waterproof, Potted  UL8750 Compliant  Wide Operating Temperature Range  5 Year Warranty  Brownout/Brownout Recovery  OVP, Short and Open Circuit Protection  120V-277V Rated Operation Applications  General Lighting  Outdoor Lighting  Street Lighting  Architectural Lighting Safety Approvals  CE  cUL/UL Mechanical Characteristics  Length: 242mm (9.5in)  Height: 30.5mm (1.2in)  Width: 43.5mm (1.7in)  Weight: 750g (1.65lbs) Output Specifications DC Output Voltage Output Output (1) Model (2) Current Min. Typ. Max. Power PDA080X-700G 90V - 114V 700mA 80W PDA080X-1A0G 50V - 76V 1000mA 80W PDA080X-1A6G 34V - 48V 1670mA 80W Note (1): X is B for non-dimming or W for 0-10V Dimming Note (2): Output power drops to 65W maximum when input is 90-100VAC Phihong is not responsible for any error, and reserves the right to make changes without notice. Please visit our website at www.phihong.com for the most up-to-date specifications and contact information. Revised 11/8/2013 PDA080X Characteristics WWW.PHIHONG.COM Input: Dimming Grounding AC Input Voltage Range Dim(-) and Vout(-) must never be connected together to 90VAC to 304VAC ensure proper operation and isolation requirements AC Input Frequency EMC 47~63Hz EN55015/CISPR 15, FCC 47 CFR Part 15/18, Class A Maximum Input Current Immunity ≤ 2A IEC61000-4-2 IEC61000-4-3 Leakage Current IEC61000-4-4 0.5mA maximum at 230VAC Input IEC61000-4-5* IEC61000-4-6 Inrush Current IEC61000-4-8 ≤ 20A IEC61000-4-11 IEC61000-3-2 Class C OUTPUT: *Surge Differential mode: 2.0kV, Common mode: 4.0kV Power Factor ≥ 0.9 at nominal Ring Wave Surge (ANSI C62.41.2 Cat A) Differential mode: 4.0kV Ripple and Noise Common mode: 6.0kV <7% (p-p) Input Over Current Protection Efficiency (Target) The input power line will be fused with a 3.15A fuse 85% at 277VAC 84% at 120VAC Short-Circuit Protection The PSU will withstand a short circuit across the Turn-on Delay Time outputs without damage 0.5s maximum at nominal AC Power ON Open Circuit Protection Environmental: Once the circuit is opened, the output voltage should be Temperature less than 120% at nominal AC input conditions Operation -40 to +60°C Non-operation -40 to +85°C Dielectric Withstand (Hi-pot) Test Primary to secondary: 4242VDC for 1 minute, 5mA Operating Humidity 10 to 95% Insulation Resistance Case Temperature Primary to secondary: >5M Ohm 500VDC, 1 Minute 80°C maximum Design Life Warranty 50K hours at full power, ambient 50°C and Tcase