WWW.PHIHONG.COM 2 Port 95W per Port Power over Ethernet Mega PoE Midspan Features • Fully Compliant Detection,Disconnect • Proprietary Detection, Disconnect and and Voltage Control IEEE802.3af Overload Protection • Gigabit Compatible • Limited Power Source • SNMP Management • Diagnostic LEDs • Full Protection OCP, OVP • Full Power at 95W per port • Kit available for mounting in a 19” • 1 Year Warranty Rack Applications • LCD Displays • Computer Stations • Wireless Access Points • Kiosks • Emergency Lights • Outdoor Security Cameras • Magnetic Locks • Medical Monitoring Safety Approvals • cUL/UL • CE Mechanical Characteristics • Length: 224.9mm (8.85in) • Height: 48.5 mm (1.91in) • Width: 200mm (7.87in) • Weight: 1.59Kg (3.5lbs) Output Specifications Model Number of Ports POE240U-2MP-N 2 Optional 19” Rack mounting adapter to mount 1 POE240U or 2 side by side; order P/N POE125U-ACCY01 Reference files: 1. SNMPv2c_User_Manual-Rev1.7.pdf 2. Multiport_Midspan_Installation_Manual.pdf 3. SNMPv2c_Firmware-Rev1.7.zip 4. SNMPv2c_MIB_10_30_2009.zip 5. 19in_Rack_Mounting_Kit_Datasheet.pdf Phihong is not responsible for any error, and reserves the right to make changes without notice. Please visit our website at www.phihong.com for the most up-to-date specifications and contact information. Revision 4/26/2018 POE240U-2MPN Characteristics WWW.PHIHONG.COM INPUT: ENVIRONMENTAL: AC Input Voltage Range Temperature 90 to 264VAC Operation 0 to +40°C Non-operation -25 to +65°C Input Frequency Humidity 5 to 90% 47-63Hz EMC Input Current EN55022 Radiate Class A 5A (RMS) maximum for 90VAC EN55022 Conducted Class B 2.5A (RMS) maximum for 230VAC Isolation Test Leakage Current Primary to Secondary: 4242VDC, 1 minute 3.5mA maximum at 254VAC 60Hz Primary to Ground: 2121VDC, 1 minute Secondary to Ground: 2121VDC, 1 minute AC Inrush Current 30A (RMS) maximum for 115VAC Insulation Resistance 60A (RMS) maximum for 230VAC Primary to Secondary: >10M OHM 500VDC OUTPUT: Primary to Field Ground: >10M OHM Total Output Power 500VDC 95W per port Total power on all ports 190W Immunity EN50082-1 ESD: EN61000-4-2. Level 3 Ripple and Regulation RS: EN61000-4-3. Level 2 250mV maximum EFT: EN61000-4-4. Level 2 Surge: EN61000-4-5. Level 3 Efficiency CS: EN61000-4-6. Level 2 75% (typical) at maximum load, and Voltage Dips EN61000-4-11 120VAC 60Hz Harmonic: EN61000-3-2 Class A Hold-up Time IEEE 802.3af Interoperability 10mS min. 120VAC and maximum load If 25kohm is detected the unit operates in “IEEE802.3at mode” 33.6W 2 pair Transient O/P Voltage Protection powering. 12.5k detection resistance 60V maximum at switch on and off at any required for full power AC line Phase UNH Interoperability report available on request Turn-On Delay Time 20 sec maximum at maximum load, and FEATURES: 120VAC 60Hz, 25Hz Cisco Legacy detection No extern parts required for Legacy devices: VoIP Phones: 7910, 7912, 7940, 7960 Access Points: 350, 1100, 1200, 1250 POE240U-2MPN Characteristics WWW.PHIHONG.COM Over Voltage/Current, Short Circuit Indicators Protection Green LED: Power detected “CONNECT” Outputs equipped with short circuit at 60WFlashing GREEN: IEEE802.3at protection and overload protection as per detected “CONNECT” at 30W 802.3af specifications except for maximum Yellow LED: Fault detected average current is 1.69A Input Connector The output can be shorted permanently AC Input IEC320 3 pin without damage Output Connection Over Temperature Protection 4-pair powering for full power Automatic Shutdown without damage Pins 3,6, 4,5(+) Pins 1,2, 7,8 (-) 2-pair powering for IEEE802.3at mode Pins 3,6(+) Pins 1,2 (-) Dimension Diagram (mm) Façade Display Showing Optional Rack Mounting