WWW.PHIHONG.COM 4 Ports 60W per Port Power over Ethernet Ultra PoE Midspan Features • Fully Compliant Detection, • Limited Power Source Disconnect and Voltage Control • Gigabit Compatible IEEE802.3af • Proprietary Detection, Disconnect and • Diagnostic LEDs Overload Protection • SNMP Management • Full Protection OCP, OVP • Full Power at 60W per port • Optional Mounting Kit for 19” Rack • 1 Year Warranty Applications • LCD Displays • Computer Stations • Wireless Access Points • Kiosks • High Power Radios Safety Approvals • cUL/UL • CE Mechanical Characteristics • Length: 224.9mm (8.85in) • Height: 48.5 mm (1.91in) • Width: 200mm (7.87in) • Weight: 1.59Kg (3.5lbs) Output Specifications Model Number of Ports POE240U-4UP-N 4 Optional 19” Rack mounting adapter to mount 1 POE125U or 2 side by side; order P/N POE125U-ACCY01 Reference files: 1. SNMPv2c_User_Manual-Rev1.7.pdf 2. SNMPv2c_Firmware-Rev1.7.zip 3. SNMPv2c_MIB_10_30_2009.zip Phihong is not responsible for any error, and reserves the right to make changes without notice. Please visit our website at www.phihong.com for the most up-to-date specifications and contact information. Revision 1/10/2018 POE240U-4UPN Characteristics WWW.PHIHONG.COM INPUT: EMC AC Input Voltage Range EN55022 Radiate Class A 90 to 264VAC EN55022 Conducted Class B Input Frequency Isolation Test 47-63Hz Primary to Secondary: 4242VDC for 1 minute Primary to Ground: 2121VDC for 1 minute Input Current Secondary to Ground: 2121VDC for 1 minute 5A (RMS) max for 90VAC 2.5A (RMS) max for 230VAC Insulation Resistance Primary to Secondary: >10M OHM 500VDC Leakage Current Primary to Field Ground: >10M OHM 3.5mA max at 254VAC 60Hz 500VDC AC Inrush Current Immunity EN50082-1 30A (RMS) max for 115VAC ESD: EN61000-4-2. Level 3 60A (RMS) max for 230VAC RS: EN61000-4-3. Level 2 EFT: EN61000-4-4. Level 2 OUTPUT: Surge: EN61000-4-5. Level 3 Total Output Power CS: EN61000-4-6. Level 2 60W per port at 56V+1/-2 Voltage Dips EN61000-4-11 Total power on all ports 240W Harmonic: EN61000-3-2 Class A Ripple and Regulation IEEE 802.3af Interoperability 250mV max If 25kohm is detected the unit operates in “IEEE802.3at mode” 33.6W 2 pair powering. Efficiency 12.5k detection resistance required for full 75% (typical) at max load,120VAC 60Hz power UNH Interoperability report available on Hold-up Time request 10mS min. 120VAC and max load FEATURE: Transient O/P Voltage Protection Cisco Legacy detection 60V max at switch on/off at any AC line Phase No extern parts required for Legacy devices: VoIP Phones: Turn-On Delay Time 7910, 7912, 7940, 7960 20 sec max at max load,120VAC 60Hz, 25Hz Access Points: 350, 1100, 1200, 1250 ENVIRONMENTAL: Temperature Over Voltage/Current Protections Operation 0 to +40°C Outputs equipped with short circuit protection Non-operation -25 to +65°C and overload protection as per 802.3af Humidity 5 to 90% specifications except for max average current is 1.69A Short Circuit Protection Output Connection The output can be shorted permanently 4-pair powering for full power without damage Pins 3,6, 4,5(+) Pins 1,2, 7,8 (-) Over Temperature Protection 2-pair powering for IEEE802.3at mode Automatic Shutdown without damage Pins 3,6(+) Pins 1,2 (-) Indicators Warranty Green LED: Power detected “CONNECT” at 1 Year 60W Flashing GREEN: IEEE802.3at detected “CONNECT” at 30W Yellow LED: Fault detected Input Connector AC Input IEC320 3 pin POE240U-4UPN Dimension Diagram (mm) WWW.PHIHONG.COM Façade Display Showing Optional Rack Mounting