WWW.PHIHONG.COM 4-Port 95W per Port Midspan Mega Power over Ethernet Midspans Features • Fully Compliant Detection, • Proprietary Detection, Disconnect and disconnect and Voltage Control per Overload Protection IEEE802.3af • SNMP Management • Gigabit Compatible • Mega PoE 95W per Port • Full Protection OCP, OVP • Diagnostic LEDs • Limited Power Source • 1U Rack Mounting Kit Ships with Unit • 1 Year Warranty Applications • Wireless Access Points • Security Systems • Computer Workstations • IP Cameras • Kiosks • Magnetic Locks Safety Approvals • cUL/UL • CE Mechanical Characteristics • Length: 438mm (17.25in) • Height: 44.5mm (1.75in) • Width: 228mm (8.98in) • Weight: 3.8Kg (8.5lbs) Output Specifications Load DC Output (1) Model Output Power per Port (2) Voltage Min. Max. POE576U-4MP-N 56V 15mA 1.69A 95W Note (1): Model without SNMP management available upon special request Note (2): Max load applies to compliant load at 12.5K detection. If operating at 25K “IEEE802.3at mode” max load is 0.6A Reference files: 1. SNMPv2c_User_Manual-Rev1.7.pdf 2. Multiport_Midspan_Installation_Manual.pdf 3. SNMPv2c_Firmware-Rev1.7.zip 4. SNMPv2c_MIB_10_30_2009.zip Phihong is not responsible for any error, and reserves the right to make changes without notice. Please visit our website at www.phihong.com for the most up-to-date specifications and contact information. Revision 1/9/2018 POE576U-4MPN Characteristics WWW.PHIHONG.COM INPUT: Input Voltage Rating ENVIRONMENTAL 100 to 240VAC Temperature Operation 0 to +40C Input Voltage Range Non-Operation -25 to +65C 90 to 264VAC Humidity AC Input Current Operation 5 to 90% 9.0A (RMS) 90VAC at maximum load Non-Operation 5 to 90% 4.25A (RMS) 230VAC at maximum load EMC AC Input Frequency EN55022 Class A, FCC Class A with UTP 47 to 63Hz cabling EN55022 Class B, FCC Class B with FTP Leakage Current cabling 3.5mA maximum at 264VAC and 60Hz Isolation Test Max In-Rush Current: Primary to Secondary: 4242VDC for 1 min 30A for 115VAC at maximum load Primary to Ground: 2121VDC for 1 min 60A for 230VAC at Maximum load Secondary to Ground: 2121VDC for 1 min (Cold Start at Ambient 25°C) Immunity EN50082-1 OUTPUT: ESD: EN61000-4-2 Level 3 Total Output Power RS: EN61000-4-3 Level 2 95W per port EFP: EN61000-4-4 Level 2 380W Maximum Total Power Surge: EN61000-4-5 Level 3 CS: EN61000-4-6 Level 2 Ripple and Regulation Voltage Dips: EN61000-4-11 250mV maximum Harmonic: EN61000-3-2 Class A Efficiency IEEE802.3af/at Interoperability 75% (typical) at maximum load, and If 25K Ohm is detect the unit operates in 120VAC 60Hz “IEEE802.3at mode” 33.6W 2 pair powering. 12.5K detection resistance Hold-Up Time required for full power. 16mS min. 120VAC and maximum load FEATURE: Transient O/P Voltage Protection Cisco Legacy Detection 60V maximum at switch on and off at any No extern parts required for Legacy AC line Phase Devices: VoIP Phones:7910, 7912, 7940, 7960 Turn-On Delay Time Access Points350, 1100, 1200 20 sec maximum at maximum load, 120VAC 60Hz POE576U-4MPN Characteristics WWW.PHIHONG.COM Over-Voltage/Current, Short Circuit SNMPv2c management port Interface Protection NIC interface for remote management via Outputs equipped with short circuit secure IP access protection and overload protection as per 802.3af specification except at maximum Input Connector average current is 1.69A AC Input IEC320 C14 The output can be shorted permanently without damage Output Connection 4-pair powering for full power Over Temperature Protection Pins 3, 4, 5, 6 (+) Automatic shutdown without damage Pins 1, 2, 7, 8 (-) Indicators 2-pair powering for IEEE802.3at mode Solid Green LED: Power detected “ON” Pins 3, 6 (+) Flashing Green: IEEE802.3at or (af) Pins 1, 2 (-) detected Yellow LED: Fault detected POE576U-4MPN Dimension Diagram Unit: mm