WWW.PHIHONG.COM 80W Power over Ethernet Midspan High Power Single Port Injector Features • Fully Compliant Detection, Disconnect and Voltage Control per • Single Source 4-Pair Powering IEEE802.3af • Diagnostic LEDs • Full Protection OCP, OVP, OTP • Gigabit Compatible • Broken Wire Detection • 1 Year Warranty Wide Operating Temperature Range Applications • Satellite Receiver • Security Cameras • Wireless Network Access Points • Kiosks • LCD Displays • Computer Workstations Safety Approvals • cUL/UL • CCC • CE • SAA • C-Tick • Korea (PHC) • IRAM Mechanical Characteristics • Length: 203mm (8in) • Height: 63mm (2.5in) • Width: 108mm (4.25in) • Weight: 1.93Kg (4.5lbs) Output Specifications DC Output Load Regulation Model Voltage Min. Max. Line Load 1 POE80U-560(G) +56V 0A 0.72A 54-57V DC Note: Output measured over data and spare pairs for combined 1.43A output. (1) Consult factory for availability Phihong is not responsible for any error, and reserves the right to make changes without notice. Please visit our website at www.phihong.com for the most up-to-date specifications and contact information. Revision 5/29/2018 POE80U Characteristics WWW.PHIHONG.COM INPUT: EMC AC Input Voltage Range Complies with FCC Class B 85 to 264VAC Complies with EN55032 Class B AC Input Voltage Rating Isolation Test 100 to 240VAC Primary to Secondary: 4242VDC for 1 minute, 10mA Input Frequency Primary to Field Ground: 2121VDC for 1 47 to 63Hz minute Output to Field Ground: 2121VDC AC Input Current 2.0A (RMS) maximum for 90VAC Immunity 1.2A (RMS) maximum for 240VAC ESD: EN61000-4-2 Level 3 RS: EN61000-4-3 Level 2 AC Inrush Current EFT: EN61000-4-4 Level 2 50A (RMS) maximum for nominal input Surge: EN61000-4-5 Level 3 CS: EN61000-4-6 Level 2 OUTPUT: Voltage Dips: EN61000-4-11 Total Output Power Harmonic: EN61000-3-2 80W Insulation Resistance DC Offset Primary to secondary: >10M OHM 500VDC No data degradation with DC imbalance Primary to Field Ground: >10M OHM 18mA per min. 500VDC Ripple and Regulation (P-P) IEEE802.3af/at Interoperability 100mV maximum UNH Interoperability report available upon request Efficiency 75% (typical) at maximum load, and FEATURE: 120VAC 60Hz Detection 12.5K ohm detection resistor value required Hold-up Time to turn on full power (4-pairs) 10mS min. 120VAC and maximum load Over Voltage/Current, Short Circuit Transient O/P Votlage Protection Protection 60V maximum at switch on/off at any point Outputs equipped with short circuit on the AC line phase protection dn overload protection as per 802.3af specifications except max average ENVIRONMENTAL: pair current is 0.72A, Peak 1.4A per pair. Temperature The output can be shorted permanently Operation -40 to 55C without damage. Non-operation -50 to +85C Humidity 5 to 90% POE80U Characteristics WWW.PHIHONG.COM Indicators Input Connector Green LED 1: DC Power “ON” IEC320 inlet 3 pin Red LED: Fault detected Green LED 2: Power detected “CONNECT” Output Connection at 80W Pins 3,6, 4,5(+) Pins 1,2, 7,8 (-) Dimension Diagram Unit: mm