GB60S 60W Single Output General Purpose Features
2” x 3” x 1.0” Package
For 1U Applications
60W convection cooled
Universal Input 90-264Vac
Optional Power ON LED
Approved to CSA/EN/IEC/UL60950-1, nd 2 Edition
Level V Efficiency Compliant Models
Less than 0.5W no-load Power Consumption
3 Year Warranty
RoHS Compliant Description The GB60S Series models provide a highly reliable power source in high density 2” x 3” x 1.0” package. Fully compliant to the applicable safety and EMC standards, these models will allow easy integration into many industrial and ITE applications. All 4 models are CE marked to low voltage directive and approved to ITE nd standards of EN60950, 2 edition. Model Selection Model Output Current Output Power Ripple & Total OVP Number* Volts Convection Cooled Convection Cooled Noise** Regulation Threshold GB60S12K 12V 4.58A 55W 120mV pk-pk ±2% 14.4-18Vdc GB60S15K 15V 4.00A 60W 150mV pk-pk ±2% 18-22.5Vdc GB60S24K 24V 2.50A 60W 240mV pk-pk ±2% 28.8-36Vdc GB60S48K 48V 1.25A 60W 480mV pk-pk ±2% 57.6-72Vdc Notes: * Models with 24V or higher output voltage meet efficiency requirements of Level V ** Measured with noise probe directly across output terminals, and load terminated with 0.1μF ceramic and 10μF low ESR capacitors. General Specifications 100-240Vac, 47-63Hz, 1∅ rated AC Input Turn On Time 2 sec. max. @120Vac 80–270Vac, 47-440Hz operational 120Vac: 1.4A, 240Vac: 0.75A 16mS min. @ 60W load, 120Vac input Input Current Hold-up Time Inrush Current 240Vac, cold start: will not exceed 40A Signals Optional Power ON LED Overload Input Fuses 4A, 250VAC fuse provided on all models Hiccup Mode, 120% to 180%, typical Protection www.slpower.com GB60S REV 4.3,6-MAR-13 1 GB60S 60W Single Output General Purpose General Specifications (continued) Earth Leakage Short Circuit <1mA@240Vac, NC Hiccup Mode Current Protection Overtemperature Not Applicable Self-recovering Power Factor Protection nd CSA/EN/IEC/UL60950-1, 2 Edition. See below Efficiency 88% typical (83% for 12V& 85% for 15V) Safety Standards for detailed standards information. Input-Output: 4000Vac Output Power 60W continuous (55W for 12V models) Isolation Input-Ground: 1800Vac Output-Ground: 500Vac Peak Output Operating -10°C to +70°C Not Applicable -40C start up Power Temperature Output Power Ripple and Noise See chart above See Fig.1 on page 4 Derating Storage Output Voltage See chart -40°C to +85°C Temperature Voltage Fixed 5% to 95%, non-condensing Relative Humidity Adjustability Operating: 3000 meters Minimum Load Not required Altitude Non-operating: 40,000 ft. Total Regulation +/- 3%. See chart MTBF Over 300,000 hours per Telcordia Random Vibration per MIL-STD-810E, Method Transient 500µS max. to 1%, 50% load step. 0.2A/µS, 514.4, Cat. 1, Figure 514.4.1, 1 hour in each of 3 Vibration 3.5% deviation typical Response axes. Switching Half-sine, 40 gpk, 10 mS duration, +/- in each of 65kHz, typical Shock Frequency 3 axes, 6 shocks total 2.0” x 3.0” x 1.0” Dimensions Weight 126g 50.8 x 76.2 x 25.4mm Notes: 1. Specifications subject to change without notice. 2. All dimensions in inches (mm), tolerance is ±.02”. 3. Mounting holes should be grounded for EMI purpose 4. FG is safety ground connection 5. Specifications are for convection rating at factory settings with 115Vac input and 25°C ambient unless otherwise stated. 6. This power supply requires mounting on metal standoffs 0.20” (5mm) in height. 7. For Class II (no earth ground) applications, all mounting hardware must be non-conductive. www.slpower.com GB60S REV 4.3,6-MAR-13 2 GB60S 60W Single Output General Purpose EMI/EMC Compliance Conducted Emissions EN55011/22 Class B, FCC Part 15 Class B EN55011/22 Class A, FCC Part 15 Class A with 6dB margin Radiated Emissions EN61000-4-2, 6kV Contact Discharge, 8kV air discharge Static Discharge Immunity Radiated RF Immunity EN61000-4-3, 3V/m EFT/Burst Immunity EN61000-4-4, 2kV/5kHz Line Surge Immunity EN61000-4-5, 1kV differential, 2kV common-mode Conducted RF Immunity EN61000-4-6, 3Vrms Power Frequency Magnetic Field Immunity EN61000-4-8, 3A/m EN61000-4-11 100Vac, 95% dip/0.5 cycle (Criteria A), 60%/5cycles Voltage Dip Immunity (Criteria B), 30%/25 cycles (Criteria A). EN61000-3-2 Class A Line Harmonic Emissions Flicker Test EN61000-3-3, Complies (dmax<6%) Mechanical Drawing Connector Information Input Connector DC Output Connector J100 J2 Ground PIN 1) AC LINE 19-30258-0187 (Keystone PIN 1) +Vout PIN 3) -Vout PIN 2) EMPTY 1285)(Zierick PIN 2) +Vout PIN 4) -Vout PIN 3) AC NEUTRAL 895)(.187*0.020) Mating Connector: Mating Connector: Tyco/AMP 640250-3 AMP 640250-4 Molex 01-90020005 Pins = 770461-1 Pins = 770461-1 www.slpower.com GB60S REV 4.3,6-MAR-13 3 60 70 60 45 50 30 40 30 15 20 10 6 0 -10 GB60S 60W Single Output General Purpose Characteristic Curves Output vs. Temperature 55W convection cooled, derating output power to 50% at 70°C for 12V. 60W convection cooled, derating output power: 50W at 60°C and 40W at 70°C for Output Voltages ≥ 24V Output Power vs. Temperature 80 Convection for 12V 70 model Convection 60 for 24V and above 50 40 30 20 Temperature (℃) Fig.1 Efficiency vs. Loading Efficiency vs. Output Power 100.0% 90.0% 80.0% 70.0% Output Power (W) 120Vac 240Vac Fig.2 www.slpower.com GB60S REV 4.3,6-MAR-13 4 Output Power (W) Efficiency (%) GB60S 60W Single Output General Purpose Ripple & Noise To verify that the output ripple and noise does not exceed the level specified in the product specification, measured using a scope probe socket with 0.1uF ceramic and a 10uF electrolytic capacitor connected in parallel across it, 20MHz BW. 24V OUT, NO LOAD, 90VAC, 60HZ 24V OUT, FULL LOAD, 90VAC, 60HZ 24V OUT, NO LOAD, 264VAC, 50HZ 24V OUT, FULL LOAD, 264VAC, 50HZ www.slpower.com GB60S REV 4.3,6-MAR-13 5 GB60S 60W Single Output General Purpose Output Transient Response 50% load step within the regulation limits of minimum and maximum load, dI/dt< 0.2A/μSec. Recovery time not specified as there is no laps in regulation with a 50% Load Step. Maximum voltage deviation is 3.5% 24V OUT, 120VAC, 25% TO 75% LOAD STEP 24V OUT, 240VAC, 25% TO 75% LOAD STEP Output Overload Characteristic 24V OUT, 90VAC 24V OUT, 264VAC Short Circuit Protection Supply shall protect itself against Short Circuit conditions. No damage will occur if the output is shorted. 24V OUT, 90VAC 24V OUT, 264VAC www.slpower.com GB60S REV 4.3,6-MAR-13 6 GB60S 60W Single Output General Purpose Overvoltage Protection OVP firing reduces output voltage to <50% of nominal in <50ms. See models chart for trip ranges. 24V OUT, FULL LOAD, 90VAC, 60HZ 24V OUT, FULL LOAD, 264VAC, 50HZ Turn On Time 24V OUT, FULL LOAD, 90VAC, 60HZ 24V OUT, FULL LOAD, 264VAC, 50HZ Hold Up Time 24V OUT, FULL LOAD, 120VAC, 60HZ Data Sheet © 2012 SL Power Electronics Corp. The information and specifications contained herein are believed to be correct at the time of publication. However, SL Power accepts no responsibility for consequences arising from reproduction errors or inaccuracies. Specifications are subject to change without notice. www.slpower.com GB60S REV 4.3,6-MAR-13 7