GEM600 600W Single Output Economy/Technology Switchers Commercial and Medical 2 Year Warranty •600W Single Output AC-DC Power Supply •Universal Input 90-264 VAC •Standard: Active PFC, OVP, Power Fail and Inhibit (low) •Modified and Customized Designs also available •Complies with EMI/RFI Standards •Approved to EN/IEC/UL/CSA 60950-1 for ITE •Approved to EN/IEC/UL60601-1 for Medical • Compliant (LVD, RoHS) Specifications All Specifications are typical at nominal input, full load at 25°C unless otherwise stated. AC Input Turn On Time 90-264VAC, 47-63 Hz single phase. Less than 2 seconds under all rated load conditions. Input Current Hold-up Time 120VAC: 9A, 230VAC: 4.5A. ≥20 ms from loss of AC input at 600W load, 120VAC input. Inrush Current Over/Undershoot Limited by internal thermistor. The inrush at 240VAC, averaged over 3.5% max. at turn-on, 1% max. at turn-off. the first AC half-cycle under cold start conditions will not exceed 40A. Input Fuse Output Overload & Short Circuit Protection F1, F2: 12A, 250VAC fuses provided on all models. Foldback, then cycle-by-cycle current limiting, automatic recovery. Power Factor Overvoltage Protection 0.99 typical, 0.96 minimum. Latching type, recycle AC input to reset. See chart for trip levels. Earth Leakage Current Ripple and Noise 120VAC: 75μA max. NC, 120μA max. SFC. 1% pk-pk max., 20MHz BW, differential mode. Measured with noise 264VAC: 160μA max. NC, 300μA max. SFC. probe directly across output terminals. Output Power ITE Safety Standards 600W continuous. CSA/EN/IEC/UL 60950-1 Peak Output Power Medical Safety Standards 650W for 1 minute, 10% duty cycle. EN/IEC/UL 60601-1 Output Voltage Efficiency See chart. >80% typical at full rated load Voltage Adjustability Switching Frequency Adjustable potentiometer, capable of ±5% change from nominal. 140KHz main inverter and 70kHz PFC (synchronized). Minimum Load MTBF Not required. 208K hours per Telcordia. Total Regulation Overtemperature Protection See chart. Automatic. Transient Response Weight 500μs max., 50% load step, ∆i/∆t < 0.2A/μs. 3.75 lbs. (1.70kg) Enclosure Dimensions Signals See outline drawing AC Power Fail: TTL “0” 10ms before the output drops to <97% of nom. Inhibit: Short inhibit pin to output common to Inhibit. 1 of 4 ______________________________________________________________________________________________________________________________ SL Power Electronics Corp • 6050 King Drive Ventura, CA 93003 • Phone 805.486.4565 • Fax 858.712.2040 • Email: info@slpower.com • www.slpower.com GEM600 600W Single Output Economy/Technology Switchers Commercial and Medical 2 Year Warranty Output Parameters Model Volts (V) ┌────── Output Current ───────┐ Ripple Total OVP Number Nominal Peak & Noise Regulation Threshold GEM600-24G 24V 25.0A 27.0A 240mV ±1.0% 30.0 ± 2V GEM600-28G 28V 21.5A 23.5A 280mV ±1.0% 33.0 ± 3V GEM600-36G 36V 16.7A 18.0A 360mV ±1.0% 43.0 ± 3V GEM600-48G 48V 12.5A 13.5A 480mV ±1.0% 56.0 ± 4V Environmental Specifications Operating Temperature Temperature Coefficient -20° to 70°C. Derate output power for operation above 50°C. Fan 0.03% per °C typical on all units. integral to the power supply. Storage Temperature Output Power Derating -40 to +85°C Derate Output Power by 2.5% per °C up to 70°C maximum. Relative Humidity Thermal Shutdown 5% to 95%, non-condensing Provided to avoid prolonged over-temperature condition. Vibration Operating Altitude 2 Operating: 0.003 g /Hz, 1.5 g overall, 3 axes, 10 min. / axis -500 to 10,000 ft. rms 2 Non-Operating: 0.026 g /Hz, 5.0 g overall, 3 axes, 1 hr. / axis rms Shock Non-operating Altitude Operating: Half-sine, 20 g , 10 ms, 3 axes, 6 shocks total -500 to 40,000 ft. pk Non-Operating: Half-sine, 40 g , 10 ms, 3 axes, 6 shocks total pk EMI/EMC Compliance RF Emissions EN55011/22 and FCC Part 15, radiated Class A, conducted Class B. Static Discharge Immunity EN61000-4-2, 6kV Contact Discharge, 8kV air discharge Radiated RF Immunity EN61000-4-3, 3V/m. EFT/Burst Immunity EN61000-4-4, 2kV/5kHz.. Line Surge Immunity EN61000-4-5, 1kV differential, 2kV common-mode Conducted RF Immunity EN61000-4-6, 3V Power Frequency Magnetic Field Immunity EN61000-4-8, 3A/m Voltage Dip Immunity EN61000-4-11, see EN60601-1-2: 2001 chart below. Line Frequency Harmonics EN61000-3-2, Class A Voltage Fluctuations/Flicker EN61000-3-3, Complies (clause 5b) EN60601-1-2: 2001 Voltage Sag Compliance Voltage Test Level Voltage Dip Duration Output Voltage Input Voltage Input Voltage Periods Deviation 100VAC <5 VAC 10mS <3.5% 100VAC 40 VAC 100mS <3.5% 100VAC 70 VAC 500mS <3.5% 240VAC <12 VAC 10mS <3.5% 240VAC 96 VAC 100mS <3.5% 240VAC 168 VAC 500mS <3.5% Note: During 100mS voltage dip (5 cycles at 40%VAC), the AC Power Fail warning may trigger. During low line 100mS voltage dip, reduced loading to 50% rated load is required to meet the deviation requirement and regulation. 2 of 4 ______________________________________________________________________________________________________________________________ SL Power Electronics Corp • 6050 King Drive Ventura, CA 93003 • Phone 805.486.4565 • Fax 858.712.2040 • Email: info@slpower.com • www.slpower.com GEM600 600W Single Output Economy/Technology Switchers Commercial and Medical 2 Year Warranty Connector Information INPUT CONNECTOR (TB1): DC OUTPUT CONNECTORS (TB2, TB3): Option: Pin 1 Pin 2 Pin 3 Manufacturer's P/N: Option: TB2 All Pins TB3 All Pins Manufacturer's P/N: A AC Line Neutral Ground EBY P/N 6002-03-N-01 A +Vout -Vout EBY P/N 6002-03-N-01 T Ground Neutral AC Line Phoenix Contact P/N 1706785 B +Vout -Vout Bussbar #10-32UNC x 0.375 Screw C +Vout -Vout Phoenix Contact P/N 1998959 MATING CONNECTORS: D +Vout -Vout Phoenix Contact P/N 1731721 Option: Mate For: Manufacturer's P/N: C TB2, TB3 Phoenix Contact P/N 1913523 SIGNAL CONNECTOR (J4) (all options): Pin 1 Pin 2 Pin 3 Pin 4 Manufacturer's P/N: All J4 AMP P/N 1375820-4 All other options' connector is a terminal block or has a direct wire connection. Pwr Good Pwr Fail N/C Inhibit AMP P/N 640456-4 “A” Option Input Connector: “T” Option Input Connector: “A” Option Output Connectors: “C” Option Output Connector: “D” Option Output Connector: Model Number Configuration GEM 600 - VV W X Y ZZ G ROHS COMPLIANT VALUE-ADDED CONFIGURATIONS: Blank = Standard Model OPTIONAL DIODE: Blank = None D = N+1 OR'ing Diode OUTPUT CONNECTOR: A = EBY P/N 6002-03-N-01 B = Buss Bars 10-32 UNC x 0.375 SCREWS C = Phoenix Contact P/N 1998959 D = Phoenix Contact P/N 1731721 INPUT CONNECTOR: A = EBY P/N 5000-03-N-12 T = Phoenix Contact P/N: 1706785 OUTPUT VOLTAGE: 24 = 24Vdc @ 31.2A 28 = 28Vdc @ 26.8A 36 = 36Vdc @ 20.8A 48 = 48Vdc @ 17.0A OUTPUT POWER MODEL SERIES 3 of 4 ______________________________________________________________________________________________________________________________ SL Power Electronics Corp • 6050 King Drive Ventura, CA 93003 • Phone 805.486.4565 • Fax 858.712.2040 • Email: info@slpower.com • www.slpower.com GEM600 600W Single Output Economy/Technology Switchers Commercial and Medical 2 Year Warranty Mechanical Specifications Data Sheet © 2009 SL Power Electronics Corp. The information and specifications contained herein are believed to be correct at the time of publication. Rev. 5-19-2009 However, SL Power accepts no responsibility for consequences arising from reproduction errors or inaccuracies. Specifications are subject to change without notice. 4 of 4 ______________________________________________________________________________________________________________________________ SL Power Electronics Corp • 6050 King Drive Ventura, CA 93003 • Phone 805.486.4565 • Fax 858.712.2040 • Email: info@slpower.com • www.slpower.com