GNT200 Front End Series 200W AC/DC Universal Input Power Supply 2 Year Warranty •Wide Range Input 100-240 VAC with PFC •Inhibit, Enable, Power Signals and Remote Sense Standard •Power Density 10-13W/in³ •Compact (3.0” x 5.0” x 1.25”) •High Efficiency: 90% Typical •Main Output and Two Auxiliary Outputs •Conducted EMI meets Class B nd •Approved to CSA/EN/IEC/UL 60950-1, 2 Edition for ITE •Approved to EN/IEC/UL60601-1 and CSA 22.2 No. 601 for Medical •Also Available in Class II (G2T200) •CB Report Available (for IEC60601-1 standard) Specifications All Specifications are typical at nominal input, full load at 25°C unless otherwise stated. AC Input 100-240VAC, 50/60 Hz, single phase Turn On Time 500 ms max 80-270VAC, 45-65 Hz max Input Current 120VAC: 3A. 230VAC: 1.5A Hold-up Time See chart Inrush Current Limited by internal thermistor. The inrush at 240Vac, Thermal Considerations Keeping the following components below averaged over the first AC half-cycle under cold start these temps indicates sufficient cooling: conditions will not exceed 38A. Q1: 90°C max., T4: 110°C max Input Fuses F1 and F2, 4A/250V Over/Undershoot 3.5% max Power Factor 0.98 typical, 0.96 minimum Overload Protection Cycling type, 250W nominal limit Leakage Current 100μA at 120VAC NC, 400μA at 264VAC, SFC Overvoltage Protection See chart Output Power 200W continuous with 200lfm airflow Ripple and Noise 1% pk-pk max., 20MHz BW, See chart for convection ratings 0.1μF and 10 μF caps on probe nd Peak Output Power 240W for 1 minute, 10% duty cycle ITE Safety Standards CSA/EN/IEC/UL 60950-1, 2 Edition Output Voltage See chart Medical Safety Standards EN/IEC/UL 60601-1, CSA22.2 No. 601-1 Voltage Adjustability Adjustable potentiometer, capable of Switching Frequency Output: 195kHz ±12kHz, PFC: 130kHz ±5% change from the nominal setting Minimum Load Not required MTBF 300K hours per Telcordia Total Regulation See chart Overtemperature Protection Automatic Transient Response 500μs to 1%, 50% load step, ∆i/∆t < 0.2A/μs E f f i c i e n c y 90% typical at 230VAC, 87% typical at 120VAC Maximum voltage deviation is 3.5% Temperature Coefficient 0.03% per °C typical on all units Operating Temperature 0 to 70°C (see chart) Operating Altitude -500 to 10,000 ft Storage Temperature -40 to +85°C Non-operating Altitude -500 to 40,000 ft Relative Humidity 5% to 95%, non-condensing Vibration 5 Hz – 500 Hz, 5 grms Shock MIL-STD-810E, 516.4 part IV Model Number Key GNT 2 XX X G RoHS Compliant Enclosure Options: Blank - no enclosure; F = Fan Cover with "U" channel; L = L bracket, no cover; T = Slotted cover with U channel; U = U channel, no cover. Output Voltage: (See models chart below) Output Power (Watts): "2" = 200W Product Family (GNT = Class I input, G2T = Class II input) ______________________________________________________________________________________________________________________________ 1 of 3 SL Power Electronics Corp • 6050 King Drive Ventura, CA 93003 • Phone 805.486.4565 • Fax 858.712.2040 • Email: info@slpower.com • www.slpower.com GNT200 Front End Series 200W AC/DC Universal Input Power Supply 2 Year Warranty Model Volts (V) ┌──── ────── Output Current ─────────────┐ Ripple Total OVP Number 100Vac Convection 240Vac Convection 90-270VAC Fan Cooled & Noise Regulation Threshold GNT212G 12V 8.3A 12.5A 16.7A 120mV ±2% 14.0 ± 1V GNT215G 15V 6.7A 10.0A 13.3A 150mV ±2% 17.6 ± 1V GNT218G 18V 5.6A 8.3A 11.1A 180mV ±2% 20.8 ± 1V GNT224G 24V 4.2A 6.3A 8.3A 240mV ±2% 27.5 ± 1V GNT228G 28V 3.6A 5.4A 7.1A 280mV ±2% 32.0 ± 1V GNT236G 36V 2.5A 3.9A 5.6A 360mV ±2% 42.0 ± 1V GNT248G 48V 1.9A 2.9A 4.2A 480mV ±2% 55.0 ± 1V Notes: 1. When the input voltage is <90Vac, derate output power by approximately 20%. 2. Convection ratings shown are for 40°C ambient. Derate load 2.5%/°C to 70°C. 3. Fan cooled rating of 200W @ 50°C requires 200lfm of airflow over the unit. General Specifications (continued from p. 1) Signals PS Off: High to Inhibit Inhibit: Low to Inhibit Pwr OK: Goes high 100ms to 200 ms after DC OK signal Pwr OK: Power fail low – 4ms warning DC OK: High when output is >92% of nominal Aux. Output: 12Vdc @ 250mA Aux. Output: 5Vdc @ 100mA, always on EMC/EMI Compliance Conducted Emissions: EN55011/22, Class B; FCC Class B Line Freq. Harmonics: EN61000-3-2 Class A Voltage Fluctuations: EN61000-3-3 Static Discharge: EN61000-4-2 RF Field Susceptability: EN61000-4-3 3 V/meter Fast Transients/Bursts EFT: EN61000-4-4, 2 kV, 5 kHz – criteria B Surge Susceptability: EN61000-4-5, criteria B Conducted Immunity: EN61000-4-6, 3 Vrms Power Freq. Mag. Field: EN61000-4-8, 3 A/m Voltage Dips Immunity: EN61000-4-11 Contact factory GNT200 Series Typical Holdup & Warning Time vs Output Power 200 180 160 140 120 100 Tholdup (mS) 80 Twarning (mS) 60 40 20 0 200 150 100 50 25 Output Power ______________________________________________________________________________________________________________________________ 2 of 3 SL Power Electronics Corp • 6050 King Drive Ventura, CA 93003 • Phone 805.486.4565 • Fax 858.712.2040 • Email: info@slpower.com • www.slpower.com Time (milliSeconds) GNT200 Front End Series 200W AC/DC Universal Input Power Supply 2 Year Warranty Mounting Options CONNECTOR INFORMATION GNT200 WEIGHT: 0.68 Lbs. (350g) AC INPUT - AMP# 640445-3 J1: PIN 1: AC LINE PIN 2: AC NEUT RAL DC OUTPUT - AMP# 640445-6 J2: PIN 1: +V out PIN 2: +V out Q1 PIN 3: +V out PIN 4: COMMON PIN 5: COMMON PIN 6: COMMON T4 J3: FAN OUT PUT - AMP# 640456-2 PIN 1: +12Vdc @ 0.25A PIN 2: FAN RTN (COMMON) SIGN ALS - MOLEX 22-05-7085 J4: PIN 1: PS OFF PIN 2: INHIBIT PIN 3: PWR OK PIN 4: DC OK PIN 5: SIGN AL RTN (COMMON) PIN 6: +5Vdc @ 0.1A PIN 7: -SENSE PIN 8: +SENSE MATING CONNECTORS: J1: MOLEX 09-50-3031, PINS: 08-52-0112 J2: MOLEX 09-50-3061, PINS: 08-52-0112 J3: AMP 1375820-2, PINS: 1375813-3 J4: MOLEX 50-37-5083, PINS: 08-70-1040 GNT200 Output Power vs. Line Voltage & Temperature 200 5 0 C w/ 2 0 0 lfm a irflo w ° 180 2 5 C c o n v e c tio n ° 160 140 120 5 0 C c o n v e c tio n 4 0 ° C c o n v e c tio n ° 100 80 60 40 20 0 100 110 1 20 130 14 0 1 50 160 17 0 1 80 190 20 0 2 10 220 23 0 2 40 In p u t Vo lts AC Data Sheet © 2011 SL Power Electronics Corp. The information and specifications contained herein are believed to be correct at the time of publication. Rev. 2-17-2011 SL Power accepts no responsibility for consequences arising from reproduction errors or inaccuracies. Specifications are subject to change without notice. ______________________________________________________________________________________________________________________________ 3 of 3 SL Power Electronics Corp • 6050 King Drive Ventura, CA 93003 • Phone 805.486.4565 • Fax 858.712.2040 • Email: info@slpower.com • www.slpower.com Power Rating (Watts)