SL POWER GPHP600-28

GPHP SERIES SINGLE OUTPUT POWER SUPPLY High Power Supplies 600/700 Watt AC/DC Universal Input Power Supply SUMMARY • 90 -264 Vac nominal input range g • Overvoltage and short circuit protection • Approved to UL, CSA and EN Standards • Power Good LED • Low Leakage The GPHP Series are universal input AC/DC power supplies with power factor correction (PFC) with up to 700 Watts ouput power. The GPHP product in corporates ‘hot-swap’ capabilities and a handle. The series is approved to EN60950 to reduce design-in time and end system compliance costs GPHP 600 shown in CRA rack O All specifications are typical at nominal input, full load at 25 C unless otherwise stated SPECIFICATIONS OUPUT SPECIFICATIONS INPUT SPECIFICATIONS Output Power Integral forced air 700 Watts max. Input Voltage range Universal input 100-240 nom (85 - 264 max) Vac Total Regulation See table Input frequency 47 Hz to 63 Hz Rise time At turn-on 2.0 s max. Input surge current 25 A max. Transient response Main output 25% 3.5% max. dev. 350 ms recovery 0.1 A/ms to 1% Ground Leakage current 264 Vac 60 Hz 160 mA Temperature Coef- +/-0.03%/oC Input current 120 Vac 8.5 A ficient 230 Vac 4.5 A Overvoltage protection 125% +/-10% Input fuse F1,F2 10.0 A Short Circuit protection block wall Yes EMC INFORMATION ENVIRONMENTAL SPECIFICATIONS o o Conducted emissions FCC Pt 15, EN55022 Level B Thermal Performance operating ambient -20 C -50 C (see ratings chart) Radiated emissions FCC Pt 15, EN55022 Level A o non-operating -40 to +85 C Line freq. harmonics EN61000-3-2 Class A o 0 - 50 C 600 Watts Voltage fluctuations EN61000-3-3 Complies (clause 5b) Convection cooled ESD Air EN61000-4-2 8 kV contact Maximum Altitude operating / non-operating 10,000 ft. / 40,000 ESD Contact EN61000-4-2 6 kV air ft. max. Relative Humidity non-condensing 5% - 95% RH Radiated immunity EN61000-4-3 3 V/m 2 Vibration (operating) 0.003 g /Hz 1.5 g 3 axes 10 Fast Transients (EFT) EN61000-4-4 2 kV 5 kHz rms min/axis Line surge immunity EN61000-4-5 1 kV diff /2 kV cm 2 Vibration (non-operating) 0.026 g /Hz 5.0 g 3 axes, 1 rms Conducted immunity EN61000-4-6 3 Vrms hr/axis Power freq. mag. field EN61000-4-8 3 A/m Shock half-sine 20 g 10 ms, 3 axes, 6 pk shocks total Voltage dip immunity EN61000-4-11 Unit will ride through without loss of output at 75% of Shock half-sine 40 g 10 ms, 3 axes, 6 pk rated load with AC power fail shocks total warning. Page 1 of 3 GENERAL SPECIFICATIONS Hold-up time 120 Vac, 60 Hz 30 ms at 600 Watts output Efficiency 120 Vac 600 W output >84 % isolation voltage input to ouput 4000 Vac input to ground 1500 Vac Switching frequency fixed 70 KHz, +/- 10 KHz Safety Approvals UL/EN/IEC 60950-1 1st Edition CSA22.2 No.60950-1-03 Maximum weight 2 kg (4.4 lbs) MODEL NUMBER Output Peak Output Features Ripple Regulation GPHP600-24 24 V 25 A 24 V 27 A Hot Swap 240 mV 3% (see note 4) GPHP600-28 28 V 21.5 A 28 V 23.5 A Hot Swap 240 mV 3% (see note 4) GPHP600-36 36 V 17 A 36 V 19 A Hot Swap 240 mV 3% (see note 4) GPHP700-48 48 V 14 A 48 V 15.6 A Hot Swap 240 mV 3% (see note 4) NOTES 1. Integral forced air cooling 2. Peak rating is for 1 minute maximum 10% duty cycle 3. Noise measurent 20 MHz Bandwidth, differential mode. Measured with scope probe directly across output terminals of the power supply. 4. Regulation includes provision for ‘droop’ sharing MECHANICAL NOTES The GPHP series is factory configured for rack mounting installation with Condor CRA series racks. Other mounting configurations and connector op- tions are available, Please contact factory. POWER CONNECTOR DIN # 41612 Type H INPUT PINS Z-32 AC Line D-30 AC Neutral Z-28, D26 GROUND OUTPUT PINS Z12, D14, Z16,D18 OUTPUT Z4, D6, Z8, D10 RETURN (COMMON) STATUS & CONTROL PINS Z20 DC POWER GOOD Z24 INHIBIT D22 AC POWER FAIL Page 2 of 3 OUTLINE AND MOUNTING DRAWING Other drawings and SolidWorks™ 3D Models are available on request. Condor DC Power Supplies Inc. 2311 Statham Parkway, Oxnard CA, 93033, USA. Phone:(805) 486 4565 Fax:(805) 487 8911 Email: condor@condordc.com GPHP600/700 RevB 11/15/05. Data Sheet © 2005 Condor DC Power Supplies Inc. The information and specifications contained in this data sheet are believed to be correct at time of publication. However, Condor accepts no responsibility for consequences arising from reproduction errors or inaccuracies. Specifications are subject to change without notice. SolidWorks is a trademark of SolidWorks Corp. Page 3 of 3