SL POWER GSM11-3AAG

SL POWER GSM11 MEDICAL SERIES SINGLE OUTPUT POWER SUPPLY GSM11 SERIES 11 Watt Medical Power Supply Measures: 2.28 x 1.78 x 0.56” Low Power Medical Power Supplies 11 Watt AC/DC Universal Input Power Supply SUMMARY • 85 - 264 Vac input range (100 - 240 Vac nominal) • Overvoltage and short circuit protection • Approved to UL, CSA and EN Standards • Class II input • RoHS Compliant (G suffix models) The GSM11 Series is an 11 W universal input AC/DC power supply in an industry leading small footprint. With the medical approvals the GSM11 is ideal for a variety of medical device applications includ- ing small single board computers, battery charging, and running small motors, pumps, and solenoids. The series, with full approval to EN60601-1 and EN60950-1 Standards, improves design-in time and reduces end system compliance costs. O All specifications are typical at nominal input, full load at 25 C unless otherwise stated SPECIFICATIONS OUPUT SPECIFICATIONS INPUT SPECIFICATIONS Output Power Natural Convection 11 Watts Input Voltage range Universal input 100-240 nom (85 - 264 max) Vac Total Regulation See table Input frequency 55 Hz +/- 10 Hz Turn on time 2.0 s max. Input surge current 35 A max. Transient response Main output 50% 5% max. dev. 1 ms recovery to 0.2 A/ms 1% Input current 120 Vac 0.23 A Temperature Coef- +/-0.03%/oC 230 Vac 0.16 A ficient Input fuse F1 1.0 A Overvoltage protection 110 - 155% Short Circuit protection Power cycling 135 % +/- 20 % EMC INFORMATION ENVIRONMENTAL SPECIFICATIONS o Conducted emissions EN55011 Level B Thermal Performance operating ambient 0-70 C (see ratings chart) Radiated emissions EN55011 Level A o non-operating -40 to +85 C Line freq. harmonics EN61000-3-2 Complies o 0 - 50 C 11 Watts Voltage fluctuations EN61000-3-3 Complies Convection cooled ESD Air EN61000-4-2 8 kV air o 50 -70 C ambient derate to 50% ESD Contact EN61000-4-2 4 kV contact Convection cooled Relative Humidity non-condensing 5% - 95% RH Radiated immunity EN61000-4-3 3 V/m Maximum Altitude operating / non-operating 10,000 ft. / 40,000 Fast Transients (EFT) EN61000-4-4 2 kV ft. max. Line surge immunity EN61000-4-5 1 kV differential Vibration 5 Hz- 500 Hz 2.5 g rms Conducted immunity EN61000-4-6 3 Vrms Shock per MIL-STD-810E 516.4 part IV Power freq. mag. field EN61000-4-8 3 A/m Voltage dip immunity EN61000-4-11 5 cycles 40 % vnom 4.0 Watts. 25 cycles 70 % vnom 11 W Specifications are subject to change without notice. It is responsibility of each customer to thoroughly test each product and part number under their unique parameters and environments to ensure a product will work properly and reliably. Click below for more details, to buy on-line or request volume pricing: (866) 588-1750 power@sager .com http://power.sager.com/sl-power-GSM11-power-supply.html http://power.sager.com SL POWER GSM11 SERIES 11 Watt Medical Power Supply Measures: 2.28 x 1.78 x 0.56” GENERAL SPECIFICATIONS Hold-up time 120 Vac, 60 Hz >31 ms at 11 Watts output Efficiency 120 Vac 11 W output 67 - 77 % isolation voltage input to ouput 4000 Vac 1500 Vac Switching frequency fixed 80 KHz, +/- 5 KHz Safety Approvals UL/EN/IEC 60601-1 CSA22.2 No.601 UL/EN/IEC 60950-1 CSA22.2 No.60950-1 Maximum weight 50 g (0.1 lbs) o MODEL NUMBER 50 C Convection RIPPLE REGULATION ADJUSTMENT Shown with opt A Connectors GSM11-3AAG 3.3 V 2.0 A 50 mV 2% +/- 5% GSM11-5AAG 5.1 V 2.2 A 50 mV 2% +/- 5% GSM11-12AAG 12 V 0.92 A 120 mV 2% +/- 5% GSM11-15AAG 15 V 0.73 A 150 mV 2% +/- 5% GSM11-24AAG 24 V 0.46 A 240 mV 2% +/- 5% GSM11-28AAG 28 V 0.39 A 280 mV 2% +/- 5% NOTES 1. Convection cooling rating is 11 Watts (7 Watts on 3.3 V unit) o o 2. When the input voltage is less than 90 Vac the operating temperature range is 0 C to 40 C. The ripple and regulation specs. may not be met. 3. Peak output rating is 15 Watts for 1 minute, 10% duty cycle. (7 Watts on 3.3 V unit) 4. Noise 0.5% RMS, 1% Pk-Pk, 20 MHz Bandwidth, differential mode. Measured with scope probe directly across output terminals of the power supply. 5. Installation data is online at www.condorpower.com GSM11 CONNECTOR OPTIONS (other options available) AC INPUT OPTION A OPTION B OPTION T 2.5 mm SPOX 0.025” Square pin locking Screw terminal block Connector MOLEX 22-43-8030 MOLEX 22-23-2031 Weco 950-T-DS/02 Part Num MOLEX 50-37-5033 MOLEX 22-01-2035 26-16 Gage Mate MOLEX 08-70-1040 MOLEX 08-50-0113 N/A Pins 18-30234-111A 18-30234-111B N/A Kit Pin 1 =neutral Pin 1 =neutral Pin 1 =neutral Pin 3 =line Pin 3 =line Pin 2 =line DC OUTPUT OPTION A OPTION B OPTION T 2.5 mm SPOX 0.025” Square pin locking Screw terminal block Connector MOLEX 22-43-8020 MOLEX 22-23-2021 Weco 950-T-DS/02 Part Num MOLEX 50-37-5023 MOLEX 22-01-2025 26-16 Gage Mate MOLEX 08-70-1040 MOLEX 08-50-0113 N/A Pins GSM11 Part Numbering Scheme GSM11-xxYYG 18-30234-112A 18-30234-112B N/A Kit xx=Volts (5,12,etc) Pin 1=+Vout Pin 1=+Vout Pin 1=+Vout YY=In-out connectors e.g. AA, TB, BA G=RoHS Compliant Pin 2 =Return Pin 2 =Return Pin 2 =Return Condor DC Power Supplies Inc. 2311 Statham Parkway, Oxnard CA, 93033, USA. Phone:(805) 486 4565 Fax:(805) 487 8911 Email: condor@condordc.com GSM11 Rev C 10/18/05. Specifications are subject to change without notice. It is responsibility of each customer to thoroughly test each product and part number under their unique parameters and environments to ensure a product will work properly and reliably. Data Sheet © 2005 Condor DC Power Supplies Inc. The information and specifications contained in this data sheet are believed to be correct at time of publication. However, Condor accepts no responsibility for consequences arising from reproduction errors or inaccuracies. Specifications are subject to change without notice. Click below for more details, to buy on-line or request volume pricing: (866) 588-1750 power@sager .com http://power.sager.com/sl-power-GSM11-power-supply.html http://power.sager.com