SL POWER MAX-504-1224

NON-STOCK ITEM; SPECIAL ORDER ONLY MAX-500 Multiple Watt Output NOT FOR NEW DESIGNS FEATURES: 3 Over 3.5 watts/in power density 80% overall efficiency VMEbus and Multibus II system compatibility Meets international safety agency requirements All outputs regulated ±1% High peak currents for motor starting System air or self-cooling options Ac automatic line selection option Option V SPECIFICATIONS: INPUT Ac Input: 90-132 Vac/180-264 Vac, 47 to 63 Hz. User selectable. Cooling: 30 cfm required to achieve full ratings. See option “A” for automatic line selection. Internally fused for 12 A. Output Isolation: Isolated from ground 50 Vdc. Inrush: Cold start ac current is less than 80 A at 115 Vac and 20 OPTIONS: A at 230 Vac. Limited by thermistor. Option “A”, Ac Auto-Range: Automatically selects proper ac Holdup Time: 16 ms minimum after removal of power, at line voltage range to enable power operation at either 115 or 230 nominal line, full load. Vac without user intervention. Efficiency: 80% typical. Brownout Protection: Holds regulation to 85 Vac or 170 Vac. Option “F”, Fan/Cover Assembly: Cover with intergal ball- OUTPUT bearing fan provides proper cooling to achieve full ratings at 50°C Adjustability: User adjustable ±5% minimum. ambient temperature. Line & Load Reg: ±1% over ac input range and 0 to 100% load change. Output #1 requires minimum load of 10%. Option “P”, Ac Power Fail: Provides TTL “0” 5 ms before Ripple & Noise: Less than 1% p-p or 100 mV, whichever is output voltage goes out of regulation band upon loss of ac power. greater. VMEbus compatible, provides 48 mA sink current capability. Not Remote Sense (Output #1): Compensates for 250 mV total line available if option “G” is selected. drop. Open sense lead protection. Temperature Coefficient: 0.02% per degree C. Option “V”, Fan/Cover Assembly: Low profile, end venting Stability: 0.1% over 8 hours after 30 minutes warm-up. cover with integral ball-bearing fan. Transient Response (Output #1): Output voltage returns to within 1% in less than 500 µs for a 50% load change. Peak AC INPUT transient does not exceed 5%. FUNCTION 115 VAC 230 VAC CONNECTOR Overload Protection: All outputs are protected against It nput SelectSn horOs pe 0.250 Male Faston overload and short circuit. Automatic recovery upon removal of Te B-1-(L) L1 in L2 ine Barrier strip #6-3 fault. Tl B1-(N) N2 eutraL. ine screws 3/8 centers Overvoltage Protection (Output #1): Protects load against Td B1-(GND)Sd afety Groun Safety Groun power supply induced overvoltage. Trip point is factory set so DC OUTPUT that output voltage cannot exceed 136% of nominal. FUNCTION LOCATION NOTES CONNECTOR Remote Inhibit: Contact closure to the negative sense line OV utput #1Tt erminal marked +Ms ain Outpu Bus bar drops output power to nominal zero. T) erminal marked COMRs tn (common #1/4-20 screw Reverse Voltage: Protected against reverse voltage up to O3 utput #2 TB2- supply current rating. T) B2-4 Rtn (common ENVIRONMENTAL O5 utput #3 TB2- Barrier strip #6-32 screws 3.8" Thermal Protection: Shuts down power supply if overheated. T) B2-4 Rs tn (common center Automatic recovery. O1 utput #4T) B2- (+ T) B2-2 (- Temperature Range: 0° to 50°C at full ratings. Derate to half power at 70°C. STATUS AND CONTROL Safety Agencies: Most models are approved to UL1950; CSA FUNCTION LOCATION NOTES CONNECTOR 22.2 #234; IEC 950 and TÜV EN60950, Class 1 SELV., CE 72/23/ R) emote SenseJe 1-1 (+SOe utput #1 Sens AMP MTA typ EEC/93/68EEC (low voltage directive). Jn 1-2 (-S) On utput #1 Sense Rt #640456-4 pi Conducted RFI: Meets FCC Part 15, Subpart J, Class A; A) c Power FailJ2 1-3 (PFR) eference to J1- header (locking EN55022 Class B; CISPR 22 Class B. Dc Power Good* I) nhibit J2 1-4(1H Short to J1- * Optional function Condor D.C. Power Supplies, Inc., 2311 Statham Parkway, Oxnard, CA 93033 800-235-5929 • 805-486-4565  FAX 805-487-8911  www.condorpower.com 82 MAX-500 Multiple Watt Output Commercial Model Power Out Output No. Output Current Total Regulation (A) M0 AX-504-1205AF 51 0 +A 5V 81 0 ± M2 AX-504-1205AP +k 12V 11 0/16 A p ± 3V-A 12 11 0 ± 4V5A .2 21 ± M0 AX-504-1212AV 51 0 +A 5V 81 0 ± 2V+k 12 11 0/16 A p ± 3V-A 12 11 0 ± 4V1A 2 21 ± M0 AX-504-1224 51 0 +A 5V 81 0 ± 2V+k 12 11 0/16 A p ± 3V-A 12 11 0 ± 4V+A 24 21 ± Note: (A) Output #1 requires minimum load of 10% MAX-500 MECHANICAL SPECIFICATIONS Dimensions: Inches Millimeters Condor D.C. Power Supplies, Inc., 2311 Statham Parkway, Oxnard, CA 93033 800-235-5929  805-486-4565  FAX 805-487-8911  www.condorpower.com 83