SL POWER MINT1022A0505I01

MINT1022 SL POWER 22 Watt Single Output Series MINT1022 SERIES 22 Watt Medical Power Supply Measures:3.50 x 2.00 x 0.67” Medical - Universal Input Power Supply • 90-264 VAC Input • Overvoltage and Short Circuit Protection • Compact Size, Low Profile 2.0” x 3.5” x 0.67” • Approved to UL, CSA and EN Standards • CE Compliant (LVD, EMC, RoHS) • Low Standby Power Loss (<0.5 W) International Safety Standard Approvals All specifications are typical at nominal input, full load at 25°C unless otherwise stated Specifications Output Specifications Environmental Specifications Output Power Natural Convection 22 Watts continuous, Thermal Performance Operating ambient 0-70° C 24 W peak for 60 sec- (see ratings chart) onds, 10% duty cycle Non-operating -40 to +85° C 0-50° C Full load. See table. Minimum Load Not required 50-70° C ambient derate to 50% Total Regulation (Line and Load) 1.5%, see table Relative Humidity Non-condensing 0-95% RH Rise Time At turn-on 100 ms max. Maximum Altitude Operating 10,000 ft./40,000 ft. max. Transient Response 50% step load, 0.2A/μs 4% max. dev., 1.5 msec /non-operating max. recovery to 0.5% Vibration 5Hz-500Hz 2.5 g rms Temperature Coefficient +/-0.03%/° C typical Shock Per MIL-STD-810E 516.4 part IV Overvoltage Protection Standard - See chart Voltage Adjustability Factory set with fixed resistors to maximize General Specifications reliability Hold-up Time 120VAC, 60Hz 15ms min. at 22W output Efficiency 120VAC, 22W output 70-80% typical depending on output voltage Input Specifications Switching Frequency Fixed 15 to 100kHz, varies with line Voltage Universal Input 90-240VAC (Nominal and load 100-240VAC) Safety Approvals Medical UL/EN/IEC 60601-1 CSA22.2 Frequency 47-63Hz No.601 Input Surge Current Thermistor limited 32A max. Maximum Weight 100 Grams (0.20 lbs) Earth leakage current 264V, 60Hz 125 μA max. (200 μA single fault) MTBF 25° C, ground benign, 300,000 hours Telcordia Input Current 120VAC 0.45A Overload and short Fully protected Cycling type power limit 230VAC 0.25A circuit protection Input Fuse F1 2.0 A SL Power Electronics Corp. • 6050 King Drive • Ventura, CA 93003 • Phone:805.486.4565 • Fax:858.712.2040 • Email:info@slpower.com • www.slpower.com Specifications are subject to change without notice. It is responsibility of each customer to thoroughly test each product and part number under their unique parameters and environments to ensure a product will work properly and reliably. Click below for more details, to buy on-line or request volume pricing: (866) 588-1750 power@sager .com http://power.sager.com/sl-power-MINT1022-power-supply.html http://power.sager.com MINT1022 SL POWER 22 Watt Single Output Series MINT1022 SERIES 22 Watt Medical Power Supply Measures:3.50 x 2.00 x 0.67” Medical - Universal Input Power Supply Medical Voltage Output Total Initial Setpoint Ripple/ OVP Model Output Current Regulation Tolerance Noise Setpoint MINT1022A0505I01 5V 4.40A +/-1.5% +/-2.5% 100mV 6.2+/-0.6V MINT1022A1205I01 12V 1.83A +/-1.5% +/-2.5% 120mV 14.1+/-1.1V MINT1022A2405I01 24V 0.92A +/-1.5% +/-2.5% 240mV 28+/-2.5V Notes 1. Other output voltages available by special order 2. Regulation from initial setpoint for 50% load change from 50% to 0% or 100% 3. Peak output rating is 24 Watts for 1 minute 4. 20MHz Bandwidth scope, differential mode. Measured with scope probe directly across output terminals of the power supply with load terminated with 0.1 μF 5. Heatsink temperatures should not be allowed to exceed 90° C 6. Installation data is online at www.slpower.com Condor Part Number Key M I N T 1 022 A 05 05 I 01 Medical Internal Standard Factory No. of Output Initial Design Output Output Input Standard Product Designation Outputs Wattage of the Product Voltage Connector Connector Configuration General Specifications (continued from p. 1) Mechanical Notes INPUT J1 MOLEX 22-43-8040 EMC Information INPUT J1 MOLEX 22-43-8040 Conducted emissions EN55011 Level B PIN 1 AC LINE Radiated emissions EN55011 Level B PIN 4 AC NEUTRAL Line freq. harmonics EN61000-3-2 Complies GROUND SOLDER HOLE ON BOARD Voltage fluctuations EN61000-3-3 Complies OUTPUT J2 MOLEX 22-43-8040 ESD Contact EN61000-4-2 6 kV contact PIN 1 OUTPUT 1 ESD Air EN61000-4-2 8 kV air PIN 2 OUTPUT 1 Radiated immunity EN61000-4-3 3 V/m PIN 3 COMMON Fast Transients (EFT) EN61000-4-4 2 kV/5 kHz PIN 4 COMMON Line surge immunity EN61000-4-5 1 kV diff /2 kV common mode MATING CONNECTOR (MOLEX) Conducted immunity EN61000-4-6 3 Vrms INPUT HOUSING 50-37-5043 CONTACTS 08-70-1040 Power freq. mag. field EN61000-4-8 3 A/m OUTPUT HOUSING 50-37-5043 CONTACTS 08-70-1040 Voltage dip immunity EN61000-4-11 Consult Factory SL Power Electronics Corp • 6050 King Drive • Ventura, CA 93003 • Phone:805.486.4565 • Fax:805.487.8911 • Email:info@slpower.com • www.slpower.com Data Sheet © 2008 SL Power Electronics Corp. The information and specifications contained in this data sheet are believed to be correct at time of publication. However, SL Power accepts no responsibility for consequences arising from reproduction errors or inaccuracies. Specifications are subject to change without notice. Rev.9/08/08 Specifications are subject to change without notice. It is responsibility of each customer to thoroughly test each product and part number under their unique parameters and environments to ensure a product will work properly and reliably. Click below for more details, to buy on-line or request volume pricing: (866) 588-1750 power@sager .com http://power.sager.com/sl-power-MINT1022-power-supply.html http://power.sager.com