SL POWER MINT2270A11976E02

MINT2270A 270W Dual Output Series Medical – Universal Input Power Supply 2 Year Warranty •270W Convection Cooled AC-DC Power Supply •Up to 90% Efficiency Typical •Natural Interleaving Technology for PFC •LLC Technology for DC Converter •Remote ON/OFF by PS-ON Signal •Approved to EN/IEC/UL60601-1 for Medical •DC-OK, AC-OK Signal Active • Compliant (LVD, RoHS) Specifications All Specifications are typical at nominal input, full load at 25°C unless otherwise stated. AC Input Turn On Time 100-240VAC +/- 10%, 47-63 Hz single phase. Less than 2 seconds under all rated load conditions. Input Current Hold-up Time 115VAC: 3.0A max. 16 ms at 270W, nominal input (120VAC). Inrush Current Overvoltage Protection The inrush at 264VAC, at a cold start, will not exceed 45A. See chart for levels, latching type Input Fuse Overload Protection T6.3A, 250VAC fuse provided on all models. Hiccup Mode Power Factor Short Circuit Protection Complies with EN61000-3-2. Hiccup Mode Efficiency Overtemperature Protection 90% typical. Provided on all models, auto-recovery. Output Power Medical Safety Standards 270W continuous. EN/IEC/UL 60601-1, CSA22.2, No. 60601.1 Ripple and Noise Isolation 1% pk-pk max., 20MHz BW, differential mode. Measured with noise Input-Output: 4000VAC, Input-Ground: 1500VAC, Output-Ground: probe directly across output terminals. 707VDC Output Voltages Earth Leakage Current See chart. 260μA typical at 264Vac, 50Hz. Total Regulation Operating Temperature See chart. 0° to 70°C, refer to derating curve. Minimum Load Storage Temperature Not required. -40 to +85°C. Transient Response Relative Humidity 500μs max. for a 50% load step, with 5mSec high load and 5mSec low 5% to 95%, non-condensing load. Enclosure Dimensions & Weight MTBF (Mean-Time-Between-Failure): 3.35”W x 7.17”L x 1.17”H. See outline drawing. 325,000 hours at 40°C operating ambient temperature. Weight: 550 grams 1 of 3 ______________________________________________________________________________________________________________________________ SL Power Electronics Corp • 6050 King Drive Ventura, CA 93003 • Phone 805.486.4565 • Fax 858.712.2040 • Email: info@slpower.com • www.slpower.com MINT2270A 270W Dual Output Series Medical – Universal Input Power Supply 2 Year Warranty Output Parameters Model Output Output Output Ripple Total OCP OVP Number No. Volts (V) Current & Noise Regulation Limit Limit MINT2270A1976E0X 1 5V 0.2A 1% 5% 1.5A 7.0V 2 24V 11.25A 1% 2% 15.5A 30.0V Note: “X” in model number as shown above is replaced by a numeral which will signify the remote on/off configuration, or other potential modifications. See model number key below. Specifications (continued) Remote ON/OFF (PS-ON): Shock On = logic high, off = logic low or open. Operating: Half-sine, 20 g , 10 ms, 3 axes, 6 shocks total pk Model suffix “01” will be in the normally OFF configuration. Model suffix Non-Operating: Half-sine, 40 g , 10 ms, 3 axes, 6 shocks total pk “02” will be in the normally “ON” configuration. AC-OK Signal Vibration 2 “High” when input voltage exceeds 68VAC, “Low” when input voltage is less Operating: 0.003 g /Hz, 1.5 g overall, 3 axes, 10 min. / axis rms 2 than 68VAC. Non-Operating: 0.026 g /Hz, 5.0 g overall, 3 axes, 1 hr. / axis rms DC-OK Signal Altitude “High” when the 24V output is within normal range. “Low” upon an Operating: -500 to 10,000 ft. MSL overvoltage, overcurrent, undervoltage, or short circuit condition, or when Non-Operating: -500 to 40,000 ft. MSL the PS-ON is disabled (“OFF”). EMI/EMC Compliance Conducted Emissions EN55011 Class B, FCC Part 15, Class B. Static Discharge Immunity EN61000-4-2, 6kV Contact Discharge, 8kV air discharge Radiated RF Immunity EN61000-4-3, 10V/m. EFT/Burst Immunity EN61000-4-4, 2kV/5kHz.. Line Surge Immunity EN61000-4-5, 1kV differential, 2kV common-mode Conducted RF Immunity EN61000-4-6, 3Vrms Power Frequency Magnetic Field Immunity EN61000-4-8, 3A/m Voltage Dip Immunity EN61000-4-11 240VAC, 0%/0.5 cycle, 40%/5cycles, 70%/25 cycles Line Frequency Harmonics EN61000-3-2, Class A Model Number Key MINT 2 270 A 19 76 E 01 01 = Standard Model, Remote ON/OFF in "OFF" configuration. 02 = Standard Model, Remote ON/OFF in "ON" configuration. 03 and higher indicates a modified model. Input Connector Output Connector Output Voltage Configuration, "19" = 5V, 24V outputs Model Configuration Output Power (Watts) # of Outputs Product Family: "M" = Medical, "I" = Internal, "NT" = New Technology 2 of 3 ______________________________________________________________________________________________________________________________ SL Power Electronics Corp • 6050 King Drive Ventura, CA 93003 • Phone 805.486.4565 • Fax 858.712.2040 • Email: info@slpower.com • www.slpower.com MINT2270A 270W Dual Output Series Medical – Universal Input Power Supply 2 Year Warranty Outline Drawing & Connector Information INPUT, OUTPUT and SIGNAL CONNECTORS: CON1 M3 Screw terminals, 7.62mm pitch PIN 1) GND PIN 2) AC NEUTRAL PIN 3) AC LINE CON2 M3 Screw terminals, 7.62mm pitch PIN 1) RTN PIN 3) 24V PIN 2) RTN PIN 4) 24V CON3 Landwin 2502P0600T PIN 1) RTN PIN 4) DC-OK PIN 2) RTN PIN 5) AC-OK PIN 3) 5V SB PIN 6) PS-ON CON4 AMP 640456-2 PIN 1) RTN PIN 2) 24V for FAN MATING CONNECTORS: CON1, 2: Wire Lugs - Barrier width = 6.62mm CON3: Landwin 2500S060, PINS: 2503T012P CON4: AMP 1375820-2, PINS: 1375913-3 Output Power Derating Curve Data Sheet © 2010 SL Power Electronics Corp. The information and specifications contained herein are believed to be correct at the time of publication. Rev. 11/2/2010 However, SL Power accepts no responsibility for consequences arising from reproduction errors or inaccuracies. Specifications are subject to change without notice. 3 of 3 ______________________________________________________________________________________________________________________________ SL Power Electronics Corp • 6050 King Drive Ventura, CA 93003 • Phone 805.486.4565 • Fax 858.712.2040 • Email: info@slpower.com • www.slpower.com