SL POWER PCI-204-1203

200 WATTS POWER FACTOR CORRECTED MULTIPLE OUTPUT PCI-200 STANDARD PCI SERIES MODEL PWR OUTPUT #1 OUTPUT #2 OUTPUT #3 OUTPUT #4 PCI 204-1203 200 +5V @ 30A* +3.3V @ 20A* +12V @ 5A** -12V @ 5A** Featuring: • Dual main outputs * Combined rating, sum of output currents of outputs #1 & #2 equals 30 A. ** Combined rating, sum of output currents of outputs #3 & #4 equals 5 A. • Flexible ratings • 5 V “Keep Alive” bias output The PCI 204 power supply series • Universal AC input provides simultaneous high currents • 0.99 typical power factor on both 5 V and 3.3 V outputs. The • Remote sense on main outputs load may be shifted between outputs. • DC power good and AC power fail For example: the PCI 204-1203 may • True remote inhibit be loaded at +5 V @ 25 A and 3.3 V • High-current bus bars @ 5 A, or 5 V @ 10 A and 3.3 V @ 20 A, or any other combination of loads within the maximum ratings. Similarly the ±12 V may be loaded in any combination not exceeding maximum ratings. The PCI series provides a single solution as system configurations proliferate, thereby reducing cycle time and cost. Condor D.C. Power Supplies, Inc., A subsidiary of SL Industries, Inc. 805-486-4565 • (800) 235-5929 Fax: (805) 487-8911 http://www.condorpower.com 200 WATTS 8.09”x 5”x 2” PCI-200 PCI-200 2.0 lbs .9 kgs Dimensions: Inches Millimeters AC INPUT (90 - 264 VAC Continuous Range) SPECIFICATIONS: FUNCTION 115 VAC 230 VAC CONNECTOR INPUT J1-17 Neutral Line 2 AMP p/n 1-60445-7 AC Input: 90 - 264 Vac continuous range, 47 to 63 Hz. Internally fused for 4 A. mates with: Power Factor: 0.99 typical at full load. Meets EN61000-3-2. Inrush: Cold start AC current limited to 16 A. at 115 Vac, 30 A. at 230 Vac. Limited by J1-15 Line Line 1 AMP p/n 1-640426-7 thermistor. Brownout Protection: Holds regulation to 85 Vac. Holdup Time: 16 ms minimum. DC OUTPUT Efficiency: 70% typical at full load nominal line. FUNCTION LOCATION NOTES CONNECTOR AC Power Fail: Provides TTL “0” 5 ms before output goes out of regulation band upon loss of input power. Output #1 Terminal marked +5 Main Output Bus bar #8-32 screw OUTPUT Terminal marked RTN RTN (com) Bus bar #8-32 screw Adjustability: + / - 5% Output #2 Terminal marked +3.3 +3.3 Output Bus bar #8-32 screw Line & Load Reg: + /- 1% over AC input range and minimum to maximum load. Output #3 J1-5 + Output AMP p/n 1-6044-7 Minimum Load: 10% on main to insure regulation of aux outputs. Ripple & Noise: Less than 1% p-p or 100 mV, which ever greater. J1-6 +/- RTN (com) mates with: Remote Sense: (Outputs #1, and #2) Compensates for 250 mv total line drop. Open sense Output #4 J1-7 - Output lead protection. Temperature Coefficient: 0.02% per degree C. Transient Response: Output voltage returns to within 1% in less than 500 µs for a STATUS AND CONTROL 25% load change. Peak transient does not exceed 3%. Overload Protection: All outputs are protected against overload and short circuit. FUNCTION LOCATION NOTES CONNECTOR Automatic recovery upon removal of fault. Remote Sense J1-1 +5 sense See above Overvoltage Protection: Output #1 protected against power supply induced overvoltage condition. Factory set to 136% maximum. Other outputs inherently voltage J1-2 +3.3 sense limited by design. J1-3 +3.3 sense rtn Remote Inhibit: Contact closure to negative sense line or a TTL “0” (open collector) J1-4 +5 sense rtn turns off DC outputs. Reverse Voltage: Protected against reversed voltage up to supply current ratings. DC Power Good J1-8 Reference to com DC Power Good: Provides TTL “0” (open collector) when output #1 above 4.6V. AC Power Fail J1-9 Reference to com Aux Output: Provides 5 V + / - 5% @ 100 ma bias output, which is present whenever power supply has input power. Inhibit J1-10 Reference to com Aux output (+) J1-11 5V aux bias ENVIRONMENTAL Thermal Protection: Shuts down power supply if heatsink temperature exceeds 82° C. Aux output (-) J1-12 5V aux bias rtn Temperature Range: 0° C to 50° C at full ratings. Safety Agencies: Approved to UL 1950; CSA 22.2 # 234 (950); TUV EN60950, Class 1 SELV; CE 72/23/EEC/93/68EEC (low voltage directive). Output Isolation: Isolated form ground 50Vdc. Conducted RFI: Meets FCC part 15, Subpart J class A, and CISPR 22 class A. Cooling: 30 CFM required to achieve full ratings. OPTIONS: Consult factory for available options. Condor D.C. Power Supplies, Inc., A subsidiary of SL Industries, Inc. 805-486-4565 • (800) 235-5929 Fax: (805) 487-8911 http://www.condorpower.com