SL POWER PCI-304-1203F

300 WATTS POWER FACTOR CORRECTED MULTIPLE OUTPUT PCI-300 Option F STANDARD PCI SERIES Featuring: MODEL PWR OUTPUT #1 OUTPUT #2 OUTPUT #3 OUTPUT #4 • Quad output PCI 304-1203 300 +5 @ 30A +12 @ 8.0A -12 @ 4.0A +3.3 @ 15.0A • Floating wide-range fourth output • Flexible ratings The PCI-304 power supply series • Universal AC input offers a combination of outputs • 0.99 typical power factor designed for systems that require • Remote sense main both high-current 5V and 3.3V out- • AC power fail puts. Outputs #2 and #3 provide ± 12 • Available with or without fan volts up to 8 amps. • Safety agency approved The series is extremely flexible, and it can be cooled using system airflow or by an integral ball-bearing fan (F option). The fourth output is fully isolated and is easily configured to your sys- tem requirements. Condor D.C. Power Supplies, Inc., A subsidiary of SL Industries, Inc. 805-486-4565 • (800) 235-5929 Fax: (805) 487-8911 http://www.condorpower.com 300 WATTS 10.23” x 5.50 x 2.19” PCI 300 PCI-300 PCI-300 with Option F 2.6 lbs 1.2 kgs 3.2 lbs 1.5 kgs Dimensions: Inches Millimeters AC INPUT (90 - 264 VAC Continuous Range) SPECIFICATIONS: FUNCTION 115 VAC 230 VAC CONNECTOR INPUT AC Input: 90 - 264 Vac continuous range, 47 to 63 Hz. Internally fused for 7 A. TB-1 (L) Line Line Barrier strip Power Factor: 0.99 typical at full load. Meets EN61000-3-2. #6-32 screw Inrush: Cold start AC current limited to 20 A. at 115 Vac, 40 A. at 230 Vac. Limited by TB-1 (N) Neutral Neutral Barrier strip thermistor. # 6-32 screw Brownout Protection: Holds regulation to 85 Vac. TB-1 (GND) Safety Ground Safety Ground Barrier strip Holdup Time: 20 ms minimum. #6-32 screw Efficiency: 70% typical at full load nominal line. AC Power Fail: Provides TTL “0” 5 ms before output goes out of regulation band upon loss of input power. DC OUTPUT OUTPUT FUNCTION LOCATION NOTES CONNECTOR Adjustability: ±5% Output #1 TB-2-1,2 (+) +5V Output Barrier strip Line & Load Reg: ± 1% over AC input range and minimum to maximum load, V1, V2, & V3. #6-32 Screw V4 : ±2% Minimum Load: 10% on main to insure regulation of aux outputs. TB-2-3,4 Rtn (Common) Barrier strip Ripple & Noise: Less than 1% p-p or 100 mV, which ever greater. #6-32 screw Remote Sense: (Outputs V1, and V4) Compensates for 500 mv total line drop. Open sense lead Output #2 TB-2-7 (+) +12V Output Barrier strip protection. #6-32 screw Temperature Coefficient: 0.02% per degree C. Transient Response: Output voltage returns to within 1% in less than 500 µs for a TB-2-8 Rtn (Common) Barrier strip 50 % load change. Peak transient does not exceed 5%. #6-32 screw Overload Protection: All outputs are protected against overload and short circuit. Output #3 TB-2-9 (-) -12V Output Barrier strip Automatic recovery upon removal of fault. #6-32 screw Overvoltage Protection: Outputs V1, V2 & V3 protected against power supply induced over TB-2-8 Rtn (Common) Barrier strip voltage condition. Factory set to 125% maximum. #6-32 screw Reverse Voltage: Protected against reversed voltage up to supply current ratings. Output #4 TB-2-5 +3.3V Output Barrier strip ENVIRONMENTAL #6-32 screw Thermal Protection: Shuts down power supply if overheated. Requires AC input to be recycled to reset. TB-2-6 Rtn Barrier strip Temperature Range: 0° C to 50° C. at full ratings. #6-32 screw Safety Agencies: Approved to UL 1950; CSA 22.2 # 234 (950); TUV EN60950, Class 1 SELV; CE 72/23/EEC/93/68EEC (low voltage directive). STATUS AND CONTROL Conducted RFI: Meets FCC part 15, Subpart J class A, and CISPR 22 class A. FUNCTION LOCATION NOTES CONNECTOR Output Isolation: Isolated form ground 50Vdc. Cooling: 30CFM required to achieve full ratings. Remote Sense J3-1 3.3v Sense Rtn Amp #640456-5* Cooling: Self-cooled by ball-bearing fan (F-option). J3-2 3.3v Sense Amp #640456-5 J3-4 +5v Sense Rtn Amp #640456-5 OPTIONS: J3-5 +5 Sense Amp #640456-5 Option F: Integral ball-bearing fan AC Power Fail J3-3 Reference to com Amp #640456-5 Consult factory for other available options. *Mates with AMP # 640440-5 with contact sockets Condor D.C. Power Supplies, Inc., A subsidiary of SL Industries, Inc. 805-486-4565 • (800) 235-5929 Fax: (805) 487-8911 http://www.condorpower.com