SL POWER PENB1020A4800F01

PENB1020A Universal 19.2W Gigabit PoE Adapter 3 Year Warranty •10/100/1000 (MbPS) Data Rates •Self-contained Injector •100-240Vac Universal Input •Green DC Power LED •Overload and Short Circuit Protection •Regulated Output with Low Ripple •Compliant to UL/IEC/EN60950-1 •LPS (Limited Power Source) Compliant •RoHS Compliant Description The PENB1020A Series of Power-over-Ethernet (PoE) adapters operate from a 90 to 264Vac input range, and provide up to 19.2W of output power at an output voltage of 48Vdc. These models are capable of operating with Gigabit Data rates, and include features include diagnostic LED, and overvoltage, overload, and short circuit protection. This non-compliant adapter does not require a “handshake” signal to enable the output voltage. Specifications All specifications are typical at nominal input, full load at 25°C unless otherwise stated AC Input 100-240Vac +/- 10%, 47-63 Hz single phase MTBF >60,000 hours, calculated (7 years) Input Current 0.5A @ 90Vac Hold-Up Time 18mS min. @ 115Vac, 60Hz 0.25A @ 180Vac 60mS min. @ 230Vac, 60Hz Input Inrush Current 60A peak, cold start Efficiency 65% minimum Input Protection Internal Primary Current Fuse provided, Turn-on Time 2.0 seconds max., at 115v230Vac, 60Hz 250Vac/3.15A Dialectric Withstand 4242Vdc Primary – Secondary, Rise Time 100mS max.@ 115/230Vac, 60Hz 2,150Vdc Primary–GND, 500Vdc Secondary - GND Earth Leakage Current <250µA @ 264Vac, 60Hz Short Circuit Protection 10 minutes max. @ 265Vac, 60Hz Output Power 19.2W continuous, convection cooled Operating Temperature 0° to +40°C Ripple and Noise See Chart below Storage Temperature -30° to +85°C Output Voltage 48Vdc Typical Relative Humidity 5% to 95%, non-condensing Altitude 0 to 10,000 ft Transient Response 0.5msec for 50% load change typical Regulation See chart below Safety Standards UL/IEC/EN60950-1, CE, CB Case Material 94V-0 Black Polycarbonate Dimensions W: 1.9” x L: 4.44” x H: 1.3”. Weight: 120g Models Max. IEEE802.3af AC Input Model Output Output Ripple Regulation Power Compliant? Receptacle & Noise¹ Number Voltage Current Line Load PENB1020A4800F01 48Vdc 0.4A 480mV pk-pk 15.4W ±2% ±5% No IEC60320, C14 PENB1020A4800N01 48Vdc 0.4A 480mV pk-pk 15.4W ±2% ±5% No IEC60320, C8 Note: 1. Measured at 20MHz bandwidth, with noise probe as close to output RJ-45 connector as possible, and load terminated with 0.1μF ceramic and 10μF low ESR electrolytic capacitors. ______________________________________________________________________________________________________________________________ 1 of 2 SL Power Electronics Corp• 6050 King Drive Ventura, CA 93003• Phone 805.486.4565• Fax 805.832.6131• Email: info@slpower.com• www.slpower.com PENB1020A Universal 19.2W PoE Gigabit 3 Year Warranty EMI/EMC Compliance Conducted Emissions EN55022: 2006+ A1:2007 (Class B) Radiated Emissions EN55022: 2006+ A1:2007 (Class B) Static Discharge Immunity EN55024/IEC61000-4-2, 6kV/8kV, Criteria A Radiated RF Immunity EN55024/IEC 61000-4-3, 3V/m, Criteria A EFT/Burst Immunity EN55024/IEC 61000-4-4, 2kV, 5kHz, Criteria A Line Surge Immunity EN55024/IEC 61000-4-5, 1kV/2kV, Criteria A Conducted RF Immunity EN55024/IEC 61000-4-6, 3V (AM 80%, 1kHz), Criteria A Power Frequency Magnetic Field Immunity EN55024/IEC 61000-4-8, 3A/m, Criteria A EN55024/IEC 61000-4-11, 100%, 10mS; 60%, 100mS; 30%, 500mS Voltage Dip Immunity Criteria A. 100$, 5000mS, Criteria B Line Harmonic Emissions EN61000-3-2: 2006 Flicker Test EN61000-3-3: 2008 Outline Drawing IEC320 C14 input receptacle shown. Other options available. Consult factory for details and availability. PSA pinout Alternative B (IEEE 802.3af 33.2.2): J1 Pins J2 Pins 1 Data Pair 1 1 Data Pair 1 2 Data Pair 1 2 Data Pair 1 3 Data Pair 2 3 Data Pair 2 4 +VDC 4 No Connection 5 +VDC 5 No Connection 6 Data Pair 2 6 Data Pair 2 7 -VDC 7 No Connection 8 -VDC 8 No Connection Data Sheet © 2014 SL Power Electronics Corp. The information and specifications contained herein are believed to be correct at the time of publication. Rev. 12/1/2014 However, SL Power accepts no responsibility for consequences arising from reproduction errors or inaccuracies. Specifications are subject to change without notice. ______________________________________________________________________________________________________________________________ 2 of 2 SL Power Electronics Corp• 6050 King Drive Ventura, CA 93003• Phone 805.486.4565• Fax 805.832.6131• Email: info@slpower.com• www.slpower.com