Instruction Sheet   408-4831 SMA Right-Angle Cable Plugs 30 AUG 11 Rev B 2. DESCRIPTION The plug connector consists of a housing subassembly and disc. See Figure 1. 3. ASSEMBLY PROCEDURE Follow safety precautions included with the tools DANGER Housing used for assembly. Disc Subassembly STOP  DESCRIPTION PART NUMBER 1. Strip the cable to the dimensions shown in  1311055-1 Figure 2. 1051156-1 2. Secure the threaded end of the housing subassembly onto the locator tool. Secure the 1311563-1 assembly in a small bench vise. 1056931-1 3. Tin the cable center conductor. 1313729-1 If using microporous cable, do not allow flux or CAUTION SMA Right-Angle Cable Plugs 1088312-1 solvent on or near the cable dielectric.  1051157-1 ! 1223286-1 4. Insert the center conductor into the housing 1313559-1 subassembly. See Figure 3, Detail A. Make sure 1313278-1 that the conductor is positioned in the slot of the contact inside the housing and the cable dielectric is 1082030-1 against the contact. See Figure 3, Detail B. Figure 1 5. Place the soldering iron on the tip of the contact, and solder. 1. INTRODUCTION 6. Solder the housing subassembly to the cable. The SMA Right-Angle Cable Plugs listed in Figure 1 Refer to Figure 4, Detail A. were designed to be soldered onto .141 or .085 semi- rigid coaxial cable, or .141 semi-rigid microporous 1.27 [.05] cable using the following tool: Jacket Dielectric 90° PART NUMBER TOOL DESCRIPTION TE CONNECTIVITY M/A-COM 1.27 / 1.524 [.05 / .06] 2098-5218-0217 Locator Tool 1055451-1 Center Conductor Note: Not to Scale (T-2367) Figure 2 Dimensions in this instruction sheet are in NOTE millimeters [with inches in brackets]. Figures are 7. Refer to Figure 4, Detail B, and install the disk not drawn to scale. onto the housing subassembly according to the i following preferred option: Reasons for reissue of this instruction sheet are Option 1 - Press the disk into the opening in the provided in Section 4, REVISION SUMMARY. housing subassembly, and secure with epoxy. Do not allow epoxy to enter the housing subassembly. Option 2 - Tin the perimeter of the opening in the housing subassembly. Do not allow solder to enter the housing subassembly. Press the disk into the opening, then apply heat to the disk. 8. Remove the locator tool. © 2011 Tyco Electronics Corporation, a TE Connectivity Ltd. Company TOOLING ASSISTANCE CENTER 1-800-722-1111 This controlled document is subject to change. 1 of 2 All Rights Reserved PRODUCT INFORMATION 1-800-522-6752 For latest revision and Regional Customer Service, *Trademark visit our website at www.te.com LOC B TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks. Other logos, product and/or Company names may be trademarks of their respective owners. 408-4831 Dielectric Detail A Solder Here Detail A Housing Subassembly Center Conductor Locator Tool Center Conductor in Slot Press Disc Here of Contact and Dielectric Against Contact Detail B Detail B Figure 4 Figure 3 4. REVISION SUMMARY Updated document to corporate requirements. Rev B 2 of 2