Automotive Relays High Current Devices High Current Relay 150 n Limiting continuous current 130A at 85°C n Current switching ability up to 300A n Suitable for voltage levels up to 24VDC n Heat, moisture and vibration resistant n Minimal contact resistance n Dustproof and sealed versions Typical applications Engine control, glow plug, heated front screen, preheating systems (e.g. for diesel engines, catalytic converters), switches for loading ramps, start/stop. F132_fcw2b Contact Data Coil Data Contact arrangement 1 form A, 1 NO Rated coil voltage 12/24VDC 1) 1 form B, 1 NC Rated coil power 3.3W 1 form C, 1 CO Max. coil temperature 155°C 1 form X, 1 NO DM 1) Rated voltage 12VDC/24VDC Coil versions, DC coil A) Max. switching voltage depends on load parameters Coil Rated Operate Release Coil Rated coil 2 Rated current, cable 25mm 130A at 85°C code voltage voltage voltage resistance power Limiting continuous current VDC VDC VDC Ω±10% W 2 23°C, load cable 16mm 130A 001 12 7.2 1.2 37 3.9 2 85°C, load cable 16mm 120A 002 24 14.4 2.4 141 4.1 2 1) With resistor. 125°C, load cable 16mm 60A 2 All figures are given for coil without preenergization, at ambient temperature +23°C. 23°C, load cable 25mm 180A 2 85°C, load cable 25mm 130A 2 125°C, load cable 25mm 70A Coil operating range ECR1449-V Limiting making current, load current max. 3s on, 300 make/break ratio 1:10 300A Limiting breaking current 300A Contact material AgSnO 2 4) Min. recommended contact load 1A at 5VDC Initial voltage drop, typ. at 100A 70mV Frequency of operation, with/without load 6 ops./min Operate/release time typ. at nominal voltage 25/8ms Electrical endurance Does not take into account form A contact (NO), resistive load, the temperature rise due to 4 cyclic temperature:+23°C >5x10 cycles at 300A, 13.5VDC the contact current 7 E = pre-energization Mechanical endurance >10 ops. A) Please contact TE relay application engineer. Does not take into account the temperature rise due to the contact current E = pre-energization Insulation Data Initial dielectric strength between contact and coil 1000VAC rms Load dump test ISO 7637-1 (12VDC), test pulse 5 Vs=+86.5VDC ISO 7637-2 (24VDC), test pulse 5 Vs=+200VDC 1 03-2014, Rev. 0314 Datasheets and product specification ac- Datasheets and product data is subject to the Datasheets, product data, ‘Definitions’ sec- www.te.com cording to IEC 61810-1 and to be used only terms of the disclaimer and all chapters of tion, application notes and all specifications © 2014 Tyco Electronics Corporation, together with the ‘Definitions’ section. the ‘Definitions’ section, available at are subject to change. a TE Connectivity Ltd. company. http://relays.te.com/definitions Automotive Relays High Current Devices High Current Relay 150 (Continued) Other Data Other Data (continued) EU RoHS/ELV compliance compliant Terminal type screw Ambient temperature -40°C to +125°C Cover retention Dry heat, IEC 60068-2-2 500h at 100°C pull force 500N Damp heat constant, push force 500N IEC 60068-2-3 (78), Ca 500h, 40°C, 93% RH Terminal retention Degree of protection pull force 150N dustproof: IP54 (IEC 60529), RT I (IEC 61810) push force 150N sealed: sealing in accordance with IEC 68 resistance to bending 20N immersion cleanable: IP67 (IEC 60529), RT III (IEC 61810) force applied to side 20N Corrosive gas torque 5Nm IEC 60068-2-42 10 days Weight approx. 220g (7.8oz) IEC 60068-2-43 10 days Packaging unit 50 pcs. 2) No change in the switching state >10µs. Vibration resistance (functional) 2) IEC 60068-2-6 (sine sweep) 10 to 200Hz >5g Shock resistance (functional) 2) IEC 60068-2-27 (half sine) 6ms >20g Drop test, free fall IEC 60068-2-32 1m onto concrete Terminal Assignment NOR COR NOBRR 1 form A, 1 NO with resistor 1 form C, 1 CO with resistor 1 form X, 1 NO DM with resistor 2 5 2 54 2 55b 1 3 1 3 1 Dimensions View of the terminals NO and NO DM version Bottom view 84 84 40 40 63 63 15.5 7.5 x 6.5 7.5 x 6.5 45 45 *) 65.2 65.2 13.5 13.5 71 71 Ø 6.5 Ø 6.5 TE1667-61 TE1666-X1 TE1666-X1 Connector Connector 17 17 *) Alternatively 5b for form X, 1 NO DM with resistor. Screw terminals M6 Screw terminals M6 2-pole 2-pole Connector Information AMP SUPERSEAL 1.5 SERIES Coil side - Receptacle connector 282080-1 - Single wire seal 281934-2 - Contact 282110-1 Load side Cable lug M6, maximum cable section 25 mm² 2 03-2014, Rev. 0314 Datasheets and product specification ac- Datasheets and product data is subject to the Datasheets, product data, ‘Definitions’ sec- www.te.com cording to IEC 61810-1 and to be used only terms of the disclaimer and all chapters of tion, application notes and all specifications © 2014 Tyco Electronics Corporation, together with the ‘Definitions’ section. the ‘Definitions’ section, available at are subject to change. a TE Connectivity Ltd. company. http://relays.te.com/definitions Automotive Relays High Current Devices High Current Relay 150 (Continued) Dimensions CO version Load terminals 2 pole tab connector Screw M6 TE AMP MCP 1.2 Max. torsion of 132CO_DD1 screw bolts: 5Nm View of the terminals Bottom view Product code structure Typical product code V23132 -A2 001 -A 2 00 Type V23132 High Current Relay 150 Contact arrangement A2 1 form A, 1 NO D2 1 form B, 1 NC B2 1 form X, 1 NO DM E2 1 form C, 1 CO Coil 001 12VDC 002 24VDC Protection class A IP54 B IP67 Contact material 2 AgSnO 2 Standard version 00 Standard Product code Arrangement Coil Circuit Coil suppr. Protect. Contact mat. Terminals Part number V23132-A2001-A200 1 form A, 1 NO 12VDC NOR Resistor IP54 AgSnO2 Screw 1393315-2 V23132-A2001-A200-EV-USBX*) 7-1414968-8*) V23132-A2001-B200 IP67 1416010-1 V23132-A2001-B200-EV-USBX*) 2-1414939-2*) V23132-B2002-A200 1 form X, 1 NO DM 24VDC NOBRR IP54 1393315-9 V23132-B2002-B200 IP67 1-1393315-1 V23132-B2002-B200-EV-USBX*) 5-1414968-1*) V23132-D2001-B200 1 form B, 1 NC 12VDC NCR on request V23132-E2001-A200 1 form C, 1 CO 12VDC COR IP54 9-1415001-5 Other types on request. This list represents the most common types and does not show all variants covered by this datasheet. *) Americas market only. 3 03-2014, Rev. 0314 Datasheets and product specification ac- Datasheets and product data is subject to the Datasheets, product data, ‘Definitions’ sec- www.te.com cording to IEC 61810-1 and to be used only terms of the disclaimer and all chapters of tion, application notes and all specifications © 2014 Tyco Electronics Corporation, together with the ‘Definitions’ section. the ‘Definitions’ section, available at are subject to change. a TE Connectivity Ltd. company. http://relays.te.com/definitions