SPECIFICATION CONTROL DRAWING 5028D5312 Date 7-15-13 50 OHM, AWG 28, 7 STRANDS OF AWG 36, TRIAXIAL CABLE CHEMINAX Revision E THIS SPECIFICATION SHEET FORMS A PART OF THE LATEST ISSUE OF RAYCHEM SPECIFICATION 1200. CONSTRUCTION DETAILS ELECTRICAL CHARACTERISTICS DIMENSIONS ARE NOMINAL VALUES IN INCHES UNLESS OTHERWISE DESIGNATED. CHARACTERISTIC IMPEDANCE 50 ± 2 ohms, Method A CAPACITANCE 27.8 pF/ft. (nominal) CONDUCTOR 28.3 pF/ft. (maximum) .0150 AWG 28, 7 Strands of VELOCITY OF PROPAGATION 73% (nominal) AWG 36, Silver-Coated Copper ATTENUATION 92.0 dB/100 ft. (maximum) at 4 GHz DIELECTRIC ADDITIONAL REQUIREMENTS .039 Rayfoam L ± .003 Color - Natural ELECTRICAL CONDUCTOR RESISTANCE 62.0 ohms/1000 ft. (nominal) st INSULATION RESISTANCE 10,000 megohms (minimum) 1 SHIELD CONDUCTOR TO SHIELD for 1000 ft. .052 AWG 40, Silver-Coated Copper JACKET FLAWS SPARK TEST 1.0 kV (rms) IMPULSE TEST 6.0 kV (peak) VOLTAGE WITHSTAND st 1 JACKET CONDUCTOR TO SHIELD 750 volts (rms) (minimum) .072 Thermorad F SHIELD TO SHIELD 500 volts (rms) (minimum) Color - White ENVIRONMENTAL FLAMMABILITY Method C nd 2 SHIELD HEAT SHOCK 225°C .085 AWG 40, LOW TEMPERATURE-COLD BEND -55°C/3.00 inch mandrel Silver-Coated Copper VOLTAGE WITHSTAND 1000 volts (rms), 1 minute (Post Environmental) PHYSICAL INSULATION (DIELECTRIC) ELONGATION 50% (minimum) nd 2 JACKET 2 TENSILE STRENGTH 1000 lbf/in (minimum) .105 Thermorad F (nominal) JACKET (EACH) .110 ELONGATION 100% (minimum) 2 (maximum) TENSILE STRENGTH 2000 lbf/in (minimum) JACKET THICKNESS (EACH) .008 inch (minimum) .010 inch (nominal) SHIELD COVERAGE (EACH) 90% (minimum) Outer jacket color will be white (designated by a “-9)" appended to the part number, e.g. 5028D5312-9) unless otherwise specified. Designate outer jacket color with a dash number in accordance with MIL-STD-681. Other codes and suffixes may be added to the part number, as necessary, to capture any additional requirements imposed by the purchase order. WEIGHT 8.8 lbs/1000 ft. (nominal) Users should evaluate the suitability of this product for their application. Specifications are subject to change without notice. Tyco Electronics Corporation also reserves the right to make changes in materials or processing, which do not affect compliance with any specification, without notification to Buyer. Page 1 of 1 Rayfoam, Thermorad, Cheminax, Raychem, TE Connectivity, TE connectivity (logo) and TE (logo) are trademarks. Raychem Wire & Cable THIS SPECIFICATION SHEET TAKES PRECEDENCE OVER DOCUMENTS 501 Oakside Avenue REFERENCED HEREIN. REFERENCED DOCUMENTS SHALL BE OF THE Redwood City, California 94063-3800 ISSUE IN EFFECT ON DATE OF INVITATION FOR BID. 1-800-227-8816 Fax: 1-650-361-6297 © 2013 Tyco Electronics Corporation, All rights reserved.