9530F5214 SPECIFICATION CONTROL DRAWING Date: 10-2-06 95 OHM, AWG 30, 7 STRANDS OF AWG 38, Revision: CHEMINAX TRIAXIAL CABLE, OUTER SPACE USE E THIS SPECIFICATION SHEET FORMS A PART OF THE LATEST ISSUE OF RAYCHEM SPECIFICATION 1200. CONSTRUCTION DETAILS ELECTRICAL CHARACTERISTICS DIMENSIONS ARE NOMINAL VALUES IN INCHES UNLESS OTHERWISE DESIGNATED. CHARACTERISTIC IMPEDANCE 95 ± 5 ohms, Method B CAPACITANCE 13.7 pF/ft. (nominal) at 1 kHz CONDUCTOR VELOCITY OF PROPAGATION 78% (nominal) AWG 30, 7 Strands of .012 AWG 38, Silver-Coated High Strength Copper Alloy DIELECTRIC ® Rayfoam L .081 Color - Natural ADDITIONAL REQUIREMENTS ELECTRICAL CONDUCTOR RESISTANCE 116. ohms/1000 ft. (nominal) 1ST SHIELD INSULATION RESISTANCE 10,000 megohms (minimum) AWG 40, .094 (CONDUCTOR TO SHIELD) for 1000 ft. Tin-Coated Copper JACKET FLAWS SPARK TEST 1.0 kV (rms) IMPULSE TEST 6.0 kV (peak) VOLTAGE WITHSTAND (DIELECTRIC) 1ST JACKET CONDUCTOR TO SHIELD 1000 volts (rms) (minimum) .110 Radiation-Crosslinked, SHIELD TO SHIELD 500 volts (rms) (minimum) Modified PVF 2 Color - White ENVIRONMENTAL FLAMMABILITY Method B HEAT SHOCK 225°C 2ND SHIELD LOW TEMPERATURE- -55°C/3.75 inch mandrel .123 AWG 40, COLD BEND Tin-Coated Copper VOLTAGE WITHSTAND 1000 volts (rms), for 1 minute (POST ENVIRONMENTAL) OUTER SPACE REQUIREMENTS RADIATION RESISTANCE 500 megarads/4.25 inch mandrel VACUUM STABILITY TOTAL MASS LOSS (TML) 1.0% (maximum) VOLATILE CONDENSABLE 0.1% (maximum) MATERIAL (VCM) 2ND JACKET .139 Radiation-Crosslinked, Modified PVF 2 PHYSICAL INSULATION (DIELECTRIC) ELONGATION 50% (minimum) TENSILE STRENGTH 800 lbf/in² (minimum) JACKET (EACH) ELONGATION 200% (minimum) TENSILE STRENGTH 4000 lbf/in² (minimum) JACKET THICKNESS (EACH) .008 inch (nominal) Outer jacket color will be white (designated by a "-9" appended to SHIELD COVERAGE (EACH) 90% (minimum) the part number, e.g. 9530F5214-9) unless otherwise specified. Designate outer jacket color with a dash number in accordance with MIL-STD-681. Other codes and suffixes may be added to the part number, as necessary, to capture any additional requirements WEIGHT 14.9 lbs/1000 ft. (nominal) imposed by the purchase order. Users should evaluate the suitability of this product for their application. Specifications are subject to change without notice. Tyco Electronics also reserves the right to make changes in materials or processing, which do not affect compliance with any specification, without notification to Buyer. 501 Oakside Avenue THIS SPECIFICATION SHEET TAKES PRECEDENCE OVER DOCUMENTS REFERENCED HEREIN. R Redwood City, California 94063-3800 REFERENCED DOCUMENTS SHALL BE OF THE ISSUE IN EFFECT ON DATE OF INVITATION FOR BID. Wire & Cable 1-800-227-8816 Fax: 1-650-361-6297 © 2006 Tyco Electronics Corporation. All rights reserved.