TRACO POWER TSH0512D

DC/DC Converters TSH Series, 2 Watt Features ◆ Ultra compact SMD package (SOIC-14/18) ◆ Isolated single and dual output models ◆ I/O isolation 1‘000 VDC ◆ High efficiency up to 82% ◆ Operating temperature –40°C to +85°C ◆ Reflow solder temperature up to 245°C ◆ High accuracy of pin Co-planarity ◆ Available in tape and reel package ◆ Lead free design, RoHS compliant ◆ 3–year product warranty The TSH series are ultra miniature, isolated 2 Watt DC/DC-converters in SMD pack- age. The devices can be soldered without any problems in a high temperature lead 2 free solder process. Requiring only 1.5 cm board space they offer the ideal solution in many space critical applications. These converters are the ideal solution for point of load power conversion, ground loop elimination, noise reduction and digital interface applications. Models Ordercode Input voltage Output voltage Output current max. Efficiency typ. TSH 0505S 5 VDC 400 mA 77 % TSH 0512S 12 VDC 165 mA 81 % TSH 0505D 5 VDC ±10% ±5 VDC ±200 mA 77 % TSH 0512D ±12 VDC ±80 mA 79 % TSH 0515D ±15 VDC ±65 mA 79 % TSH 1205S 5 VDC 400 mA 78 % TSH 1212S 12 VDC 165 mA 82 % 12 VDC ±10% TSH 1212D ±12 VDC ±80 mA 82 % TSH 1215D ±15 VDC ±65 mA 82 % TSH 2405S 5 VDC 400 mA 78 % TSH 2412S 12 VDC 165 mA 81 % 24 VDC ±10% TSH 2412D ±12 VDC ±80 mA 81 % TSH 2415D ±15 VDC ±65 mA 82 % http://www.tracopower.com Page 1 of 4 not recommended for new design in DC/DC Converters TSH Series 2 Watt Input Specifications Input current no load / full load 5 Vin models: 60 mA / 500 mA typ. 12 Vin models: 30 mA / 200 mA typ. 24 Vin models: 15 mA / 100 mA typ. Surge voltage (1 sec. max.) 5 Vin models: 9 V max. 12 Vin models: 18 V max. 24 Vin models: 30 V max. Reverse polarity protection 0.3 A max. Reflected input ripple current can be reduced by ext. 1–3.3 µF polyester film capacitor Input filter internal capacitors Output Specifications Voltage set accuracy ±4 % max. Voltage balance (dual output models) 1 % max. Regulation – Input variation 1.2 % / 1% change Vin – Load variation 20 – 100 % 10 % max. Ripple and noise (20 MHz Bandwidth) 75 mV pk-pk max. Temperature coefficient ± 0.02 %/K Short circuit protection limited 1 sec. max. Capacitive load 5 VDC single output models: 47 µF max. 5 VDC dual output model: 10 µF max. 12 VDC single output models: 10 µF max. 12/15 VDC dual output models: 4.7 µF max. General Specifications Temperature ranges – Operating –40°C to +85°C (no derating) – Case temperature +95°C max. – Storage –55°C to +125°C Humidity (non condensing) 95 % rel H max. Reliability, calculated MTTF (MIL-HDBK-217F, @+25°C, ground benign) >2’000’000 h Isolation voltage (60 sec.) – Input/Output 1‘000 VDC Isolation capacitance – Input/Output 60 pF typ. Isolation resistance – Input/Output >1‘000 Mohm (at 500VDC) Switching frequency 100 kHz typ. (frequency modulation) Frequency change over line and load ±30 % max. Physical Specifications Casing material non conductive black plastic (UL 94-V0 rated) Package weight single output models: 1.5 g (0.08 oz) dual output models: 2.2 g (0.05 oz) Lead-free reflow solder process as per IPC/JEDEC J-STD-020C peak temp. 245°C (20 sec. max.) All specifications valid at nominal input voltage, full load and +25°C after warm-up time unless otherwise stated. http://www.tracopower.com Page 2 of 4 DC/DC Converters TSH Series 2 Watt Outline Dimensions Single Output Models S 0-4˚ 8.6 (0.34) 2.54 2.54 5.08 Pin-Out (0.10) (0.10) (0.10) 10.0 (0.39) 0.15 12.7 (0.50) 11.8 (0.46) Pin Single 1 –Vin (GND) 0.6 (0.02) 3 +Vin (Vcc) 1.2 7 –Vout 14 8 (0.05) 8 +Vout Top fiew 14 Ntc. Ntc. = not to connect 1 3 7 2.54 2.54 5.08 (0.10) (0.10) (0.10) Dual Output Models S Pin-Out 2.6 2.54 5.08 2.54 0-4˚ 8.6 (0.34) (0.11) (0.10) (0.10) (0.10) 0.15 Pin Dual 10.0 (0.39) 15.3 (0.6) 11.8 (0.46) 1 –Vin (GND) 3 +Vin (Vcc) 0.6 7 Common 9 –Vout 18 12 1.2 (0.05) 12 +Vout Top fiew Ntc. 18 Ntc. = not to connect 1 3 7 9 2.54 2.54 5.08 2.54 (0.10) (0.10) (0.10) (0.10) Dimensions in [mm], () = Inches Tolerances ±0.25 (±0.01), pins ±0.05 (±0.002) http://www.tracopower.com Page 3 of 4 0.25 9.3 (0.01) 8.9 (0.35) (0.37) 0.25 9.3 (0.01) 8.9 (0.35) (0.37) 12.7 (0.50) 12.7 (0.50) 1.8 (0.07) 1.8 (0.07) DC/DC Converters TSH Series 2 Watt Packaging: Single Output Models Standard Packaging - Tube { 14.2 175.0 2.0 10.2 - 1 Tube contains 10 converters R0.7 7.0 3.6 29.1 2.2 Optional Packaging - Tape & Reel - Specifications according IEC 286-3 - 1 Reel contains 300 Converters - Use appendix «-TR» on order code 0.5 { 0.05 3.5 4.0 A 2.0 B B 20.0 A 9.5 SECTION A-A 10 SECTION B-B 1.5 8.5 2.0 9.55 12.55 Dimensions in [mm], Tolerance ±0.1mm http://www.tracopower.com Page 4 of 4 +0.1 -0 1.5 { 24.0 0.03 1.75 11.5 0.6 3.7 2.9 0.8 9.7 3.5 10.5 50 1.7 13.0 6.3 330.0 99.1 13.45 0.25 DC/DC Converters TSH Series 2 Watt Packaging: Dual Output Models Standard Packaging - Tube 14.2 175.0 { 2.0 10.2 1 Tube contains 10 Converters R0.7 7.0 3.6 37.0 2.2 Optional Packaging - Tape & Reel - Specifications according IEC 286-3 - 1 Reel contains 300 Converters - Use appendix «-TR» on order code 0.5 { 0.05 2.0 4.0 A B B 20.0 9.5 A M SECTION A-A 50 10 8.55 1.5 9.55 SECTION B-B 2.0 partial enlargement M: 12.55 Specifications can be changed any time without notice. Dimensions in [mm], Tolerance ±0.1mm Rev. 12/10 Jenatschstrasse 1 · CH-8002 Zurich · Switzerland Tel. +41 43 311 45 11 · Fax +41 43 311 45 45 · info@traco.ch · www.tracopower.com Page 5 of 4 +0.1 -0 R0. 5 7 1.5 28.5 1.75 14.2 0.2 0.6 3.7 2.9 { 32.0 0.3 0.8 9.7 3.5 10.5 50 1.7 1.7 15.5 4.45 330.0 99.1 13.45 0.25 10