TRACO POWER TSR3-24150

TRACO POWER DC/DC Converters TSR3 SERIES 3 Watt Non-Isolated / POL DC-DC Converter TSR-3 Series, 3 A Measures: 0.61 x 0.41 x 0.24” Features ◆ High performance 3 Amp. switching regulator ◆ Suitable for positive & negative output circuit ◆ High efficiency up to 95 % ◆ Adjustable output voltages ◆ Wide input voltage ranges 2.5–5.5, 4.5–14 and 10–30 VDC ◆ Over-temperature protection ◆ Short circuit protection ◆ Remote On/Off input ◆ Low output ripple & noise The TSR 3 models are non isolated step down switching regulators. Since production ◆ 3-year product warranty May 2013 they can also be operated with negative output voltage. They come in a very compact open frame package of 15.5 x 9.4 x 6.2mm. The high efficiency of up to 95% admits a full load operation up to 50°C and up to 85°C with 50% current reduction. A low standby current, a very wider input range and no requirement for heatsink give these switching regulators a significant advantage over linear regulators. Togther with a remote On/Off input and protection against short circuit and over temperature the TSR 3 Series models are ideal point of load regulators for high reli- able and energy critical applications. Models Order code * Input voltage range Output voltage Output current max. Efficiency typ. 6) adjustable Positive output circuit 1) TSR 3-0533 2.5 – 5,5 VDC 0.6 – 3.3 VDC 95 % at 2.5 VDC 2) TSR 3-1250 4.5 – 14 VDC 0.59 – 6.0 VDC 93 % at 3.3 VDC 3 A 3) TSR 3-2450 10 – 30 VDC 3.0 – 6.0 VDC 91 % at 5.0 VDC 3) TSR 3-24150 10 – 30 VDC 5.0 – 15 VDC 95 % at 12 VDC Negative output circuit 1.5 A at |Vout| >3.3 VDC TSR 3-1250 4.7 – 13 VDC 4) -0.59 – -6.0 VDC 90 % at -3.3 VDC 2.2 A at |Vout| <3.3 VDC 5) TSR 3-2450 10 – 27 VDC -3.0 – -6.0 VDC 2.2 A 90 % at -5.0 VDC 5) TSR 3-24150 10 – 25 VDC -5.0 – -15 VDC 1.2 A 91 % at -12 VDC * Suffix A for models with angular pins (see dimensions), availability on demand, no stocking item. 1) input voltage must be at least 0.5 V higher than output voltage 2) input voltage must be at least 2.0 V higher than output voltage, max. 9 VDC if output is <0.9 VDC 3) input voltage must be at least 3.0 V higher than output voltage 4) max. input voltage = 14-|Vout| 5) max. input voltage = 30-|Vout| 6) open trim input = min. output voltage Specifications are subject to change without notice. It is responsibility of each customer to thoroughly test each product and part number under their unique parameters and environments to ensure a product will work properly and reliably. http://www.tracopower.com Page 1 of 3 Click below for more details, to buy on-line or request volume pricing: (866) 588-1750 power@sager .com http://power.sager.com/traco-power-TSR3-dc-dc-converter.html h t t p: / / pow e r. sa ge r. c om TRACO POWER TSR3 SERIES DC/ 3 W Datt Non-Isolated / POL DC C Converters-DC Converter TSR-3 Series 3 A Measures: 0.61 x 0.41 x 0.24” Input Specifications Maximum input current (@ Vin min. and 3 A output current) TSR 3-0533: 3.0 A TSR 3-1250: 2.6 A TSR 3-2450: 2.2 A TSR 3-24150: 3.0 A No load input current positive output circuit 25 mA typ. – negative output circuit 35 mA typ., 60 mA typ. for TSR 3-24150 – Reflected ripple current positive output circuit TSR 3-0533 and TSR 3-1250: 30 mA typ. – TSR 3-2450 & TSR 3-24150: 30 mA typ. with ext. filter, see fig. 1 page 3 – negative output circuit all models: 30 mA typ. with ext. filter, see fig. 2 page 3 Input filter internal capacitors Output Specifications Voltage set accuracy ±2 % (at full load) Output voltage adjustment see application note page 3 Regulation – Input variation >2.5 Vout: 0.2 %, <2.5 Vout: 5 mV – Load variation 0 – 100 % >2.5 Vout: 0.8 %, <2.5 Vout: 20 mV – Load variation 10 – 90 % >2.5 Vout: 0.6 %, <2.5 Vout: 15 mV Temperature coefficient ±0.015 %/°C max. Overshoot startup voltage 1.0 % max. Minimum load not required Ripple and noise (20 MHz Bandwidth) TSR 3-0533: 30 mVp-p TSR 3-1250: 60 mVp-p TSR 3-2450: 75 mVp-p TSR 3-24150: 150 mVp-p Dynamic load response 50 % load change (upper half) 150 mV max. peak variation (250 mV max. for TSR 3-24150) 250 µS max. response time Startup rise time 10 % to 90 % Vout TSR 3-0533 & TSR 3-1250: 7 mS TSR 3-2450 & TSR 3-24150: 10 mS Short circuit protection indefinite, automatic recovery Current limitation TSR 3-0533: 280 % typ. other models: 220 % typ. Capacitive load – ESR > 1 mOhm TSR 3-24150: 500 µF max. other models: 1000 µF max. – ESR > 10 mOhm TSR 3-24150: 1200 µF max. other models: 3000 µF max. General Specifications Temperature ranges – Operating (natural convection cooling 20 LFM) –40°C to +85°C – Storage –55°C to +125°C Derating 1.5 %/K above +50°C Thermal shock acc. MIL-STD-810F Humidity (non condensing) 95 % rel H max. Reliability, calculated MTBF (MIL-HDBK-217F, at +25°C, ground benign) >1’630’000 h Isolation voltage none Switching frequency TSR 3-0533 & TSR 3-1250: 600 kHz typ. TSR 3-2450 & TSR 3-24150: 300 kHz typ. Remote On/Off – On TSR 3-0533: open or Vin (pin 1 ref. to GND) other models: open or 1 to 12 VDC – Off 0 to 0.3 VDC – Off idle current: TSR 3-0533 & TSR 3-1250: 1.5 mA typ. TSR 3-2450 & TSR 3-24150: 6 mA typ. Environmental compliance – Reach www.tracopower.com/overview/tsr3 – RoHS RoHS directive 2011/65/EU All specifications valid at nominal input voltage, full load and +25°C after warm-up time unless otherwise stated. http://www.tracopower.com Page 2 of 3 Specifications are subject to change without notice. It is responsibility of each customer to thoroughly test each product and part number under their unique parameters and environments to ensure a product will work properly and reliably. Click below for more details, to buy on-line or request volume pricing: (866) 588-1750 power@sager .com http://power.sager.com/traco-power-TSR3-dc-dc-converter.html h t t p: / / pow e r. sa ge r. c om TRACO POWER TSR3 SERIES DC/ 3 W Datt Non-Isolated / POL DC C Converters-DC Converter TSR-3 Series 3 A Measures: 0.61 x 0.41 x 0.24” Applications notes Input filter to reduce reflected ripple current fig. 1 fig. 2 Positive output circuit Negative output circuit L1 GND + + 24 Input TSR 3 C1 C2 Output Input 3 GND + 24 TSR 3 GND GND C1 C2 Output 3 C1 = 220 µF, ESR <0.1 Ohm C2 = 150 µF L1 = 8.2 µH C1, C2 =10 µF, MLCC Output voltage adjustment (for negative and positive circuit) Model R trim [KOhm] 1/16 W 4 TSR 3-0533 1.2/(|Vout| -0.6)-0.01 TSR 3 TSR 3-1250 1.18/(|Vout| -0.59) 5 Load TSR 3-2450 11.2/(|Vout| -3) 3 Rtrim TSR 3-24150 8.4/(|Vout| -5) (|Vout| = absolute value) Outline Dimensions Standard version Angular Pin version (optional) W 6.0 6.2 (0.24) (0.25) Pin-Out positive negative 1 Remote On/Off 2 +Vin (Vcc) 3 GND –Vout 4 +Vout GND 5 Trim 5.1 5S 1 quare pins 0.64 x 0.64 (0.20) (0.025 x 0.025) 4 x 1.70 3.7 (0.14) (4 x 0.06) TSR 3-0533 & TSR 3-1250: W=9.4 (0.37) H=15.5 (0.61) TSR 3-2450 & TSR 3-24150: W=10.4 (0.41) H=16.5 (0.65) Weight TSR 3-0533 & TSR 3-1250: 1.7 g Dimensions in [mm], () = Inch TSR 3-2450 & TSR 3-24150: 2.1 g Pin pitch tolerances: ±0.25 (±0.01) Pin profile tolerance: ±0.1 (±0.004) Other tolerances: ±0.5 (±0.02) Specifications can be changed without notice! Make sure you are using the latest documentation, downloadable at www.tracopower.com Rev. February 23. 2015 www.tracopower.com Page 3 of 3 Specifications are subject to change without notice. It is responsibility of each customer to thoroughly test each product and part number under their unique parameters and environments to ensure a product will work properly and reliably. Click below for more details, to buy on-line or request volume pricing: (866) 588-1750 power@sager .com http://power.sager.com/traco-power-TSR3-dc-dc-converter.html h t t p: / / pow e r. sa ge r. c om 3.3 H (0.13)