OP508F, OP509 Series OP509 OP508 Features:  Flat lensed for wide acceptance angle (OP508F)  Lensed for high sensitivity (OP509)  Easily stackable on 0.100” (2.54 mm) hole centers  Inexpensive plastic package  Mechanically and spectrally matched to OP168 and OP268 series of infrared emitting diodes Description: Each device in the OP508F series consists of a NPN silicon phototransistor mounted in a flat, black plastic “end-looking” package. The flat sensing surface allows an acceptance half-angle of 60° when measured from the optical axis to the half power point. Each device in the OP509 series consists of a NPN silicon phototransistor mounted in a lensed, clear plastic “end-looking” package. The lensing effect of the package allows an acceptance half-angle of 25° when measured from the optical axis to the half power point. OP508F and OP509 series devices can be mounted on 0.100” (2.54 mm) hole centers, which makes them an ideal low-cost alternate to hermetic OP600 sensors. OP508F and OP509 series devices are mechanically and spectrally matched to the OP168F and OP268F series of infrared emitting diodes. Please refer to Application Bulletins 208 and 210 for additional design information and reliability (degradation) data. For custom versions of the OP508F, OP509 and OP538F series devices please contact your OPTEK representative. Applications:  Applications requiring a wide acceptance angle  Applications requiring high sensitivity Ordering Information  Space-limited applications Part Viewing Lead Number Sensor Angle Length OP508FA 120° OP508FC OP509A Phototransistor 0.50" OP509B 50° OP509C RoHS General Note OPTEK Technology, Inc. TT Electronics reserves the right to make changes in product specification without 1645 Wallace Drive, Carrollton, TX 75006|Ph: +1 972 323 2200 notice or liability. All information is subject to TT Electronics’ own data and is www.optekinc.com | www.ttelectronics.com considered accurate at time of going to print. Issue A 08/2016 Page 1 © TT electronics plc OP508F, OP509 Series OP508F (A, C) [MILLIM DIMENSIONS ARE IN: INCHES OP509 (A, B) [MILLIMET DIMENSIONS ARE IN: INCHES OP508F & OP509 OP538 1 1 Pin # Transistor 1 Collector 2 Emitter 2 2 General Note OPTEK Technology, Inc. TT Electronics reserves the right to make changes in product specification without 1645 Wallace Drive, Carrollton, TX 75006|Ph: +1 972 323 2200 notice or liability. All information is subject to TT Electronics’ own data and is www.optekinc.com | www.ttelectronics.com considered accurate at time of going to print. Issue A 08/2016 Page 2 © TT electronics plc OP508F, OP509 Series Electrical Specifications Absolute Maximum Ratings (T = 25° C unless otherwise noted) A o o Storage and Operating Temperature Range -40 C to +100 C Collector-Emitter Voltage 30 V Emitter-Collector Voltage 5 V (1) Lead Soldering Temperature [1/16 inch (1.6 mm) from case for 5 seconds with soldering iron] 260° C (2) Power Dissipation 100 mW Electrical Characteristics (T = 25° C unless otherwise noted) A SYMBOL PARAMETER MIN TYP MAX UNITS TEST CONDITIONS On-State Collector Current 20.00 OP509A (Dome Lens) 5.70 - - I OP508FA (Flat Lens) 2.70 - C(ON) 2 (3 ) 10.60 mA V = 5.0 V, E = 5 mW/cm CE E OP509B (Dome Lens) 1.40 - - OP508FC (Flat Lens) 0.34 - 2(3) V = 5 V.0, E = 1.0 mW/cm λ = 890 CE E , I /∆ T Relative I Charge with Temperature - 1.00 - %/°C C C nm Collector-Dark Current I OP508F & OP509 - - 100 CEO (4) nA V = 10.0 V, E = 0 CE E OP538F - - 225 Collector-Emitter Breakdown Voltage V (BR)CEO OP508F & OP509 30 - - V I = 1.00 mA, E = 0 C E V Emitter-Collector Breakdown Voltage 5 - - V I = 100 µA (BR)ECO E Collector-Emitter Saturation Voltage 2 (3 ) - - 0.4 V I = 300 µA, E = 5 mW/cm C E OP508F V CE(SAT) 2 (3 ) - - 0.4 V I = 250 µA, E = 5 mW/cm C E OP509 Notes: 1. RMA flux is recommended. Duration can be extended to 10 seconds maximum when flow soldering. A maximum 20 grams force may be applied to the leads when soldering. 2. Derate linearly 1.33 mW/° C above 25° C. 3. Light source is an unfiltered GaAs or GaAlAs LED with a peak emission wavelength of 935 or 890 nm and a radiometric intensity level which varies less than 10% over the entire lens surface of the phototransistor being tested. (0.040 T - 3.4) 4. To calculate typical collector dark current in µA, use the formula I =10 , where T is ambient temperature in °C. CEO A A General Note OPTEK Technology, Inc. TT Electronics reserves the right to make changes in product specification without 1645 Wallace Drive, Carrollton, TX 75006|Ph: +1 972 323 2200 notice or liability. All information is subject to TT Electronics’ own data and is www.optekinc.com | www.ttelectronics.com considered accurate at time of going to print. Issue A 08/2016 Page 3 © TT electronics plc OP508F, OP509 Series Performance OP508FA, OP508FC, OP508FD General Note OPTEK Technology, Inc. TT Electronics reserves the right to make changes in product specification without 1645 Wallace Drive, Carrollton, TX 75006|Ph: +1 972 323 2200 notice or liability. All information is subject to TT Electronics’ own data and is www.optekinc.com | www.ttelectronics.com considered accurate at time of going to print. Issue A 08/2016 Page 4 © TT electronics plc OP508F, OP509 Series Performance OP509A, OP509B, OP509D General Note OPTEK Technology, Inc. TT Electronics reserves the right to make changes in product specification without 1645 Wallace Drive, Carrollton, TX 75006|Ph: +1 972 323 2200 notice or liability. All information is subject to TT Electronics’ own data and is www.optekinc.com | www.ttelectronics.com considered accurate at time of going to print. Issue A 08/2016 Page 5 © TT electronics plc OP508F, OP509 Series Issue Change Description Approval Date Used PDFs from PDF Catalog to write new data sheet. June 1996 Wrote data sheet using above PDFs and information from some 04/04/06 A unreleased Publisher files (see USED folder). Transferred to new TT Electronics template. 8/2016 General Note OPTEK Technology, Inc. TT Electronics reserves the right to make changes in product specification without 1645 Wallace Drive, Carrollton, TX 75006|Ph: +1 972 323 2200 notice or liability. All information is subject to TT Electronics’ own data and is www.optekinc.com | www.ttelectronics.com considered accurate at time of going to print. Issue A 08/2016 Page 6 © TT electronics plc