CRYDOM LS240D12

PCB Mount DataSheet LS Series • SIP SSR • Ratings to 12A @ 280 VAC • SCR output for heavy industrial loads • DC control • Zero Voltage Turn-on (resistive loads) or Instantenous Turn-on (inductive loads) output PRODUCT SELECTION Control Voltage 8A 12A 4-10 VDC LS240D8 LS240D12 20-28 VDC LSE240D8 LSE240D12 AVAILABLE OPTIONS Operational Current Operational Voltage 8: 8 Amps 240: 24-280 VAC 12: 12 Amps Series LS E 240 D 12 R Control Voltage Control Input Voltage Switching Type Blank: 4-10 VDC D: DC Input Blank: Zero Voltage Turn-On E: 20-28 VDC R: Instantaneous Turn-On Required for valid part number For options only and not required for valid part number (1) OUTPUT SPECIFICATIONS Description LS240D8 LS240D12 Operating Voltage (47-63Hz) [Vrms] 24-280 24-280 Transient Overvoltage [Vpk] 600 600 Maximum Off-State Leakage Current @ Rated Voltage [mArms] 0.1 0.1 Minimum Off-State dv/dt @ Maximum Rated Voltage [V/µsec] (2) 500 500 Maximum Load Current [Arms](3) 8 12 Minimum Load Current [Arms] 0.15 0.15 Maximum Surge Current (16.6ms)[Apk] 80 120 Maximum On-State Voltage Drop @ Rated Current [Vpk] 1.6 1.6 Thermal Resistance Junction to Case (Rjc) [°C/W] 2.2 2.0 Minimum Power Factor (with Maximum Load) 0.5 0.5 FDE-07-01 REV. A Do not forget to visit us at: www.crydom.com Copyright © 2017 Crydom Inc. Specifications subject to change without notice. PCB Mount DataSheet (1) INPUT SPECIFICATIONS Description LS LSE Control Voltage Range 4-10 VDC 20-28 VDC Must Turn On Voltage 4.0 VDC 20 VDC Must Turn Off Voltage 1.0 VDC 1.0 VDC Typical Input Current @ Nominal Voltage 15 mA 15 mA Nominal Input Impedance 270 Ohm 1500 Ohm Maximum Turn-on Time [msec] 1/2 Cycle 1/2 Cycle 1/2 Cycle Maximum Turn-Off Time [msec] 1/2 Cycle (1) GENERAL SPECIFICATIONS Description Parameters Dielectric Strength, Input/Output/Base (50/60Hz) 2500 Vrms 9 10 Ohm Minimum Insulation Resistance (@ 500 VDC) Maximum Capacitance, Input/Output 10 pF Ambient Operating Temperature Range -30 to 80 °C Ambient Storage Temperature Range -30 to 125 °C Weight (typical) 0.6 oz. (17 gr) Encapsulation Thermally Conductive Epoxy GENERAL NOTES (1) All parameters at 25°C and per section unless otherwise specified. (2) Off-State dv/dt test method per EIA/NARM standard RS-443, paragraph 13.11.1 (3) See Current Derating Curve. WIRING DIAGRAM -VDC 4 +VDC V 3 B LOAD VAC 2 Load can be used wired in position A or B LOAD VAC 1 A Do not forget to visit us at: www.crydom.com Copyright © 2017 Crydom Inc. Specifications subject to change without notice. Trigger Circuit PCB Mount DataSheet MECHANICAL SPECIFICATIONS Tolerances: ±0.02 in / 0.5 mm All dimensions are in: inches [millimeters] 0.40 0.52 0.45 [10.2] [13.1] Ø 0.14 [11.4] [3.6] 0.15 [3.7] 1.22 1.05 [31.0] 0.90 LS240D12 [26.5] [22.7] 0.16 12A 240VAC 4-10VDC [4.1] 1 ~ 2 +3 -4 0.16 .032 [4.0] [0.8] 0.11 [2.9±.25] 0.032 ± .005 0.44 SQ. [.80 ±.13] [11.1] (4 Places) 0.40 [10.2] 0.30 0.20 [7.6] [5.1] 1.40 [35.5] THERMAL DERATE INFORMATION 8 Amp 12 Amp 4ºC/W 6ºC/W 8ºC/W 10ºC/W No Heatsink 4ºC/W 6ºC/W 8ºC/W 10ºC/W No Heatsink 12 8 10 6 8 6 4 4 2 2 0 0 20 30 40 50 60 70 80 10 20 30 40 50 60 70 80 Ambient Temperature (ºC) Ambient Temperature (ºC) AGENCY APPROVALS Designed in accordance with the requirements of IEC 62314 E116950 Rev. 080417 ECN 20291 Do not forget to visit us at: www.crydom.com Copyright © 2017 Crydom Inc. Specifications subject to change without notice. Load Current (Amps) Load Current (Amps) PCB Mount DataSheet DANGER / PELIGRO / DANGER /GEFAHR / PERICOLO / 危险 HAZARD OF RIESGO DE RISQUE DE GEFAHR EINES RISCHIO DI 存在电击、 ELECTRIC DESCARGA DESCHARGE ELEKTRISCHE SCOSSA 爆炸或电弧 SHOCK, ELECTRICA O ELECTRIQUE N SCHLAGES ELETTRICA O 闪烁危险 EXPLOSION, EXPLOSION. OU EXPLOSION ODER EINER DELL’ESPLOSI OR ARC FLASH. EXPLOSION. ONE. • Eteindre • 在操作此设 • Desconectar • Disconnect all • Stellen Sie toutes les • Spenga tutta todos los 备之前请先 jeglichen power before sources l'alimentazion suministros de 关闭电源。 installing or Strom ab, der d'énergie de e che fornisce energia a este working with dieses Gerät cet appareil questa equipo antes 若不遵守这些说明， this equipment. versorgt, bevor avant de apparecchiatu de trabajar 可能会导致严重的 Sie an dem ra prima del con este equipo. travailler • Verify all Gerät Arbeiten 人身伤害甚至死亡。 lavorare a questa dessus de cet connections • Verificar todas durchführen appareil apparecchiatu ra and replace all las conexiones • Vor dem covers before • Verificare tutti y colocar todas • Vérifier tous Drehen auf turning on i collegamenti las tapas antes connections, et Energie alle power. e sostituire de energizer remettre tous Anschlüsse tutte le coperture el equipo. couverts en überprüfen Failure to follow prima della olace avant de und alle these El rotazione mettre sous Abdeckungen instructions will incumplimiento sull'alimentazi one ersetzen. De non-suivi de result in death de estas ces instructions L'omissione di or serious injury. Unterlassung instrucciones provoquera la seguire queste dieser puede provocar mort ou des istruz ioni Anweisungen la muerte o provocherà la lésions sérieuses können zum lesiones serias. morte o di sérieuses. Tode oder zu lesioni serie schweren Verletzungen führen. WARNING / AVERTISSEMENT / WARNUNG /ADVERTENCIA / AVVERTENZA / 警告 RISQUE DE DOMMAGE MATERIEL ET DE GEFAHR VON MATERIALSCHÄDEN UND RISK OF MATERIAL DAMAGE AND HOT SURCHAUFFE DU BOITIER GEHÄUSEERHITZUNG ENCLOSURE • Les panneaux latéraux du produit peuvent être • Die Seitenwände können heiß sein. Lassen Sie • The product's side panels may be hot, allow chauds. Laisser le produit refroidir avant de le das Produkt abkühlen, bevor Sie es berühren. the product to cool before touching. toucher. • Beachten Sie die Montageanweisungen, • Follow proper mounting instructions including • Respecter les consignes de montage, et • Führen Sie keine Flüssigkeiten oder torque values. notamment les couples de serrage. Fremdkörper in das Produkt ein. • Do not allow liquids or foreign objects to enter • Ne pas laisser pénétrer de liquide ni de corps this product. étrangers à l'intérieur du produit. Le non-respect de cette directive peut entraîner, Die Nichtbeachtung dieser Anweisung kann Failure to follow these instructions can result in des lésions corporelles graves ou des Körperverletzung oder Materialschäden serious injury, or equipment damage. dommages matériels. zur Folge haben. RIESGO DE DAÑOS MATERIALES Y DE RISCHIO DI DANNI MATERIALI E D'INVOLUCRO 材料损坏和高温外壳的危险性 SOBRECALENTAMIENTO DE LA UNIDAD CALDO • 产品的一侧面板可能很热，在其冷却前请 • Los paneles laterales del producto pueden • I pannelli laterali dell'apparecchio possono 不要触碰。 estar calientes. Esperar que el producto se scottare; lasciar quindi raffreddare il prodotto • 遵照正确的安装说明，包括扭矩值。 enfríe antes de tocarlo. prima di toccarlo. • 请勿让液体及其他异物进入本产品。 • Respetar las instrucciones de montaje, y en • Seguire le istruzioni di montaggio corrette. particular los pares de apretado. • Non far entrare liquidi o oggetti estranei in questo • No dejar que penetren líquidos o cuerpos apparecchio. extraños en el producto. La mancata osservanza di questa precauzione può 如不能正确执行这些操作说明， Si no se respetan estas precauciones pueden causare gravi rischi per l'incolumità personale o 极有可能造成严重人体伤害或者设备的损坏。 producirse graves lesiones, daños materiales. danni alle apparecchiature. Do not forget to visit us at: www.crydom.com Copyright © 2017 Crydom Inc. Specifications subject to change without notice. PCB Mount DataSheet ANNEX - ENVIROMENTAL INFORMATION The environmental information disclosed in this annex including the EIP Pollution logo are in compliance with People’s Republic of China Electronic Industry Standard SJ/T11364 – 2006, Marking for Control of Pollution Caused by Electronic Information Products. Part Toxic or hazardous Substance and Elements Name Lead Mercury Cadmium Hexavalent Polybrominated Polybrominated Chromium biphenyls diphenyl ethers (Pb) (Hg) (Cd) (Cr (VI)) (PBB) (PBDE) Semiconductor die Solder 附件 - 环保信息 此附件所标示的包括电子信息产品污染图标的环保信息符合中华人民共和国电子行业标准 SJ/T11364 - 2006, 电子信息产品污染控制标识要求。 部件 有毒有害物质或元素 名称 铅 汞 镉 六价铬 多溴联苯 多溴二苯醚 (Pb) (Hg) (Cd) (Cr (VI)) (PBB) (PBDE) 半导体芯片 焊接点 50 Do not forget to visit us at: www.crydom.com Copyright © 2017 Crydom Inc. Specifications subject to change without notice.