5026R042A SPECIFICATION CONTROL DRAWING Date: 1-18-06 150 OHM, AWG 26, 19 STRANDS OF AWG 38, CHEMINAX TWIN CONDUCTOR CABLE Revision: C THIS SPECIFICATION SHEET FORMS A PART OF THE LATEST ISSUE OF RAYCHEM SPECIFICATION 1200. CONSTRUCTION DETAILS ELECTRICAL CHARACTERISTICS DIMENSIONS ARE NOMINAL VALUES IN INCHES UNLESS OTHERWISE DESIGNATED. CHARACTERISTIC IMPEDANCE 150 ± 15 ohms, Method C at 1 MHz CAPACITANCE - MUTUAL 8.8 pF/ft. (nominal) CONDUCTORS VELOCITY OF PROPAGATION 77% (nominal) AWG 26, 19 Strands of .0195 AWG 38, Silver-Coated SURFACE TRANSFER IMPEDANCE 10 milliohms/meter (maximum) Ultra High Strength Copper at 30 MHz per MIL-C-85485 Alloy DIELECTRICS .068 Rayfoam® H Colors - Lt. Blue / White FILLERS ADDITIONAL REQUIREMENTS .045 Radiaiton-Crosslinked Modified ETFE ELECTRICAL CONDUCTOR RESISTANCE 56.4 ohms/1000 ft. (nominal) INSULATION RESISTANCE 10,000 megohms (minimum) for 1000 ft. JACKET FLAWS SPARK TEST 1.0 kV (rms) IMPULSE TEST 6.0 kV (peak) VOLTAGE WITHSTAND (DIELECTRIC) 1500 volts (rms) (minimum) 1st SHIELD .153 AWG 38, Silver-Coated Copper, Optimized ENVIRONMENTAL FLAMMABILITY Method B HEAT SHOCK225°C LOW TEMPERATURE- -55°C/5.50 inch mandrel 2nd SHIELD COLD BEND .170 AWG 38, Silver-Coated VOLTAGE WITHSTAND Copper, Optimized (POST ENVIRONMENTAL) 1000 volts (rms), 1 minute PHYSICAL INSULATION (DIELECTRIC) (Prior to Cabling) ELONGATION 50% (minimum) JACKET TENSILE STRENGTH 600 lbf/in² (minimum) .194 Modified FEP JACKET (nominal) ELONGATION 200% (minimum) .200 TENSILE STRENGTH 2000 lbf/in² (minimum) (maximum) JACKET THICKNESS .012 inch (nominal) MARKER TAPE: Place marker tape under jacket and mark in Outer jacket will be translucent white (designated by a "-9X" 12 inch (nominal) intervals as follows: " 5026R042A-9X 06090 " appended to the part number, e.g., 5026R042A-9X) unless otherwise specified. Designate outer jacket color with a dash number in accordance with MIL-STD-681. Other codes and suffixes may be added to the WEIGHT 31.6 lbs/1000 ft. (nominal) part number, as necessary, to capture any additional requirements imposed by the purchase order. Users should evaluate the suitability of this product for their application. Specifications are subject to change without notice. Tyco Electronics also reserves the right to make changes in materials or processing, which do not affect compliance with any specification, without notification to Buyer. THIS SPECIFICATION SHEET TAKES PRECEDENCE OVER DOCUMENTS REFERENCED HEREIN. 501 Oakside Avenue R REFERENCED DOCUMENTS SHALL BE OF THE ISSUE IN EFFECTON DATE OF INVITATION FOR BID. Redwood City, California 94063-3800 Wire & Cable 1-800-227-8816 Fax: 1-650-361-6297 © 2005-2006 Tyco Electronics Corporation. All rights reserved.