SPECIFICATION CONTROL DRAWING 55/P2324 Date Revision TITLE TWO CONDUCTOR CABLE, FLAT BRAID SHIELDED, D 7-21-06 JACKETED, OUTER SPACE, 600 VOLT This specification sheet forms a part of the latest issue of Raychem Specification 55/. SHIELD - SILVER-COATED COPPER COMPONENT WIRES - 55/0314 JACKET - LOW OUTGASSING RADIATION-CROSSLINKED, MODIFIED ETFE CABLE CONSTRUCTION DETAILS SHIELD CONDUCTOR OUTSIDE DIAMETER JACKET THICKNESS MAXIMUM STRAND PART NUMBER (inch) SIZE (inch) WEIGHT THICKNESS 1/ (AWG) (lbs/1000 ft.) NOMINAL NOMINAL MAXIMUM (± .0004 in.) MINIMUM 55/P2324-28-* 28 .0040 .0050 .063 .067 3.69 .0015 26 55/P2324-26-* .0015 .0040 .0050 .072 .076 4.92 55/P2324-24-* 24 .0040 .0050 .083 5.98 .0015 .079 55/P2324-22-* 22 .0015 .0040 .0050 .096 .100 8.84 55/P2324-20-* 20 .0045 .0055 .122 12.99 .0015 .118 CABLE RATINGS AND ADDITIONAL REQUIREMENTS TEMPERATURE RATING: 200°C VACUUM STABILITY: Maximum continuous conductor temperature Total Mass Loss (TML), 1.0% (maximum) VOLTAGE RATING: 600 volts (rms) at sea level Volatile Condensable Material, 0.1% (maximum) CROSSLINK VERIFICATION: 300 ± 3°C for 1 hour VOLTAGE WITHSTAND TEST (Post Environmental): DIELECTRIC WITHSTAND: 1500 volts (rms), 60 Hz 1500 volts (rms), 60 Hz, 1 minute JACKET COLOR: White preferred JACKET ELONGATION: 50% (minimum) PART NUMBER: JACKET FLAWS: The "*" in the part numbers above shall be replaced Spark Test, 1000 volts (rms) by color code designators with a slash separating Impulse Dielectric Test, 6.0 kV (peak) the component wire colors and a dash separating RADIATION RESISTANCE: 500 megarads the component wire colors from the jacket color. SHIELD COVERAGE: 90% (minimum) 1/ Example: AWG 26, black and brown component wires; white jacket: 55/P2324-26-0/1-9 NOTE: Nominal values are for information only. Nominal values are not requirements. Users should evaluate the suitability of this product for their application. Specifications are subject to change without notice. Tyco Electronics also reserves the right to make changes in materials or processing, which do not affect compliance with any specification, without notification to Buyer. 1/ COLORS AND COLOR CODE DESIGNATORS SHALL BE IN ACCORDANCE WITH MIL-STD-681. HOWEVER, DUE TO LENGTH LIMITATIONS OF THE RAYCHEM PART NUMBER, AN ALTERNATIVE COLOR CODE MAY REPLACE MIL-STD-681 COLOR CODE DESIGNATORS. (EXAMPLE: “901/902...” MAY BE REPLACED BY “Axxx”.) OTHER CODES AND SUFFIXES MAY BE ADDED TO THE PART NUMBER, AS NECESSARY, TO CAPTURE ANY ADDITIONAL REQUIREMENTS IMPOSED BY THE PURCHASE ORDER. R Wire & Cable DIMENSIONS ARE IN INCHES, AND UNLESS OTHERWISE DESIGNATED ARE NOMINAL. 501 Oakside Avenue Redwood City, CA 94063-3800 Page 1 of 1 THIS SPECIFICATION SHEET TAKES PRECEDENCE OVER DOCUMENTS REFERENCED HEREIN. Phone: 1-800-227-8816 REFERENCED DOCUMENTS SHALL BE OF THE ISSUE IN EFFECT ON DATE OF INVITATION FOR BID. Fax: 1-650-361-6297 © 2005-2006 Tyco Electronics Corporation. All Rights Reserved.