POWER DS1200 Data Sheet 1200 Watts Distributed Power System Distributed Power Bulk Front-End Total Output Power: 1200 Watts +3.3 Vdc Stand-by Output Wide Range Input Voltage: 90 - 264 Vac Special FeatureS ƒ Active power factor correction ƒ EN61000-3-2 harmonic compliance ƒ Active AC inrush control ƒ 1U X 2U form factor ƒ 21.71 W/in3 ƒ +12 Vdc Output Electrical Specifications ƒ +3.3 Vdc or +5.0 Vdc stand-by Input ƒ No minimum load required Input range: ƒ Hot plug operation 180 - 264 (1200 W) 90 - 264 (1000 W) ƒ N + 1 redundant ƒ Internal OR’ing fets Frequency: 47-63 Hz, single phase AC ƒ Active current sharing Inrush current: 40 Apk maximum inrush current (10 - 100% load) Efficiency: > 91% typical at high line 50% load ƒ Built-in cooling fan Conducted EMI: FCC Subpart J EN55022 Class B (40 mm x 28 mm) 2 Radiated EMI: FCC Subpart J EN55022 Class B ƒ I C communication interface bus ƒ PMBus compliant Power factor: 0.99 typical ƒ EEPROM for FRU data Leakage current: 1.40 mA @ 240 VAC ƒ Red/green bi-color LED status Hold up time: 12 ms minimum ƒ Internal fan speed control Output ƒ Fan Fail Tach Output Signal Main DC voltage: +12 V @ 100 A (high line) ƒ Full digital control +12 V @ 81.6 A (low line) ƒ Two year warranty Stand-By: +3.3 Vsb @ 6 A (5 V @ 4 A available) 2 Adjustment range: ±5% on +12V only using I C SaFety Regulation: +12 Vdc; +5%/-5% ƒ UL/cUL 60950 (UL Recognized) +3.3 Vsb; +5%/-5% ƒ NEMKO+ CB Report EN60950 Over current: +12 Vdc; latches off if overcurrent lasts over 1 second, ƒ EN60950 otherwise it is auto recovery (See Table 1 next page) +3.3 Vsb, 9 A ƒ CE Mark max (hiccup mode) ƒ China CCC Over voltage: +12 Vdc; 13.2 - 14.4 Vdc +3.3 Vsb; 3.76 - 4.30 Vdc Under voltage: +12 Vdc; 9 - 10.8 V (latch off) Turn-on delay: 2 second max, 5 - 50 mS, monotonic rise Main output rise time: 5 - 50 mS, monotonic rise DS1200 Series Data Sheet Logic Control PS_SEATED (A4): TTL logic LOW if power supply is seated into system connector. This is a short pin. A logic HIGH if the PSU is removed PWR GOOD (C3): Active TTL high when output is within regulation limits. AC OK (B1): A low logic level if the input voltage is within allowable limits. A TTL logic HIGH level, and a 5mS early warn- ing signal before 12.0 V DC output loss of regulation. PS_INHIBIT/PS_KILL (B4): When left open power supply operation will be inhibited. When the power supply is inserted into the system, this pin will be pull low by the system and turn the power supply on only after all other power supply pins have seated. PS ON (A1): The output will be enabled when this signal is pulled low, below 0.8 V outputs disabled when pin is driven high or left open. Environmental Specifications Operating temperature: -10° to 50 °C Storage temperature: -40 °C to +85 °C Altitude, operating: 10,000 ft Electromagnetic susceptibility/Input transients: -EN61000-3-2, -3-3 -EN61000-4-2, 4.3, 4-4, -4-5, 4-11 -EN55024:1998 RoHS & lead-free compliant: No tantalum caps. Humidity: 20 to 90% RH, non-condensing Shock and vibration specificatons: Complies with standard operating/non-operating random shock and vibration MTBF (Demonstrated): 500K Hrs at full load, 25 °C DS1200 Series Data Sheet Ordering Information Nominal Output Output Set Point Total Minimum Maximum Model Number Ripple Over Current Stand-by Air Flow Voltage Tolerance Regulation Current Current P/P Set Point * DS1200-3 12.0 Vdc ±0.2% ±5% 0 A 100 A 120 mV 118 A - 147.6 A 3.3 V @ 6 A STD DS1200-3-002 12.0 Vdc ±0.2% ±5% 0 A 100 A 120 mV 118 A - 147.6 A* 5.0 V @ 4 A STD ** DS1200-3-003 12.0 Vdc ±0.2% ±5% 0 A 100 A 120 mV 118 A - 147.6 A* 3.3 V @ 6 A REV ** DS1200-3-004 12.0 Vdc ±0.2% ±5% 0 A 100 A 120 mV 118 A - 147.6 A* 5.0 V @ 4 A REV * Over current latches off if overcurrent lasts over 1 seconds, otherwise it is auto recovery. Derating may apply. DS1200 Series Data Sheet Mechanical Drawing Condition LED Status Stand-by - ON; Main output - OFF; AC PRESENT Blinking green Stand-by - ON; Main output - ON; Solid green Main output OCP, UVP, OVP Blinking Amber FAN_FAULT; OTP; Stand-by OCP/UVP Amber DS1200 Series Data Sheet DC Output Connector Pinout Assignment Male connector as viewed from the rear of the supply: D1 D2 D3 D4 D5 D6 C1 C2 C3 C4 C5 C6 PB1 PB2 PB3 PB4 PB5 PB6 B1 B2 B3 B4 B5 B6 A1 A2 A3 A4 A5 A6 P1 - Power Supply Side Mating Connector (System Side) 1 FCI Power Blade 51721 series 1 FCI Power Blade 51721-10002406AA 51741-10002406CC Strait Pins 2 Molex Power Connector 2 FCI Power Blade SD-87667 series 51761-10002406AALF 87667-7002 Right Angle Pin Assignments Pin Assignments Pin Signal Name Pin Signal Name 2 PB 1 Main output return C1 SDA (I C Data Signal) 2 PB 2 Main output return C2 SCL (I C Clock Signal)* PB 3 Main output return C3 POWER GOOD PB 4 + Main output C4 Spare PB 5 + Main output C5 STAND-BY PB 6 + Main output C6 STAND-BY RETURN 2 A1 PS_ON D1 A0 (I C Address BIT 0 Signal) 2 D2 A1 (I C Address BIT 1 Signal) A2 Main output remote sense return A3 Spare D3 S_INT (Alarm) A4 PS_SEATED (Power Supply Seated) D4 STAND-BY RMT SENSE A5 STAND-BY D5 STAND-BY A6 STAND-BY RETURN D6 STAND-BY RETURN B1 AC_OK (AC Input Present) 2 *Supports I C standard mode (100 kHz) only B2 Main output remote sense B3 Main output current share B4 PS_INHIBIT/PS_Kill B5 STAND-BY B6 STAND-BY RETURN WORLDWIDE OFFICES americas europe (uK) asia (HK) 14/F, Lu Plaza 2900 S.Diablo Way Waterfront Business Park Tempe, AZ 85282 Merry Hill, Dudley 2 Wing Yip Street Kwun Tong, Kowloon USA West Midlands, DY5 1LX +1 888 412 7832 United Kingdom Hong Kong www.artesyn.com +44 (0) 1384 842 211 +852 2176 3333 While every precaution has been taken to ensure accuracy and completeness in this literature, Artesyn For more information: www.artesyn.com/power Embedded Technologies assumes no responsibility, and disclaims all liability for damages resulting from use of For support: productsupport.ep@artesyn.com this information or for any errors or omissions. Artesyn Embedded Technologies, Artesyn and the Artesyn Embedded Technologies logo are trademarks and service marks of Artesyn Embedded Technologies, Inc. All other names and logos referred to are trade names, trademarks, or registered trademarks of their respective owners. DS1200 Series-DS 09.09.14 © 2014 Artesyn Embedded Technologies, Inc.