POWER Data Sheet DS650/DS850 Distributed Power Bulk Front-End Total Input 650/850 Watts Power: +3.3 Vdc Stand-by Output Wide Range 90 - 264Vac Output Voltage: 12, 24 and 48V Special FeatureS ƒ Active power factor correction ƒ EN61000-3-2 harmonic compliance ƒ Inrush control ƒ 1U X 2U form factor 3 ƒ 15.4 W/ in ƒ 12 Vdc, 24 Vdc and 48 Vdc output ƒ Available in +3.3V and +5.0V standby output versions ƒ No minimum load required Electrical Specifications ƒ Hot plug operation Input ƒ N + 1 redundant Input ra nge 90 - 264 Vac (wide range) ƒ Internal OR’ing fets Frequency 47 - 63 Hz, single phase AC ƒ Active current sharing (10 - 100% load) Inrush current 55 A maximum inrush current ƒ Built-in cooling fans (40mm x 28mm) Efficiency > 82% typical at full load, high line 2 ƒ I C communication interface bus Conducted EMI FCC Subpart J EN55022 Class B ƒ EEPROM for FRU data Radiated EMI FCC Subpart J EN55022 Class B ƒ Amber/Green bi-color LED status Power factor 0.99 typical ƒ Internal fan speed control ƒ Fan Fail Tach output signal Leakage current 1.40 mA @ 240 Vac ƒ One year warranty Hold up time 20ms minimum Output SaFety Main DC voltage +12 V @ 52.5 A/70.0 A ƒ UL/cUL 60950 (UL Recognized) +24 V @ 26.3 A/35.0 A +48 V @ 13.1 A/17.5 A ƒ NEMKO+ CB Report EN60950 ƒ EN60950 Stand-By +3.3 vsb @ 6 A (5 V @ 4 A available) ƒ CE Mark Adjustment range Factory Set, no pot adjustments ƒ China CCC Regulation Main output; +5%/-5% +3.3 vsb; +5%/-5% Over current 110% - 150% of nominal Latches off if overcurrent lasts over 1 second, otherwise it is auto recovery. +3.3 vsb, 9 A max (hiccup mode) Over voltage 110% - 120% of nominal +3.3 vsb; 3.76 - 4.30 Vdc Under voltage 75% - 90% of nominal Turn-on delay 2 Second max, 5 - 50 mS, Monotonic Rise Main output rise time 5 - 50 mS, Monotonic Rise DS650/DS850 Data Sheet Logic Control PS_SEATED TTL logic LOW if power supply is seated into system connector. This is a short pin. A logic HIGH if the PSU is removed. PWR GOOD Active TTL HiIGH when output is within regulation limits. AC OK A LOW logic level if the input voltage is within allowable limits. A TTL logic HIGH level, and a 5mS early warningsig- nal before main output loss of regulation. Temp OK A TTL logic HIGH, when operating within allowable temperature range. PS_INHIBIT/PS_KILL This signal is connected to a short pin on the PSU When left open power supply operation will be inhibited. When the power supply is inserted into the system, this pin will be pull low by the system and turn the power supply on only after all other power supply pins have seated. Environmental Specifications Operating temperature: 0 to 50°C, unimpeded airflow Storage temperature: -40°C to +85°C Altitude, operating 10,000ft. Electromagnetic susceptibility/Input transients: -EN61000-3-2, -3-3 -EN61000-4-2, 4.3, 4-4, -4-5, 4-11 -EN55024: 1998 RoHS & lead-free compliant (no tantalum caps.) Humidity: 20 to 90% RH, non-condensing Shock and vibration specificatons complies with Astec Std. Specifications. MTBF (Demonstrated) 500K Hrs at full load, 40°C Ordering Information Nominal Output Total Minimum Maximum Output Ripple Output Set Point Tolerance Voltage Set Point Regulation Current Current P/P 12.0 Vdc ±0.2% ±5% 0 A 52.5 A 120 mV DS650-3 3.3 vsb* ±1% ±5% 0 A 6.0 A 50 mV 24.0 Vdc ±0.2% ±5% 0 A 26.3 A 240 mV DS650-5 3.3 vsb* ±1% ±5% 0 A 6.0 A 50 mV 48.0 Vdc ±0.2% ±5% 0 A 13.1 A 480 mV DS650-9 3.3 vsb* ±1% ±5% 0 A 6.0 A 50 mV 12.0 Vdc ±0.2% ±5% 0 A 70.0 A 120 mV DS850-3 3.3 vsb* ±1% ±5% 0 A 6.0 A 50 mV 24.0 Vdc ±0.2% ±5% 0 A 35.0 A 240 mV DS850-5 3.3 vsb* ±1% ±5% 0 A 6.0 A 50 mV 48.0 Vdc ±0.2% ±5% 0 A 17.5 A 480 mV DS850-9 3.3 vsb* ±1% ±5% 0 A 6.0 A 50 mV *For 5 vsb, please contact marketing department. DS650/DS850 Data Sheet Mechanical Drawing Power Supply Condition LED Green/Amber No AC power to all PSU OFF AC present/Standby outpus ON, Main output OFF Blinking Green Power supply DC outputs ON and OK Solid Green Main output failure (OCP, OVP, UVP) Blinking Amber Fan Fail, OTP, Standby output OCP/UVP Solid Amber DS650/DS850 Data Sheet DC Output Connector Pinout Assignment Male connector as viewed from the rear of the supply: D1 D2 D3 D4 D5 D6 C1 C2 C3 C4 C5 C6 PB1 PB2 PB3 PB4 PB5 PB6 B1 B2 B3 B4 B5 B6 A1 A2 A3 A4 A5 A6 P1 - Power Supply Side Mating Connector (System Side) 1 FCI Power Blade 51721 series 1 FCI Power Blade 51721-10002406AA 51741-10002406CC Strait Pins 2 Molex Power Connector 2 FCI Power Blade SD-87667 series 51761-10002406AA 87667-7002 Right Angle Pin Assignments Pin Assignments Pin Signal Name Pin Signal Name 2 PB 1 MAIN O/P RETURN C1 SDA (I C Data Signal) 2 PB 2 MAIN O/P RETURN C2 SCL (I C Clock Signal)* PB 3 MAIN O/P RETURN C3 POWER GOOD PB 4 + MAIN O/P C4 FAN FAIL (Fan Fail Signal) PB 5 + MAIN O/P C5 +3V3 STAND-BY PB 6 + MAIN O/P C6 +3V3SB RETURN 2 A1 PS_ON D1 A0 (I C Address BIT 0 Signal) 2 D2 A1 (I C Address BIT 1 Signal) A2 MAIN O/P V RMT SENSE RETURN A3 TEMP_OK D3 S_INT (Alarm) A4 PS_SEATED ( Power Supply Seated) D4 +3V3 STAND-BY RMT SENSE A5 +3V3 STAND-BY D5 +3V3 STAND-BY A6 +3V3SB RETURN D6 +3V3SB RETURN B1 AC_OK (AC Input Present) 2 *Supports I C standard mode (100 kHz) only B2 MAIN O/P RMT SENSE B3 MAIN O/P CURRENT SHARE B4 PS_INHIBIT B5 +3V3 STAND-BY B6 +3V3SB RETURN WORLDWIDE OFFICES americas europe (uK) asia (HK) 14/F, Lu Plaza 2900 S.Diablo Way Waterfront Business Park Tempe, AZ 85282 Merry Hill, Dudley 2 Wing Yip Street Kwun Tong, Kowloon USA West Midlands, DY5 1LX +1 888 412 7832 United Kingdom Hong Kong www.artesyn.com +44 (0) 1384 842 211 +852 2176 3333 While every precaution has been taken to ensure accuracy and completeness in this literature, Artesyn For more information: www.artesyn.com/power Embedded Technologies assumes no responsibility, and disclaims all liability for damages resulting from use of For support: productsupport.ep@artesyn.com this information or for any errors or omissions. Artesyn Embedded Technologies, Artesyn and the Artesyn Embedded Technologies logo are trademarks and service marks of Artesyn Embedded Technologies, Inc. All other names and logos referred to are trade names, trademarks, or registered trademarks of their respective owners. DS650/DS850-DS Rev. 07.03.14 © 2014 Artesyn Embedded Technologies, Inc.