Embedded Power for Business-Critical Continuity Rev. 08.13.07 LPQ110 Series 1 of 3 LPQ110 Series 110 Watts Total Power: 80 - 110 Watts Input Voltage: 85-264 VAC 120-300 VDC # of Outputs: Quad Electrical Specifications Special Features Input • Universal input Input ra nge 85 - 264 Vac; 120 - 300 Vdc • High efficiency Frequency 47 - 440 Hz • Remote sense on main output Inrush current < 18 A peak @ 115 Vac; < 36 A peak @ 230 Vac, cold start @ 25 °C • Built-in EMI filter Efficiency 70% typical at full load • Low output ripple • Adjustable 5 V output EMI filter Meets FCC Class B conducted • Overvoltage protection CISPR 22 Class B conducted • Overload protection EN55022 Class B conducted • Adjustable floating 4th output VDE 0878 PT3 Class B conducted (On LPQ112 and LPQ113) Safety ground 0.5 mA @ 50/60 Hz, 264 Vac input • Power fail leakage current • Optional L bracket (-B suffix) Output • Cover kit available LPX110-C Maximum power 80 W convection 110 W with 30 CFM forced air Adjustment range ± 5% min. on main; 5 - 25 V on 4th output on LPQ112 and LPQ113 Cross regulation ± 2% on output 1; ±3% on outputs 2, 3 & 4 Hold-up time 20 ms @ 80 W load, 115 VAC nominal line Overload protection Short circuit protection on all outputs. Case overload protected @ 110-145% Safety above peak rating VDE 0805/EN60950 (IEC950) Overvoltage protection 5.7 - 6.7 VDC on main output. Latching type, recycle AC to reset 11774-3336-1245 (LC #84997) UL UL1950 E132002 CSA CSA 22.2-234 Level 3 LR53982C NEMKO EN 60950/EMKO-TUE P94102464 (74-sec) 203 BABT EN60950/BS7002 PS/605823 CB Certificate and report 1423, 1424, 1425 CE Mark (LVD) Embedded Power for Business-Critical Continuity Rev. 08.13.07 LPQ110 Series Logic Control 2 of 3 TTL logic signal goes high 50 - 150 msec after 5 V output. It goes Power failure low at least 4 msec before loss of regulation Compensates for 0.5 V lead drop min. Will operate without Remote sense remote sense connected. Reverse connection protected. Environmental Specifications Operating temperature: 0° to 50 °C ambient. Derate each output 2.5% per degree from Pin Assignments 50° to 70 °C (except for -C version). Connector LPQ112 LPQ113 LPQ114 Storage temperature: -40 °C to +85 °C SK1-1 GND GND GND SK1-3 Neutral Neutral Neutral Temperature coefficient:± 0.4% per °C SK1-5 Line Line Line Electromagnetic Designed to meet IEC 801, -2, -3, -4, -5, -6, Level 3 SK2-1 +5 V +5 V +5 V susceptibility: SK2-2 +5 V +5 V +5 V SK2-3 +5 V +5 V +5 V Humidity: Operating; non-condensing 5% to 95% SK2-4 Common Common Common Vibration: Three orthogonal axes, sweep at 1 oct/min, 5 min. dwell at SK2-5 Common Common Common SK2-6 Common Common Common four major resonances 0.75G peak 5Hz to 500Hz, operational SK2-7 Common Common Common MTBF demonstrated: > 550,000 hours at full load and 25 °C ambient conditions SK2-8 +12 V +15 V +12 V SK2-9 +12 V +15 V +12 V SK2-10 -12 V -15 V -12 V Ordering Information SK2-11 +5-25 V +5-25 V +24 V Maximum Load Maximum Load SK2-12 -5-25 V -5-25 V Common Model Output Minimum Peak Ripple P/P 2 with Convection with 30CFM Regulation SK201-1 +sense +sense +sense 1 3 Number Voltage Load Load (PARD) Cooling Forced Air SK201-2 -sense -sense -sense SK202-1 POK POK POK LPQ112 5 V 2 A 9 A 11 A 15 A ± 2% 50 mV SK202-2 GND GND GND 12 V 0 A 4.5 A 5 A 9 A ± 3% 120 mV -12 V 0 A 0.7 A 1.0 A 1.5 A ± 5% 120 mV Mating Connectors ± 5 - 25 V 0 A 2.5 A 3 A 3.5 A ± 3% 240mV, max AC Input: Molex 09-50-8051 (USA) LPQ113 5 V 2 A 9 A 11 A 15 A ± 2% 50 mV 09-91-0500 (UK) 15 V 0 A 4.5 A 5 A 9 A ± 3% 150 mV PINS: 08-58-0111 -15 V 0 A 0.7 A 1.0 A 1.5 A ± 5% 150 mV DC Outputs:Molex 09-50-8121 (USA) 09-91-1200 (UK) ± 5 - 25 V 0 A 2.5 A 3 A 3.5 A ± 3% 240mV, max PINS: 08-58-0111 LPQ114 5 V 2 A 9 A 11 A 15 A ± 2% 50 mV Remote Molex 22-01-1022 (USA) 12 V 0 A 4.5 A 5 A 9 A ± 3% 120 mV Sense 22-01-1023 (UK) Power Fail: PINS: 08-50-0114 -12 V 0 A 0.7 A 1.0 A 1.5 A ± 5% 120 mV Astec Connector Kit #70-841-006, includes all of -12 V 0.5 A 3.5 A 4.5 A 5 A +10 / -5% 240mV the above 1. Peak current lasting < 30 seconds with a maximum 10% duty cycle. 1. Specifications subject to change without notice. 2. At 25 °C including initial tolerance, line voltage, load currents and output voltages adjusted to factory 2. All dimensions in inches (mm), tolerance is ± 0.02” (± 0.5mm) settings. 3. Peak-to-peak with 20 MHz bandwidth and 10 µF in parallel with a 0.1 µF capacitor at rated line voltage and 3. Specifications are for convection rating at factory settings unless otherwise stated. load ranges. 4. Mounting holes M1 and M2 should be grounded 4. 4th output adjustable 5 to 25 V, factory set at 5 V. for EMI purposes. 5. Minimum loads are required. 5. Mounting hole M1 is safety ground connection. Note: -B suffix added to the model number indicates L bracket option. 6. L bracket mounting (6-32) maximum insertion depth is .20” (5). 7. Warranty: 2 year 8. Weight: 1.25 lb./0.57 kg 5V O/P ADJ Embedded Power for Business-Critical Continuity Rev. 08.13.07 Mechanical Drawing LPQ110 Series 3 of 3 -B Bracket Americas 5810 Van Allen Way Carlsbad, CA 92008 USA Telephone: +1 760 930 4600 Facsimile: +1 760 930 0698 #6-32 PEM 4.28" 6 places (108.6) Europe (UK) Waterfront Business Park Merry Hill, Dudley 2.5" West Midlands, DY5 1LX (63.5) United Kingdom Telephone: +44 (0) 1384 842 211 Facsimile: +44 (0) 1384 843 355 Asia (HK) 14/F, Lu Plaza 6.4" 2 Wing Yip Street (162.6) 7.3" Kwun Tong, Kowloon (185.5) Hong Kong Telephone: +852 2176 3333 Facsimile: +852 2176 3888 For global contact, visit: www.Emerson.com/EmbeddedPower 2.2" (56) techsupport.embeddedpower 0.86" @emerson.com (21.8) While every precaution has been taken to ensure 5.9" accuracy and completeness in this literature, Emerson Network Power assumes no responsibility, and disclaims (150.0) all liability for damages resulting from use of this information or for any errors or omissions. 0.25" (6.35) SK 202 M2 Emerson Network Power. (POK) 1 2 SK 201 The global leader in enabling 1 (+S) 1 2 business-critical continuity. (-S) 2 3 4 5 4.0" AC Power 6 (101.6) 7 8 Connectivity 9 3.5" 4th O/P ADJ 10 DC Power (88.9) 11 12 1 Embedded Computing GND 3 N Embedded Power L SK 1 Monitoring M1 6.5" 0.25" Outside Plant 0.156" (4) (165.1) (6.35) 7.0" DIA (4 places) Power Switching & Controls (177.8) Precision Cooling Racks & Integrated Cabinets Services 1.80" (45.7) Surge Protection EmersonNetworkPower.com Emerson Network Power and the Emerson 0.12" Network Power logo are trademarks and (3) service marks of Emerson Electric Co. ©2010 Emerson Electric Co. SK 2