POWER LPQ170 Series Data Sheet 175 Watts Total Power: 110 - 175 Watts Input Voltage: 85 - 264 Vac 120 - 300 Vdc # of Outputs: Quad SPECIAL FEATURES ƒ Active power factor correction ƒ IEC EN61000-3-2 compliance ƒ Adjustable outputs on 1, 3 & 4 Remote sense on main output ƒ Single wire current sharing ƒ Power fail and remote inhibit ƒ Built-in EMI filter ƒ Low output ripple ƒ Overvoltage protection Electrical Specifications ƒ Overload protection Input ƒ Thermal overload protection Input range 85-264 Vac; 120-300 Vdc ƒ DC power good Frequency 47-67 Hz ƒ 5 V standby output Inrush current 38 A max, cold start @ 25°C ƒ Adjustable floating 4th output Efficiency 75% typical at full load ƒ Optional cover (-C suffix) EMI filter Meets FCC Class B conducted ƒ RoHS compliant CISPR 22 Class B conducted EN55022 Class B conducted SAFETY VDE 0878 PT3 Class B conducted ƒ UL UL60950 Power factor 0.99 typical ƒ CB Certificate and report Safety ground leakage current 1.0 mA @ 50/60 Hz, 264 Vac input ƒ CSA CSA 22.2-234 Level 3 Output ƒ CE Mark (LVD) Maximum power 110 W convection (75 W with cover) ƒ NEMKO EN 60950/EMKO-TUE 85 W convection - LPQ173 175 W with 30 CFM forced air (130 W with cover - LPQ172) Adjustment range 3.3 - 5.5V on main; -12 - 15V on 3rd output 3.3 - 25 V on 4th output - LPQ172 3.3 - 5.5 V on 4th output - LPQ173 Hold-up time 20 ms @175 W load at nominal line Overload protection Short circuit protection on all outputs. Case overload protected @ 110-145% above peak rating Overvoltage protection Tracks outputs 1, 3 & 4; 15 to 35% Standby output 5 V @ 200 mA regulated ±5% LPQ170 Series Data Sheet Logic Control AC power failure TTL logic signal goes high 100 - 500 msec after V1 output; It goes low at least 4 msec before loss of regulation Remote inhibit -40 °C to +85 °C Electromagnetic susceptibility Requires contact closure to inhibit outputs Remote sense Compensates for 0.5 V lead drop min. Will operate without remote sense connected. Reverse connection protected. DC - OK TTL logic signal goes high after main output is in regulation. It goes low when there is a loss of regulation. Environmental Specifications Operating temperature 0 °C to 50 °C ambient. Derate each output 2.5% per degree from 50 °C to 70 °C (except for -C version). Storage temperature -40 °C to +85 °C Temperature coefficient ±0.4% per °C Electromagnetic susceptibility Designed to meet IE61000-4, -2, -3, -4, -5, -6, -8, -11, Level 3 Humidity Operating; non-condensing 5% to 95% Vibration Three orthogonal axes, sweep at 1 oct/min, 5 min. dwell at four major resonances 0.75 G peak 5 Hz to 500 Hz, operational MTBF demonstrated >550,000 hours at full load and 25°C ambient conditions Ordering Information Maximum Load Maximum Load Model Output Minimum Ripple 1 2 with Convection with 30CFM Peak Load Regulation 3 Number Voltage Load P/P(PARD) Cooling Forced Air LPQ172 5 V (3.3 - 5.5 V) 0 A 15 A 30 A 32 A ±2% 50 mV 12 V 0 A 6 A 8 A 10 A ±3% 120 mV -12 V (-12 -15 V) 0 A 1.5 A 3 A 3.5 A ±3% <1% ±3.3-25 V 0.5 A* 2 A 5 A 5.5 A ±3% <50mV or 1% LPQ173 5 V (3.3 - 5.5 V) 0 A 10 A 24 A 26 A ±2% 50 mV 12 V 0 A 6 A 8 A 10 A ±3% 120 mV -12V (-12 -15 V) 0 A .2 A 3 A 3.5 A ±3% <1% 5 V (3.3 - 5.5 V) 0 A 10 A 24 A 26 A ±2% 50 mV 1. Peak current lasting <30 seconds with a maximum 10% duty cycle. 2. At 25 °C including initial tolerance, line voltage, load currents and output voltages adjusted to factory settings. 3. Peak-to-peak with 20 MHz bandwidth and 10 μF in parallel with a 0.1 μF capacitor at rated line voltage and load ranges. 4. 4th output adjustable 3.3 - 25 V factory set at 5 V. 5. *Minimum loads are required when output set below 5 Volts 6. Remote inhibit resets OVP latch 7. LPQ173-C has no convection rating. 8. This product is a Component Power Supply and is only for inclusion by professional installers within other equipment and must not be operated as a standalone product. EMC compliance to appropriate standards must be verified at the system level. This product is for sale to OEMs and System Integrators, including through Distribution Channels. It is not intended for sale to End Users. Note: -C suffix added to the model number indicates cover option and is limited to 50 °C operation. LPQ170 Series Data Sheet Mechanical Drawing Notes: 1. Specifications subject to change without notice. 2. All dimensions in inches (mm), tolerance is ±0.02”. 3. Specifications are for convection rating at factory settings unless otherwise stated. 4. Mounting screw maximum insertion depth is 0.12”. 5. Warranty: 2 years 6. Weight: 2 lb/0.91 kg LPQ170 Series Data Sheet Pin Assignments Connector LPQ172 LPQ173 SK1 PIN 1 N/C V4 SWP PIN 2 5V Standby 5 V Standby PIN 3 N/C +V4 Sense PIN 4 V1 SWP V1 SWP PIN 5 Common Common PIN 6 +V1 sense +V1 sense PIN 7 Sense common Sense common PIN 8 Remote inhibit Remote inhibit PIN 9 DC power good DC power good PIN 10 POK POK SK2 PIN 1,2 +12 V +12V PIN 3,4,5 Common Common PIN 6 -12 V -12V PIN 7 POK POK PIN 8 +3.3 V to +25 V (Float) N/C PIN 9 Common (Float) N/C SK3 TB-1, 3 COMMON COMMON TB-2 +5 V (3.3V to 5.5V) +5V (3.3V to 5.5V) TB-4 N/C +5V (3.3V to 5.5V) SK4 PIN 1 GROUND GROUND PIN 3 LINE LINE PIN 5 NEUTRAL NEUTRAL Mating Connectors (SK4) AC Input Molex 09-50-8051 (USA) Molex 09-91-0500 (UK) PINS: 08-58-0111 (SK3) Main output Molex series 19141-0058/0063 (SK2) Aux DC Output/Power fail Molex 09-50-8091 (USA) Molex 09-91-0900 (UK) PINS: 08-58-0111 (SK1) Control Signals Molex 90142-0010 (USA) PINS: 90119-2110 or Amp: 87977-3 PINS: 87309-8 Astec connector kit #70-841-015, includes all of above WORLDWIDE OFFICES Americas Europe (UK) Asia (HK) 14/F, Lu Plaza 2900 S.Diablo Way Waterfront Business Park Tempe, AZ 85282 Merry Hill, Dudley 2 Wing Yip Street Kwun Tong, Kowloon USA West Midlands, DY5 1LX +1 888 412 7832 United Kingdom Hong Kong www.artesyn.com +44 (0) 1384 842 211 +852 2176 3333 Artesyn Embedded Technologies, Artesyn and the Artesyn Embedded Technologies logo are trademarks and For more information: www.artesyn.com/power service marks of Artesyn Embedded Technologies, Inc. All other names and logos referred to are trade names, For support: productsupport.ep@artesyn.com trademarks, or registered trademarks of their respective owners. © 2016 Artesyn Embedded Technologies, Inc. All rights reserved. For full legal terms and conditions, please visit www.artesyn.com/legal. LPQ170 Series-DS 18Mar2016