process yellow 116 1375 Embedded Power for Business-Critical Continuity 1797 375 Rev. 2.20.09_161 LPT80 Series 1 of 3 3405 LPT80 Series 80 Watts 313 Total Power: 55 - 85 Watts Input Voltage: 85 - 264 Vac 120 - 370 Vdc # of Outputs: Triple 2985 240 Electrical Specifications Special Features Input 242 • Power Factor Correction Input range: 85 - 264 Vac; 120 - 300 Vdc • EN61000-3-2 compliant Frequency: 47 - 440 Hz • Universal input < 18 A peak @ 115 Vac; • 3” x 5” footprint Inrush current: < 36 A peak @ 230 Vac, 2607 • Remote sense on outputs 1 cold start @ 25 °C (& 2 for LPT81) Input current: 1.5 A max. (RMS) @ 115 Vac • Power fail and remote inhibit • Wide range adjustable on Efficiency: 75% typical at full load outputs 1 (& 2 for LPT81) EMI filter: FCC Class B conducted 652 • Built-in Class B EMI filter CISPR 22 Class B conducted • Overvoltage protection EN55022 Class B conducted • Overload protection VDE 0878 PT3 Class B conducted Safety ground < 1 mA @ 50/60 Hz, 264 Vac input leakage current: Output Maximum power: 60 W for convection (LPT81, 55 W); 85 W with 30 CFM forced air Adjustment range: 3.3 V - 5.5 V on outputs one Safety (and two 1.8 V - 3.5 V for LPT81) • VDE 60950 Hold-up time: 20 ms @ 85 W load, 115 Vac nominal line • UL 60950 Overload protection: Short circuit protection on all outputs. • CSA 60950 Case overload protected @ 145% above peak rating • NEMKO 60950 • AUSTEL 60950 Overvoltage protection:Tracks outputs 1( & 2 for LPT81): 20% to 35% above output setting • CB Certificate & report • CE Mark LVD process yellow 116 1375 Embedded Power for Business-Critical Continuity 1797 375 Rev. 2.20.09_161 LPT80 Series 2 of 3 3405 Logic Control TTL logic signal goes high 100 - 500 msec after V1 output; It goes low at least 4 msec before Power failure: loss of regulation 313 Remote inhibit: Requires contact closure to inhibit outputs Compensates for 0.5 V lead drop min. Will operate without remote sense connected. Remote sense: Reverse connection protected. 2985 Environmental Specifications 240 Operating temperature: 0° to 50 °C ambient; derate each output at 2.5% per degree from 50° to 70 °C Temperature coefficient: ± 0.4% per °C Storage temperature: - 40° to 85 °C 242 Electromagnetic Designed to meet IEC EN61000-4, -2, -3, -4, -5, -6, -8, -11 Level 3 susceptibility: Humidity: Operating; non-condensing 5% to 95% Vibration: Three orthogonal axes, sweep at 1 oct/min, 5 min. dwell at four major resonances 0.75 G 2607 peak 5 Hz to 500 Hz, operational MTBF demonstrated: > 550,000 hours at full load and 25 °C ambient conditions 652 Ordering Information Model Minimum Maximum Load with Maximum Load with Ripple P/P 1 2 Output Voltage Peak Load Regulation 3 Number Load Convection Cooling 30CFM Forced Air (PARD) LPT81 +3.3 V (1.8 - 3.5 V) 0.7 A 8.0 A 13 A 15 A ±2% 50 mV +5 V (3.3 - 5.5 V) 0.3 A 4.0 A 13 A 15 A ±2% 50 mV +12 V 0 0.7 A 1.0 A 1.5 A ±5% 120 mV LPT82 +5 V (3.3 - 5.5 V) 0.7 A 8.0 A 13 A 15 A ±2% 50 mV +12 V 0.3 A 3.0 A 4.0 A 4.6 A ±5% 120 mV -12 V 0 0.7 A 1.0 A 1.5 A ±5% 120 mV LPT83 +5 V (3.3 - 5.5 V) 0.7 A 8.0 A 13 A 15 A ±2% 50 mV +15 V 0.3 A 2.4 A 3.2 A 3.7 A ±5% 150 mV -15 V 0 0.7 A 0.7 A 1 A ±5% 150 mV 1. Peak current lasting < 30 seconds with a maximum 10% duty cycle. 2. At 25 °C including initial tolerance, line voltage, load currents and output voltages adjusted to factory settings. 3. Peak-to-peak with 20 MHz bandwidth and 10 µF in parallel with a 0.1 µF capacitor at rated line voltage and load ranges. 4. Minimum loads are required 5. Total current of all outputs can not exceed 21 A. process yellow 116 1375 Embedded Power for Business-Critical Continuity 1797 375 Rev. 2.20.09_161 LPT80 Series Mechanical Drawing 3 of 3 Americas 3405 5810 Van Allen Way Carlsbad, CA 92008 USA 5.00 0.23 (5.8) Telephone: +1 760 930 4600 (127.0) (4x) .14 (Ø 3.6) Facsimile: +1 760 930 0698 313 Europe (UK) Waterfront Business Park 1 Merry Hill, Dudley West Midlands, DY5 1LX 2985 United Kingdom Telephone: +44 (0) 1384 842 211 3.00 Facsimile: +44 (0) 1384 843 355 (76.2) 8 2.55" Asia (HK) 240 5 10 (64.8) 14/F, Lu Plaza 2 Wing Yip Street Kwun Tong, Kowloon 1 1 6 Hong Kong Telephone: +852 2176 3333 Facsimile: +852 2176 3888 242 4.56" 0.22 (5.6) For global contact, visit: 0.22 (5.6) (115.8) www.PowerConversion.com techsupport.embeddedpower 2607 @emerson.com While every precaution has been taken to ensure Pin Assignments Mating Connectors accuracy and completeness in this literature, Emerson AC Input (SK1): Molex 09-50-8031 (USA) Network Power assumes no responsibility, and disclaims Connector LPT81 LPT82/83 Molex 09-91-0300 (UK) all liability for damages resulting from use of this PINS: 08-58-0111 SK1 Pin1 Neutral Neutral information or for any errors or omissions. 652 DC Outputs (SK2): Molex 09-50-8081 (USA) Pin3 Line Line 09-91-0800 (UK) PINS: 08-58-0111 SK2 Pin1 V1 (3.3V) V1 (5 V) Emerson Network Power. Control Signals Molex 90142-0010 (USA) The global leader in enabling Pin2 V1 (3.3V) V1 (5 V) (SK3): PINS: 90119-2110 or business-critical continuity. Pin3 Common Common Amp: 87977-3 PINS: 87309-8 Pin4 Common Common Emerson Network Power Connector Kit #70-841-018 AC Power Pin5 Common Common includes all the above. Pin6 V2 (5V) V2 (12/15V) Connectivity Pin7 V2 (5V) V2 (12/15V) DC Power Pin8 V3 (12V) V3 (-12V/15) Notes: Embedded Computing SK3 Pin1 +V1 Remote sense +V1 Remote sense 1. Specifications subject to change without notice. Embedded Power 2. All dimensions in inches (mm), tolerance is ± .02”. Pin2 -V1 Remote sense -V1 Remote sense 3. Mounting holes M1, M2 and M3 should be Pin3 +Remote inhibit +Remote inhibit Monitoring grounded for EMI purposes. Pin4 -Remote inhibit -Remote inhibit 4. Mounting hole M1 is safety ground connection. Outside Plant Pin5 +Power fail +Power fail 5. Specifications are for convection rating at Power Switching & Controls Pin6 Common Common factory settings at 115 VAC input, 25 °C unless otherwise stated. Precision Cooling Pin7 No connection No connection 6. Warranty: 2 year Pin8 +V2 sense No connection Racks & Integrated Cabinets 7. Weight: 0.8 lb. / 0.36 kg Pin9 -V2 sense No connection Services Pin10 No connection No connection Surge Protection EmersonNetworkPower.com Emerson Network Power and the Emerson Network Power logo are trademarks and service marks of Emerson Electric Co. ©2008 Emerson Electric Co.