POWER NTS500 Series Data Sheet 500 Watts Total Power: 200 - 500 Watts Input Voltage: 85 - 264 Vac 120 - 300 Vdc # of Outputs: Single SPECIAL FEATURES ƒ Active power factor correction ƒ IEC EN61000-3-2 compliance ƒ Remote sense ƒ Power fail and remote inhibit ƒ Single wire current sharing ƒ Built-in EMI filter Electrical Specifications ƒ Low output ripple Input ƒ 5 V standby Input ra nge 85 - 264 Vac (wide range) ƒ 12 V fan output Frequency 47 - 440 Hz ƒ Overvoltage protection Inrush current 50 A max., cold start @ 25 °C ƒ Overload protection ƒ Thermal overload protection Efficiency 85% typical at full load, nominal line ƒ DC power good EMI filter FCC Class B conducted and radiated; CISPR22 Class B ƒ Built in OR-ing diode/FET conducted and radiated; EN55022 Class B conducted and radiated; VDE0878PT3 Class B conducted and radiated. ƒ Optional fan cover (-CF suffix) ƒ Optional end fan cover (-CEF suffix) Safety ground leakage current < 0.5 mA @ 50/60 Hz, 264 Vac input ƒ PM Bus compliant Output ƒ RoHS compliant Maximum power 200 W for convection; 500 W with 30 CFM forced air 2 ƒ Digital I C interface Adjustment range ± 5% ƒ Two year warranty Standby output 5 V @ 1 A convection, 2 A forced air, regulated, ± 5% ƒ POE isolation on NTS508 Fan output 12 V @ 1 A, -5 %, +7%, 0.5 A for -CF version Hold-up time 20 ms @ 500 W load, 115 VAC nominal line at factory voltage SAFETY setting ƒ TUV: 60950 Overload protection Short circuit protection on all outputs. Case overload ƒ cCSAus: 60950 protected @ 115 - 130% above peak rating ƒ NEMKO: 60950 Overvoltage protection 20 - 35% above nominal output ƒ CB: Certificate & report ƒ CE: Mark (LVD) NTS500 Series Data Sheet Environmental Specifications Operating temperature 0° to 50 °C ambient derate each output as 2.5% per degree from 50° to 70 °C Storage temperature -40 °C to +85 °C Electromagnetic susceptibility Designed to meet EN61000-4; -2, -3, -4, -5, -6, -8, -11 Level 3 Humidity Operating; non-condensing 10% to 90% RH Vibration Three orthogonal axes, sweep at 1 oct/min, 5 min. dwell at four major resonances 2 G peak 8 Hz to 500 Hz, operational Ordering Information Minimum Maximum Load with Maximum Load with Ripple 1 2 Model Number Output Voltage Peak Load Regulation 3 Load Convection Cooling 30CFM Forced Air P/P (PARD) NTS503 12 V 0 A 16.6 A 41.7 A 47 A ± 2% 120 mV NTS505 24 V 0 A 8.3 A 20.8 A 23.4 A ± 2% 240 mV NTS506 18 V 0 A 11.1 A 27.7 A 30 A ± 2% 180 mV NTS508 48 V 0 A 4.2 A 10.4 A 11.7 A ± 2% 480 mV 1. Peak current lasting < 30 seconds with a maximum 10% duty cycle. 2 . At 25 °C including initial tolerance, line voltage, load currents and output voltages adjusted to factory settings. 3 . Peak-to-peak with 20 MHz bandwidth and 10 µF (tantalum capacitor) in parallel with a 0.1 µF capacitor at rated line voltage and load ranges. 4. 12 V fan output cannot be used above 50 °C with convection cooling. 5. -CF suffix added to the model number indicates cover with top fan. -CEF suffix added to the model number indicates cover with end mounted fan cover and AC inlet. 6. This product is a Component Power Supply and is only for inclusion by professional installers within other equipment and must not be operated as a standalone product. EMC compliance to appropriate standards must be verified at the system level. This product is for sale to OEMs and System Integrators, including through Distribution Channels. It is not intended for sale to End Users. Logic Control Power failure TTL logic signal goes high 100 - 500 msec after main output. It goes low 10msec before loss of regulation. Remote on/off Requires an external contact closure to inhibit outputs DC OK TTL logic goes high after the output is in regulation. It goes low when there is loss of regulation. Remote sense Compensates for 0.5 V lead drop min. Will operate without remote sense connected. Reverse connection protected. NTS500 Series Data Sheet Pin Assignments Adjustment Potentiometers Connector P1 +V1 Output adjust CN1 PIN 1 Line Mating Connectors PIN 3 Neutral SK4, 5, 6 Molex 19141-0058 PIN 5 Ground SK7 Molex 90142-0010 SK7 PIN 1 V1 SWP PINS: 90119-2110 1 5 PIN 2 - Remote Sense Or Amp: 87977-3 610 PIN 3 + Remote Sense PINS: 87309-8 PIN 4 5 VSB (standby) Or *Landwin: 2580S1003 PIN 5 5 VSB return PINS: 2583T011R PIN 6 +12 V SK8 JST PHR-2 PIN 7 Common Pins: SPH-002T-PO.5S PIN 8 Inhibit CN403 JST PHDR-10VS PIN 9 DC power good (DC OK) Pins: JST 5PHD-002T-PO.5-L/P PIN10 Power Fail (POK) Or *Landwin 2050 S1000 SK8 PIN 1 +12 V Fan Pins: 2053T011P PIN 2 Common * Where available Artesyn Connector Kit #70-841-024 includes all of the above (Molex for SK7) CN403 PIN 1 5 V_I2C 1 5 Notes: PIN 2 Ground 1. Specifications subject to change without notice. 6 10 PIN 3 A2 2. All dimensions in inches (mm), tolerance is ± 0.2”. PIN 4 A0 3. Specifications are at factory settings PIN 5 SVCC2_OR 4. Mounting maximum insertion depth is 0.12”. PIN 6 I2C_SDA 5. Warranty: 2 year PIN 7 I2C_SLC 6. Weight: NTS50X - 1.66 lbs/0.75 kg PIN 8 A1 NTS50X-CF - 2.00 lbs/0.9 kg NTS50X-CEF - 2.26 lbs/1.03 kg PIN 9 N/C PIN 10 +12 V_RTN_CTRL NTS500 Series Data Sheet Mechanical Drawing +V OR-ing out +V out Common L 5 10 AC Input N (CN1) PE 1 6 Signal Output (SK7) 1 5 1 2 Fan Header -CF option V out adj SK8 12C Header (CN403) 6 10 1.24[31.5] 0.75[19.1] (3X) a b 1.15[29.1] 1.5[38.1] 0.3[6.4] 5.85[148.7] 6.25[158.7] a b b a 4[101.6] 2.5 [63.5] (4X) b a a b 4.7 [119.6] (2X) #6-32 (8 places) 5.5 [139.7] (2X) M3 (8 places) 7 [177.8] NTS500 Series Data Sheet Mechanical Drawing - CEF option AIR FLOW DIRECTION 9.15" (232.3) 2.40" 5.85" (61) (148.6) 6.244" (158.6) 4.7" (119.6) 2.9" 5.5" (73.6) (139.7) #6-32 (8 places) M3 (8 places) WORLDWIDE OFFICES Americas Europe (UK) Asia (HK) 14/F, Lu Plaza 2900 S.Diablo Way Waterfront Business Park Tempe, AZ 85282 Merry Hill, Dudley 2 Wing Yip Street Kwun Tong, Kowloon USA West Midlands, DY5 1LX +1 888 412 7832 United Kingdom Hong Kong www.artesyn.com +44 (0) 1384 842 211 +852 2176 3333 Artesyn Embedded Technologies, Artesyn and the Artesyn Embedded Technologies logo are trademarks and service For more information: www.artesyn.com/power marks of Artesyn Embedded Technologies, Inc. All other names and logos referred to are trade names, trademarks, For support: productsupport.ep@artesyn.com or registered trademarks of their respective owners. © 2016 Artesyn Embedded Technologies, Inc. All rights reserved. For full legal terms and conditions, please visit www.artesyn.com/legal. NTS500 DS 21Mar2016 a a b b a b b a b a a b a b b a 1.61" (40.9) 4.0" 1.255" (31.9) (101.6) 0.862" (21.9) 0.862" (21.9) 0.752" 6.437" (63.5) (19.1)